| Content | Featuring Audio-Technica's UniLine® line-cardioid element, the U853RU UniLine condenser hanging microphone is equipped with UniGuard® innovations that offer unsurpassed immunity from radio frequency interference. The phantom-powered microphone accepts interchangeable elements, available in cardioid, hypercardioid, omnidirectional and UniLine® line cardioid polar patterns. Its 80 Hz low-cut UniSteep® filter reduces pickup of low-frequency ambient noise.
- Designed for suspension over choirs, instrumental groups and theater stages
- UniLine polar pattern provides narrow 90° acceptance angle
- Superior off-axis rejection for maximum gain before feedback
- UniGuard® RFI-shielding technology offers outstanding rejection of radio frequency interference (RFI)
- UniSteep® filter provides a steep low-frequency attenuation to improve sound pickup without affecting voice quality
- Accepts interchangeable elements to permit angle of acceptance from 90° to 360°
- Low-profile design with low-reflectance finish for minimum visibility
- Available in two colors: black (U853RU) and white (U853RWU)
- Element: Fixed-charge back plate, permanently polarized condenser
- Polar Pattern: Line Cardioid
- Frequency Response: 30-20,000 Hz
- Low Frequency Roll Off: 80 Hz, 18 dB/octave
- Open Circuit Sensitivity: 35 dB (17.7 mV) re 1V at 1 Pa
- Impedance: 250 ohms
- Maximum Input Sound Level: 135 dB SPL, 1 kHz at 1% T.H.D.
- Dynamic Range: 115 dB, 1 kHz at Max SPL
- Signal to Noise Ratio: 74 dB, 1 kHz at 1 Pa
- Phantom Power Requiremens: 11-52V DC, 2 mA typical
- Switch: Flat, roll-off
- Cable: 25.0' (7.6 m) long (permanently attached to microphone), 0.13" (3.2 mm) diameter, 2-conductor, shielded cable with TA3F-type connector
- Accessories: AT8154 two-stage foam windscreen; AT8451 steel hanger; AT8538 power module; AT8438 5/8“-27 stand adapter
|
Shure MX412SE/C 12-inch (30 cm) Gooseneck Condenser Microphone, Shock Mount, Flange Mount, 10-foot (3 m) Side-Exit Cable (or Bottom-Exit), Snap-Fit Foam Windscreen, In-Line Preamp, Cardioid.
Shure Microflex MX412SE/C microphones are miniature gooseneck-mounted electret condenser microphones designed for speech and vocal pickup. Their high sensitivity and broad frequency range make them suitable for recording, as well as sound reinforcement applications.
The MX412SE/C microphone can be screwed onto a mic stand or the supplied 5/8 inch 27-threaded flange. They can be easily changed from side-exit to bottom-exit to conceal the cable. All models include an in-line preamplifier and a 3 m (10 ft) cable. Each microphone is available with interchangeable cardioid, supercardioid, or omnidirectional cartridges. |
The 98H/C is wireless version of Shure\'s Beta 98 clip-on instrument mic, and is designed to work with the Shure beltpack transmitters. With the ability to handle high SPL, the Beta 98H/C is ready for the demands of brass, woodwind, and percussion, and features a flexible integrated gooseneck with clip-on clamp for secure fit and precise positioning. No external mounting hardware required.
Tech Specs
- Compatibility: All Shure w/TA4F (Tiny QG)
- Microphone Type: Condenser
- Polar Pattern: Cardioid
- Frequency Response: 20Hz-20kHz
- Max SPL: 143.5dB SPL
- Signal to Noise Ratio: 63dB
- Self Noise: 31dB (A weighted)
- Connector: TA4F (For Shure)
- Color: Black
- Cable Length: 10 ft.
- Weight: .1 lb.
- Manufacturer Part Number: WB98H/C
|
- Hypercardioid polar pattern
- 38 cm long
- 95° pickup angle
- For acoustically difficult environments
- Connects easily via XLR connector
The hypercardioid polar pattern with its narrow 95° pickup angle is suited best for situations where noise typically occurs from all sides (particularly in worship centers), where people talk into the microphone from a greater distance, or where several talkers are grouped side by side. Two different lengths are available. The .exible joint ensures optimum alignment of the gooseneck to any talker position. Several options are available for installation, i.e., stand, tabletop installation, and lockable.
