| Content | The Swiss Army Knife of microphones
for vocal and instrumental recording, on stage, in ENG/EFP and video production
The C1000 S from AKG is a small-diaphragm condenser microphone with a cardioid pattern designed for recording, live-sound, ENG and video-production applications with vocals and instruments. Using the included polar-pattern converter accessory, the microphone can be switched from cardioid to hypercardioid to reduce feedback when used on stage. The presence-boost adapter offers three discrete frequency settings to add clarity to speech and instrument sounds.
A switchable low-cut filter at 80 Hz helps reduce rumble or wind noise, and a switchable 10 dB pad enables distortion-free recording of very loud sound sources associated with proximity miking. If no phantom power is available, the C1000 S can be powered by two standard AA batteries for up to 120 hours.
Featuring a pre-polarized design encased in a sturdy metal chassis, a gold-sputtered microphone capsule housing and gold-plated XLR pins, this microphone is well suited for mobile applications such as broadcast and interviews, even in high-humidity environments.
The C1000 S comes with a stand adapter, a foam windscreen and a microphone bag.
- Presence-boost adapter offers three discrete frequency settings to add clarity to speech and instrument sounds
- Polar-pattern converter allows microphone pattern to be switched from cardioid to hypercardioid
- Pre-polarized design, gold-sputtered microphone-capsule housing and gold-plated XLR pins make this microphone well suited for portable applications and high-humidity environments
- Switchable low-cut filter at 80 Hz to reduce rumble or wind noises which may cause distortion at low frequencies.
- Switchable 10 dB pad to enable distortion-free recording of very loud sound sources in proximity miking
- If no phantom power is available, the C1000 S can be powered by two standard AA batteries for up to 120 hours
- Sturdy metal chassis and specialized mic clip to keep microphone securely attached to stands
| General |
| Audio Frequency bandwidth |
50 to 20000 Hz |
| Sensitivity |
6 mV/Pa |
| Equivalent Noise Level |
21 dB-A |
| Signal to Noise |
73 dB-A |
| Preattunation Pad |
10 dB |
| Bass Cut Filter |
80 Hz |
| Electrical Impedance |
200 Ohms |
| Recommended Load Impedance |
2000 Ohms |
|
| Polar Patterns |
| Polar Pattern |
hypercardioid; cardioid |
| Number |
2 |
|
| Powering Interface |
| Voltage |
9 to 52 V |
| Current |
3 mA |
|
| Audio Output |
| Type |
Balanced XLR |
| Gender |
Male |
| Contacts |
3-pin |
|
| Design |
| Body |
metal |
| Finish |
matte grayish blue |
|
| Dimensions / Weight |
| Length |
229 mm |
| Height |
34 mm |
| Diameter |
34 mm |
| Net Weight |
320 g |
|
| The NT5 matched pairs are a masterpiece of small-diaphragm cardioid-
condenser microphone design.Intended for recording acoustic instruments,
drum overheads, cymbals and live performances, the compact externally
polarized mic employs a .5? capsule, an active J-FET impedance converter
with bipolar output buffer.
Finished in durable satin nickel, the NT5 is intended for either single or stereo
X/Y mic set-ups. The NT5 matched pairs comesupplied in a custom carry case
with windshields and mounts.
SPECIFICATIONS:
Acoustic principle: Externally polarised single diaphragm
Directional pattern: Cardioid
Frequency range: 20Hz - 20kHz
Output impedance: 100?
Signal noise ratio din iec 651: 78dB
Equvalent noise: Maximum spl: 143 dB @ 1% THD into 1k_
Sensitivity:
-38 dB re 1v/Pa ± 2 dB equivalent to 12mV/Pa where 1 Pa = 94dBSPL
Power supply voltage: P48 Supply (38V?52V), P24 Supply (20V-26V)
Current consumption: 4 mA, 2 mA,
Weight: 100g | The e 945 is a fully professional super-cardioid vocal microphone which cuts
through the mix and offers a smooth, natural sound. Its warm tonal response
is matched with rugged construction and excellent feedback rejection.
Features
Rugged metal body
Advanced shock-mount design
Consistent on-/off-axis response
Hum compensating coil
Made in Germany
Delivery includes a pouch and a microphone clamp
Delivery Includes
1 e 945
MZQ 800 microphone clamp
Pouch
Technical Data
Pick-up pattern Super-cardioid
Frequency response (microphone) 40.....18000Hz
Sensitivity in free field, no load (1kHz)
2,0mV/Pa bei 1 kHz = -54dB (0 dB = 1V/Pa) = -74 dB (0 dB = 1V/ubar)
Nominal impedance 350 Ohm
Min. terminating impedance 1000 Ohm
Dimensions 47 x 186 mm
Weight 330 g |
Transformerless Power/Output Module ? The SE 300 B is used with all AKG Blue Line capsules and operates from 9 ? 52 V phantom power. The 3-position switch allows selection of linear response, -10 dB preattenuation and 12-dB-per-octave 75 Hz low-cut filter. A stand adapter is included.
Specifications
Polar pattern: hypercardioid/directional
Frequency range: 20?20,000 Hz
Sensitivity: 25 mV/Pa (-32 dBV)
Max. SPL for 1 % THD: 124/134 dB
Equivalent noise level: 17 dB-A
Signal/noise ratio (A weighted): 77 dB
Preattenuation pad: -10 dB, switchable Bass cut filter: 12 dB/octave at 75 Hz
Electrical impedance: 200 Ohms
Recommended load impedance: >1,000 Ohms
Power requirement: 9 to 52 V phantom power to DIN 45 596
Current consumption: |
The ME 65 is a super-cardioid microphone head designed for use with the K6 and K6P powering modules. It is especially suited to vocal and speech applications. Matt black, anodised, scratch-resistant finish.
- Pick-up pattern : super-cardioid
- Sensitivity in free field, no load (1kHz) : 10 mV/Pa +- 2,5 dB
- Nominal impedance : 200 Ohm (K6)
- Min. terminating impedance : 1000 Ohm (K6)
- Equivalent noise level : 20 dB
- Dimensions : d 44 x 131 mm
-
Weight :
|
8 Wide frequency response range
High sensitivity, Low distortion
High input withstand S.P.L.
Rugged brass case, Light weight
Shock mount adapters, stereo mounting bracket and wind screens as standard
PREMLIMINARY INFORMATION.
The MC10ST is a stereo microphone set including a pair of cardioid electret condenser microphones,
shock mount adapters, stereo mounting bracket and wind screens. The MC10ST can be used in a
wide range of applications, from studio and home recording to field or location sound aquisition.
Wide frequency response range
High sensitivity
Low distortion
High input withstand S.P.L.
Rugged brass case
Light weight
Shock mount adapters, stereo mounting bracket and wind screens as standard
Dedicated carry case as standard
SPECIFICATIONS:
Type: Back Electret Condenser Microphone
Polar Pattern: Cardioid
Frequency Response: 40Hz to 20kHz +/-10dB
Sensitivity: -40dBV/pa (10mv/pa)
Rated Impedance: 200ohm
Equivalent Noise Level: 22dB (A weighted IEC/DIN 651)
Maximum SPL: 134dB (THD |
Reviews
There are no reviews yet.