AUDIO TECHNICA ATN3472SE Turntable stylus

Replacement stylus for Audio-Technica AT92ECD, AT301EP, AT311EP & AT316EP cartridges.

Stylus Shape: Elliptical
Stylus Dimension: 0.3 x 0.7 mil

To remove old stylus (needle), hold the cartridge in one hand, grasp the plastic stylus housing with thumb and forefinger, and pull away from the cartridge.

To install replacement stylus, insert the new stylus assembly into the cartridge. The stylus assembly should click into place when fully seated on the cartridge. The stylus must be fully seated on the body for proper operation

DJ E Replacement stylus

Basic model for scratch and back-cueing. Outstanding rigidity by extra-strengthened cantilever

Features Special Elliptical stylus and a special developed and extremely balanced cantilever.

Not only does the cartridge have a most sufficient tracking ability, it is also nearly unbreakable and provides the DJs with the most needed stringency. Furthermore, it equals very low record wear, an advantage for busy DJ.  

The DJ series has been known to many as the "jack of all trades," with improved tracking, alongside of accurate sound reproduction. Featuring a low wear stylus design, the DJ provides excellent groove handling, even with less weight applied. 

Output voltage at 1000Hz, 5cm/sec. -   6 mV
Channel balance at 1kHz  -  2 dB
Channel separation at 1kHz  -  23 dB
Channel separation at 15 kHz  -  15 dB
Frequency range at -3dB  -  20-22.000 Hz
Frequency response -   20-20.000 Hz +/-2 dB
Tracking ability at 315 Hz at recommmende tracking force  -  80 μm
Compliance, dynamic lateral  -  9 μm/m N
Stylus type  -  Special Elliptical
Stylus tip radius  -  r/R 13/25 μm

Tracking force range  -  2,0-4,0 g (20-40 mN)
Tracking force recommended  -  3,0 g (30 mN)
Tracking angle -   20°
Internal impedance, DC resistance  -  750 Ohm
Internal inductance  -  450 mH
Recommended load resistance   - 47 kOhm
Recommended load capacitance -  200-600 pF
Cartridge weight  -  18,5 g

Compatible with cartridges -  DJ S

Stylus 3E

*) Typical value