Content |
- Aftermarket diaphragm D8R2406 replacement for the JBL 2406H-1 Driver or BMS 4538 and more models.
- Fits JBL MPRO 400 Series
- 8 Ohm
Polymer diaphragm replacement kit: 8ohm, 37.8mm (voice coil inner diameter)* 70.0mm (al ring outer diameter),aluminum round wire v/c
This aftermarket diaphragm is a direct replacement for the JBL 2406, 2406H, 2406-1, 2406H-1 driver / tweeter / horn.
Specifications
- Annular Ring Diaphragm
- 8 ohm
- Peak power 300 watts
- Frequency range 1200Hz - 30kHz
- Overall diaphragm diameter 2.75-in or 70-mm
- Voice coil diameter 1.5-in or 38-mm
- Diaphragm material is polyester
- Voice coil former is Kapton
- Voice coil wire is edge wound / flat wound, aluminum
Very easy to replace. This diaphragm self aligns. Simply remove the old diaphragm,
clean the voice coil gap with a piece of masking tape, then install the new diaphragm in
reverse order.
This diaphragm uses the polyester annular ring diaphragm and surround just like the
original JBL diaphragm.
This diaphragm will handle the same amount of power, and sounds the same as the
original JBL 2406 diaphragm, guaranteed! | Original JBL D8R2431 Diaphragm to repair the 2431H Driver (339894-002X). 8 ohm
Diaphragm Comes with Ferrofluid and Allen Key.
Here is the list of some cabinet model use:
AE Series: AM6200/64-WH, AM6200/95-WH, AM6212/00-WH, AM6212/64-WH, AM6212/95-WH, AM6215/64-WH, AM6215/95-WH, AM6315/64-WH, AM6315/95-WH, AM6340/64-WH, AM6340/95-WH
Precision Directivity Series: PD5200/43-WH, PD5200/64-WH, PD5200/95-WH, PD5212/43-WH, PD5212/64-WH, PD5212/95-WH, PD5322/43-WH, PD5322/64-WH, PD5322-95-WH, PD743, PD764
SRX Series: SRX712M, SRX715/F, SRX738/F VLA Series: VLA301, VLA301H, VLA601, VLA601H, VLA901, VLA901H
Vertec Series: VT4888, VT4888DP-AN/CN/DA |
This genuine JBL replacement diaphragm is compatible with the 2450J, 2446J, and 2447J horn drivers. JBL part number D16R2450.
|
- JBL D8R2406 is a genuine JBL replacement diaphragm for the 2406H-1 Driver.
- Fits JBL MPRO 400 Series
- 8 Ohm
| Replacement diaphragm kit for RX™22 driver
Impulse 1012 8 Ohm, Impulse 1012 4 Ohm, Impulse 1012P,Impulse 1015 8 Ohm, Impulse 1015 4 Ohm, DJS4, DJS 5, SP2X, SP3X,SP4X, SP5X, SP5XL, SP6X, SP112MX, SP115MX Impulse 1015P, QW 3, QW 3F, TLS 6X, SP2, SP3, SP4, SP5, SP6, SP12M, SP15M, SP 8
- Peavey Factory Speaker RX22, 22XT, 22XT+ Original Diaphragm Part # 00452400
- NEW! Now used for ALL 22 series drivers: RX22, 22A, 22XT, 22XT+
- Voice coil: 2" (50mm)
- Diameter: 4-1/2" (115mm)
- Impedance: 8 ohm
- Titanium dome with edge wound copper clad aluminum voice coil on high temp composite bobbin
- Installation instructions, Ferro Fluid, and new mounting bolts included on new diaphragms starting mid 2015Please check your model before ordering to make sure you are getting the correct diaphragm.
| |
Reviews
There are no reviews yet.