Content |
EVP-X15PM: powered version for EVP-X12P: 300W(RWS)/500W(PEAK)
2 Channel mixer; high/low EQ control; Balanced line output
SYSTEM TYPE: 15” 2-way monitor - FREQ RESP +/ - 3 DB: 50Hz - 20kHz
- FINISH MATERIAL: Black carpet - TRIPOD STAND BOTTOM: No -
TRIPOD STAND TOP: No - INPUTS: INPUT A: Line level input / INPUT
B: NA - SPEAKER LEVEL INPUT: NA - INPUT CONNECTORS: INPUT
A: Combined Jack and XLR / INPUT B: NA - INPUT SENSITIVITY: MIC:
5mV / RCA: 0.5V / LINE: 0.775V - INPUT IMPEDANCE: MIC: 470
OHMS / LINE INPUT A: 47K / LINE OUTPUT TYPE: Balanced Male XLR
connector - LINE OUTPUT HIGH PASS FILTER: MAIN EQ: 5 band
graphic EQ - ACTIVE CROSSOVER: NA - PHASE SWITCH: NA -
POWER SECTION-AMPLIFIER POWER, CONTINUOUS: 400W -
PEAK: 600W - EXTENSION SPEAKER OUTPUT: 1 - PROTECTION
TYPE: Dynamic/AGC - POWER ON INDICATOR: Green LED - SYSTEM
DYNAMIC AGC: Orange LED - ENCLOSURE - DIMENSION MM
(HXWXD): 645X445X473.5 - WEIGHT (NET) KG: 27.4 - WEIGHT
(GROSS) KG: 30.5
|
- 1000w RMS, 2000w peak, power delivers clarity, punch and more than enough headroom for any
- performance or practice space
- Specially-voiced 12-inch woofer and high frequency compression driver deliver your drum sounds
- with precise, full response across the entire frequency range without any artificial colouration
- (2) XLR/TRS 1/4-inch combo inputs with independent volume controls and clip indicator
- XLR output to link another Strike Amp 12 or send your performance to another input device
- Lightweight and flexible tilt-back cabinet design that can also be pole-mounted
- Contour EQ switch to control your sound
- Ground-Lift switch eliminates unwanted noise
Specifications:
- Output: Power 2000W (peak, 1300LF + 700HF), 1000W (continuous RMS, 650LF + 350HF)
- Low-Frequency: 12.0” (305mm) low-frequency driver, 3.0” (76mm) high-temperature voice coil
- High-Frequency: 1.4” (35mm) voice coil, neodymium-magnet high-frequency driver with precision waveguide
- Crossover Frequency: 2.0KHz
- Maximum SPL: 131dB (peak), 128dB (continuous) (dB-SPL @ 1m)
- Frequency Response: 53Hz – 20kHz (+3dB)
- Frequency Range: 46Hz – 22kHz (-10dB)
- Horn Coverage 90o horizontal x 60o vertical (nominal)
- Equalisation: Contour switch with low- and high-frequency +3dB boost
Connectors: - (2) XLR/TRS 1/4” (6.35mm) combo inputs - (1) XLR link output - (1) IEC power cable input
- Controls Power switch, (2) volume control knobs (1 per input), EQ contour switch, ground-lift switch
- Indicators: (2) power LEDs (1 front-panel, 1 rear-panel), clip limiter LED
- Protection: Electronic clip, thermal & transducer overdrive
- Input Voltage: 100V~, 110–120V~, 220–240V~; 50/60Hz (switchable)
- Fuse: 100–120V T10AL AC250V 220–240V T5AL AC250V
- Consumption: 800W
- Enclosure: Trapezoidal, injection-molded polypropylene enclosure with perforated steel grille
Dimensions: (width x depth x height) 605 x 354 x 350mm Weight: 16.3kg |
The NX 10-SMA is equipped with new high power 400 W digital amplifier and a newly designed 10 " coaxial neodymium transducer that guarantees outstanding audio quality and definition as well as an extremely lightweight of the final system. The NX 10-SMA can be also used as a portable PA system, thanks to the rugged powder coated steel pole mount installed on the side. In order to control the response of the speaker in such different applications, RCF has incorporated two special Equalization Modes: - Floor, for stage monitoring; - Free Field, for the use of the speakers as a stand-alone PA system. Cabinet is made in Baltic Birch plywood, finished with an extremely resistant paint for an extensive use on the road. An ergonomic side handle, integrated with the input panel, is provided for an easier transport of the speaker.
APPLICATIONS
- • Main vocal stage monitor
- • Drum or keyboard monitor
- • Main PA in small venues
General Specs
- 800 Watt Peak, 400 Watt RMS digital bi-amplification
- 127 dB max spl
- 60° x 60° constant directivity horn
- 10" High power neodymium woofer, 2.5" voice coil
- 7 kapton dome, 1" exit, neodymium high frequency driver
- DSP processing, floor - fre field equalization, soft limiter and protection
- Combo xlr/jack input, xlr signal output
Acoustical Specs
- Frequency Response -3 dB:60Hz ÷ 20000 Hz
- Max SPL:127dB
- Horizontal coverage angle:60°
- Vertical coverage angle:60°
- Compression Driver:7 kapton dome, 1" exit, neodymium
- Woofer:10" neo high power woofer, 2.5" voice coil
Processor Section
- Limiter:Soft Limiter
- Controls:Freefield, floor
Amplifier Specifications
- Total power:800W PEAK
- High frequencies:200 W PEAK
- Low frequencies:600 W PEAK
- Total power:400W RMS
- High frequencies:100 W RMS
- Low frequencies:300 W RMS
Cabinet Specs
- Cabinet Material:Baltic Birch
- Handles:1 on side
- Pole Mount/Cap:yes
- Grille:steel
Size/Weight
- Height:324/12.7mm/inch
- Width:450/17.7mm/inch
- Depth:417/16.4mm/inch
- Net Weight:14,5/31.96kg/lbs
|
The LDMON101A features a high end 10" co-axial speaker with a 1" compression driver and delivers 150 W RMS output power.
