| Content |
The MT 4 four-channel distribution transformer is packaged in a space saving 1U, 19-inch rack-mount tray. The fully isolated, high performance toroid transformers provide flat frequency response within 1 dB from 40 Hz to 20 kHz. Each transformer is designed for 8 ohm 100 watt input, and 100 watt 70 volt or 100 watt 100 volt output. The recommended load for the 70 volt tap is 50 ohms. The recommended load for the 100 volt tap is 100 ohms. Convenient Euroblock connectors are provided on the rear of the chassis.
The MT 4 comes ready to use with four mounted transformers and strain-relief Euro connectors. The tray with Euro connectors (model KT 4) and individual transformers with mounting hardware (model TF 4) are available separately, allowing the installer to build a tray with just the number of channels required.
While the MT 4 was designed for use with the Rane MA 4 amplifier, it is ideal for the MA 6S amplifier, or any application where high performance 100 watt, 100 / 70 volt, isolated distribution transformers are required.
Features:
- Four channels, 100 watts, 100 / 70 volt
- Input 8 Ohm, 100 watts
- Euroblock strain-relief connectors
- 1U, 19 inch rackmount tray
- Frequency response 40 Hz to 20 kHz +0, -1 dB
- Separate mounting tray and individual transformers available
|
| | - CONVENIENT INSTALLATION AND CONSTRUCTION WITHOUT NEED OF ID SETTING. - SELECTION OF VARIOUS CHIME BROADCASTINGS FOR MIC BROADCASTING (PRE/POST). - CONVENIENT PRIORITY BROADCASTING. - ADOPTION OF OUTPUT SIGNAL LEVEL DISPLAY. - ADOPTION OF RS-422 COMMUNICATION METHOD TO SUPPORT A LONG DISTANCE. | | | | | | | | Audio Output | 0dB(Balanced) | | Audio Input | Paging & RM MIC & LM MIC | -50dB(Balanced) | | BGM(Main & Local) | -10dB(Balanced) | | Tone Control (100Hz & 10kHz) | Paging MIC | ± 10dB | | Audio Output | ± 12dB | | Frequency Response | BGM | ± 3dB | | MIC | ± 3dB | | S / N | BGM | Better than 75dB | | MIC | Batter than 65dB | | T.H.D. | BGM | Less than 0.05% | | MIC | Less than 0.05% | | Priority Control | Paging MIC > DRP > RM1> RM2 > RM3 > RM4 > LM-8000 > Main BGM | | Phantom Power | DC 24V | | Serial Interface | Communication Speed | 9600bps | | Communication Distance | Maximum 300m(UTP CAT%) | | Operation Temperature | -10℃ ~ +40℃ | | Power Source | 100-120VAC or 220-240VAC; 50/60Hz (Supplied AC mains transformer depends on country requirements) | | Weight(SET) | 1.5kg / 3.2lb | | Dimensions(SET) | 200(W) x 70(H) x 206(D)mm 7.9(W) x 2.8(H) x 8.1(D)in | | ※ Specifications and design subject to change without notice. | | | |
|
*Convenient Priority Broadcasting
*Convenient Installation and Construction without ID Setting
*RS-422 Communication between RM-500 and Z-500
*21 Zone Paging Selection
*Output Signal Level Display
*Multi Chime Options
*Weight: 1.6kg/3.5Ib
*DImensions(W×H×D): 200×206×70mm/7.9×8.1×2.8in
|
toa-at-100upr Build-in Attenuator with Relay
Toa - 100V installation
Build-in Attenuator with Relay 100 W / 100 V
|
Five attenuation settings (OFF, 0/-6/-12/ -16dB), over an input range from 0.5W to 30W. |
| | - SYSTEM POWER CONTROL You can control the power of your system by using this model. - AC AND DC POWER SUPPLY You can distribute AC and DC power through the AC outlet and DC terminals on the rear panel. - USE OF EMERGENCY POWER SUPPLY For emergency equipment power supply, an extra DC terminal is provided. - REMOTE CONTROL You can control the system power by remote control function even though the power switch on front is off. - AC AND DC VOLT METER This model uses digital volt meter displays of AC and DC. - OPERATING MODE DISPLAY You can easily check the operating mode by LEDs, AC or DC operating and emergency power. | | | | | | PD-659 | | AC Outlet | Switched 2000W ⅹ3 | | Unswitched 700W ⅹ1 | | Remote Control | 1 | | DC Power Output | DC 24V 5A | | Operation Temperature | -10℃~+40℃ | | Power Source | 100-120VAC or 220-240VAC; 50/60Hz (Supplied ACmains transformer depends on country requirements) | | Power Consumption | 190W | | Weight(SET) | 6.2Kg/13.6Ib | | Dimension(SET) | 482(W) x 88(H) x 380(D)mm/19(W) x 3.5(H) x 15(D)in | | ※ Specifications and design subject to change without notice. | | | |
|
Reviews
There are no reviews yet.