Choosing polar patterns
Selecting the correct polar pattern for installed sound is difficult since it depends on a variety of factors. Of course the acoustics of the room play a key role. For highly reverberant rooms such as worship centers, a hypercardioid polar pattern will be the best choice to avoid high levels of unwanted noise. Correct placement of the loudspeakers is also essential. If the speakers project right at the capsule, a hypercardioid will be your best bet. The most difficult task, however, is trying to judge how the talkers will behave. For talkers who are inexperienced or move around a lot, be sure to choose a cardioid polar pattern for reliable pickup; talkers at a greater distance from the mic will be served best by a hypercardioid.
The microphone shall be a hypercardioid gooseneck microphone. Its pickup angle shall be 95 degrees; frequency range 50 Hz to 19 kHz; sensitivity 12 mV/Pa; max. SPL 125 dB; electrical impedance
| Polar pattern |
Hypercardioid |
| Frequency range |
50 to 19,000 Hz |
| Sensitivity |
12 mV/PA = -38 dBV re 1 V/Pa |
| Max. SPL |
125 dB (for 1% THD) |
| Equivalent noise level |
|
| Signal/noise ratio (A-weighted) |
>73 dB |
| Impedance |
=2,000 ohms |
| Supply voltage |
English: 9 to 52 V phantom power to IEC 61938 (DPA adapter integrated) |
| Powering |
|
| Connector |
3-pin male XLR |
| Finish |
matte black |
| Dimensions |
CGN 99 H/S: 13.5 x 380 mm (0.5 x 15 in.);
CGN 99 H/L: 13.5 x 580 mm (0.5 x 23 in.) |
| Net weight |
CGN 99 H/S: 480 g (17 oz.);
CGN 99 H/L: 500 g (17.7 oz.) |
|
- Cardioid polar pattern
- 10 m (33 ft.) cable
- 125° pickup angle
- Especially suited for choir recordings
- Integrated spring steel clamp for optimum alignment
The new CHM 99 Condenser Hanging Microphone provides both ease of use and a high level of functionality. There is hardly any more affordable and simpler solution for recording choirs at worship centers. Suspended from the ceiling or a beam, the hanging microphone is aligned and then fixed in the correct position. Now use the spring steel clamp to adjust the correct angle, and off you go!
The CHM 99 is available in white or black.
XY stereo recording
Using two CHM 99 hanging microphones in an XY configuration (coincident pair) is a good way to make stereo recordings, particularly of choirs. However, sound source locations are defined only by intensity differences. Adjusting the angle between the microphones determines the width and depth of the stereo image.
ORTF stereo recording
Developed by the French Broadcasting Authority, this technique differs from the XY technique by recording not only intensity differences, but also delay differences. The capsules are aligned at an angle of precisely 110° and 170 mm / 6.7 in. apart.
Polar pattern Cardioid
Frequency range 70 to 18,000 Hz
Sensitivity 18 mV/PA = -35 dBV re 1 V/Pa
Max. SPL 125 dB (for 1% THD)
Equivalent noise level 73 dB
Impedance =2,000 ohms
Supply voltage 9 to 52 V phantom power to IEC 61938 (DPA adapter integrated)
Powering |
2-inch (30 cm) Gooseneck Condenser Microphone, Cardioid, Attached XLR Preamp, Shock Mount, Flange Mount, Snap-Fit Foam Windscreen, Mute Switch, LED Indicator.
The Microflex Gooseneck microphones bring a whole new meaning to the word flexible. Beyond their fully adjustable goosenecks lies a new level of flexibility the new Microflex interchangeable condenser microphone cartridge. Designed for easy replacement and available in cardioid, supercardioid and omnidirectional polar patterns, the interchangeable cartridges offer wide frequency response and accurate sound reproduction for a broad variety of applications, such as houses of worship, courtrooms and conference centers. Plus, the condenser cartridges fit every model in the new Microflex product line for enhanced convenience and consistent sound.
Features
- Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
- Interchangeable cartridges provide the right polar pattern for every application
- Balanced, transformerless output for increased immunity to noise over long cable runs
- Shock mount that provides over 20 dB isolation from surface vibration noise
- Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables
- Snap-fit foam windscreen
Specifications
- Frequency Response: 50Hz to 17kHz
- Polar Pattern: Cardioid
- Output Impedance: rated at 150 ohms (180 ohms actual)
- Maximum SPL: 124.2 dB
- Signal to Noise Ratio: 66.0 dB
- Dynamic Range: 96.2 dB
- Power Requirements: 11 to 52 Vdc phantom, 2.0 mA
|
Reviews
There are no reviews yet.