The Volex power supply system allows a secure connection of further active monitors, this feature enables the installation of a big active stage monitor system while using only one power plug. The monitor also features a softclip-limiter as well as a volume control.
The Housing was built out of a high quality plywood with a high resistance textured finish. The stabile front guard ideally protects the speakerbox.
Specifications LDMON101A: - Model Name: LDMON101A
- Type: Bass Reflex
- Components:
- Woofer / Compression Driver: 10" / 1" Coaxial Custom Made Speaker
- Amplification: Class A / B
- Dispersion: 75° x 75°
- Power: 150 W RMS
- Frequency Range: 90 Hz- 20 Khz
- SPL (1 W / 1 m): 99 dB
- Max. SPL: 121 dB
- Protection: Limiter, Circuit and Overcurrent
- Controls: Volume, On/Off Switch
- Indicators: Signal, Power, Limit
- Connectors:
- Input: Line: XLR /6,3 mm jack (combo)
- Output: Line: XLR
- Power Supply: Transformer
- Cabinet Material: 15 mm Plywood
- Cabinet Surface: Painting
- Dimensions: 360 x 370 x 425 mm
- Features: Ergonomic milled handles, VOLEX power plug input / output
|
The NX 12-SMA is equipped with new high power 700 W digital amplifier and a newly designed 12” coaxial neodymium transducer that guarantees outstanding audio quality and definition as well as an extremely lightweight of the final system. The NX 12-SMA can be also used as a portable PA system, thanks to the rugged powder coated steel pole mount installed on the side. In order to control the response of the speaker in such different applications, RCF has incorporated two special Equalization Modes: - Floor, for stage monitoring; - Free Field, for the use of the speakers as a stand-alone PA system. Cabinet is made in Baltic Birch plywood, finished with an extremely resistant paint for an extensive use on the road. An ergonomic side handle, integrated with the input panel, is provided for an easier transport of the speaker
APPLICATIONS
- • Main vocal stage monitor
- • High-output drum or keyboard monitor
- • Main PA in small venues
General Specs
- 1400 Watt Peak, 700 Watt RMS digital bi-amplification
- 129 dB max spl
- 60° x 60° constant directivity horn
- 12" High power neodymium woofer, 2.5" voice coil
- 1.7 kapton dome, 1" exit, neodymium high frequency driver
- DSP processing, floor - fre field equalization, soft limiter and protection
- Combo xlr/jack input, xlr signal output
Acoustical Specs
- Frequency Response -3 dB:50Hz ÷ 20000 Hz
- Max SPL:129dB
- Horizontal coverage angle:60°
- Vertical coverage angle:60°
- Compression Driver:1.7 kapton dome, 1" exit, neodymium
- Woofer:12" neo high power woofer, 2.5" voice coil
Processor Section
- Limiter:Soft Limiter
- Controls:Freefield, floor
Amplifier Specifications
- Total power:1400W PEAK
- High frequencies:400 W PEAK
- Low frequencies:1000 W PEAK
- Total power:700W RMS
- High frequencies:200 W RMS
- Low frequencies:500 W RMS
Cabinet Specs
- Cabinet Material:Baltic Birch
- Handles:1 on side
- Pole Mount/Cap:yes
- Grille:steel
Size/Weight
- Height:324/12.7mm/inch
- Width:550/21.6mm/inch
- Depth:417/16.4mm/inch
- Net Weight:16,5/36.3kg/lbs
|
12” active coaxial monitor
350W class D+ 65W class AB
FR: 60Hz-20kHz
Max SPL: 121dB
Input level: LINE -6dBu
12” coaxial woofer with 1” driver
Protection: Thermal/Convection fan/Overload/limiter/compression
The INVoTONE DSX series is a brand new cabinet line in the premium segment. The speakers are characterized by their accurate and balanced sound. Even very high sound pressure levels are reached. The speakers are comparable in every respect with high-priced branded products, just not in the price! In addition to the acoustic and technical qualities, this series is also mechanically equipped with all the professional features that are common in this segment. "- Monitor and Coaxial 12" subwoofers up to 2x15 "2-way floorstanding speaker and a 18" subwoofer Currently, our product range includes compact 12 arrived.
Power
| 350Watt RMS Biamp | Frequency range (-10dB) | 60Hz-20kHz | Maximum SPL @ 1m | 121dB | Radiation (HxV) | 70 ° x 70 ° | Components | 12 "woofer, 1" HT-driver coaxial system | Connectors | INPUT jack combo / OUTPUT XLR male balanced link. | Input Level | Line -6dBu | Control switches | Volume Control, Ground Lift, monitor / FOH preset switchable ON / OFF | Protection circuits | temperature controlled fan, limiter, compressor | Housing | MDF with durable black textured lacquer, metal front grille, rubber feet, wooden handles, Hochständeflansch | Dimensions | (HxWxD) 313mm x 393mm x 513mm | Weight | 14KG |
|
Reviews
There are no reviews yet.