RME Babyface-Pro USB Desktop Sound Card

The exciting new Babyface Pro once again demonstrates RMEʼs absolute commitment to superior craftsmanship, not only in audio circuits and driver development, but also in mechanics. Created with the highest precision from a block of aluminum, this high-end yet portable interface incorporates newly designed analog and digital circuits. Its innovative energy saving technologies provide supreme fidelity with no compromises in level, noise or distortion.

Features:

USB 2.0 Desktop Recording Studio
44.1kHz to 96kHz sample rates, 24-bit resolution
Pantheon II VST/AU reverb plug-in with 6 legendary Lexicon reverbs
dbx® 60V high-voltage, ultra-low noise microphone preamps
Superior sonic performance
2 analog combi-jacks for mic/line inputs
2 analog 1/4" TRS balanced outputs
Zero latency monitoring
Low latency ASIO drivers
Streamlined monitor form factor puts all recording controls at your fingertips
Separate level meters and gain control per channel
1 side panel 1/4" instrument input
1 side panel headphone output with dedicated volume adjustment
MIDI in and out

Technical Specifications

Microphone Inputs:    Female XLR Pin 2 Hot
Input Impedance:    3kΩ balanced
Phantom Power:    +48 Volts
Maximum gain:    +58 dB
E.I.N. (at max gain):    -125 dBu @ 58dB gain typical (150Ω source) -129 dBu @ 58dB gain typical A-weighted (150Ω source)
Maximum Input Level:    +21 dBu at minimum gain
Frequency Response:    +0/-1 dB, 20Hz - 20kHz
THD+N:    +18 dBu maximum
Impedance:    32Ω Balanced, 16Ω Unbalanced
Headphone Output:    1/4" stereo jack 350mW per channel at 50Ω
MIDI Interface:    5 pin DIN connectors for MIDI in and MIDI out (5 volt signal)
Sample Rate:    44.1, 48, 88.2, or 96 kHz (determined by computer application)
Dynamic Range:    A/D (24 Bit) 108 dB typical, A-weighted, 20Hz - 20kHz
(44.1 kHz sample rate)
D/A (24 Bit) 110 dB typical, A-weighted, 20Hz - 20kHz
A/D/A (24 Bit) 102 dB typical, A-weighted, 20Hz - 20kHz
Power Requirements:    12W 9VAC
Power adaptors available for:
US and Canada: 120 VAC, 60 Hz Adapter: PS0913B - 120
Japan: 100 VAC, 50/60 Hz Adapter: PS0913B - 100
Europe: 230 VAC, 50 Hz Adapter: PS0913B - 230
UK: 240 VAC, 50 Hz Adapter: PS0913B - 240
Australia: 240 VAC, 50 Hz Adapter: PS0913B - 240-AU

Behringer UFO202 USB Audio Interface

Features

Compact and Versatile

48kHz Precision

Audacity Audio Editor Software

Specifications

• Input Connector: RCA, Unbalanced
• Input Impedance: Approx. 27kΩ
• Maximum Input Level: 2dBV
• Output Connector: RCA, Unbalanced
• Output Impedance: Approx. 400Ω
• Maximum Output Level: 2dBV
• Digital Output: Toslink, Optical
• Digital Output Format: S/PDIF
• USB: Type A
• Converter: 16-Bit
• Sample Rate: 32kHz, 44.1kHz, 48kHz
• Frequency Response: 10Hz - 20kHz ±1dB @ 44.1kHz Sample Rate
  • 10Hz - 22kHz ±1dB @ 48kHz Sample Rate
• Crosstalk: -77dB @ 0dBV, 1kHz
• Power Supply: USB, 5V 100mA Maximum
• Dimensions: 0.87" x 3.46" x 2.36" / 22mm x 88mm x 60mm (H x W x D)
• Weight: 0.10kg

he U46XL is a powerful multi-purpose 4-in 6-out multi-channel audio interface designed for various recording applications at home or on the road. The U46XL is the successor of to ESI Audio's famous U46DJ interface.

As its predecessor, it provides 2 stereo line inputs, a microphone input with +48V phantom power and a headphone output. A main difference is the improved analog circuitry improving the audio quality as well as the professional microphone preamplifier with XLR input. This makes the U46XL the perfect solution to record signals from dynamic or condenser microphones on the road or in your studio.

The unit also features an instrument input (Hi-Z), typically to connect a guitar directly to it. Two totally separate stereo line input on the backside provide 4 simultaneously usable input channels at one time. There are also 6 independent individual outputs on the backside, perfect for multi-channel playback applications like to provide individual outputs for software synthesizers, to provide independent playback channels for DJ software or to provide surround playback capability via a 5.1 setup. A separate mix output with professional TRS outputs could be used to connect U46XL to professional stereo studio monitors.

A cool feature is the DirectWIRE support in the driver, allowing you to record signals from one application to another internally. U46XL works with this driver based on our EWDM technology under Windows XP and Windows Vista/7, however U46XL is also Mac OS X compatible.

U46XL ships with Cubase LE 4 from Steinberg for Mac and PC to start recording on a professional level right out of the box.

• Number of Audio Record/Playback Channels	Record: 1 pair of stereo Play: 1 pair of stereo REC SOURCE switch = ANALOG: Full duplex (except for 96 kHz setting) REC SOURCE switch = DIGITAL: Recording only
  Signal Processing	PC interface: 24 bits AD/DA Conversion: 24 bits (linear) * ADVANCE DRIVER switch = OFF: 16 bits
  Sampling Frequency	Digital output: 32/44.1/48/96 kHz Digital input: 32/44.1/48/96 kHz AD/DA Conversion: 32/44.1/48/96 kHz * ADVANCE DRIVER switch = OFF: 32/44.1/48 kHz
  Nominal Input Level	Line input jacks: -10 to +4 dBu Guiter input jakcs: -30 to -16dBu Mic input jack: -40 to -26 dBu
  Nominal Output Level	Line output jacks: -10 dBu
  Interface	USB Digital input (Optical mini type) * The same jack serves as both the Mic Input jack and digital input connector. Digital output (Optical mini type) * The same jack serves as both the headphones jack and digital output connector. * conforms to IEC60958 consumer format.
  Controllers	ADVANCED DRIVER Switch Guiter/Mic Switch INPUT VOLUME knob PHONES VOLUME Dial SAMPLE RATE Switch 96kHz MODE Switch INPUT MONITOR Switch REC SOURCE Switch
  Connectors	USB Connector (B type) Line Input jacks (L, R) (RCA phono type) Line Output jacks (L, R) (RCA phono type) Guiter/Mic Input jack: （1/4 inch phone type) Mic Input jack (Plug-in powered miniature phone type) Digital Intput connector (Optical mini type) * The same jack serves as both the headphones jack and digital output connector. Headphones jack (Stereo miniature phone type) Digital Output connector (Optical mini type) * The same jack serves as both the Mic Input jack and digital input connector.
  Power Supply	Supplied from the computer
  Current Draw	200 mA
  Accessories	Ownerʼs Manual, UA-1G CD-ROM, SONAR LE CD-ROM
  Size and Weight
  Width	160 mm 6-5/16 inches
  Depth	58 mm 2-5/16 inches
  Height	28 mm 1-1/8 inches
  Weight	165 g 0 lbs. 6 oz.

  
  
  
  

Turn your computer into a powerful digital audio workstation with eight mic inputs. Or add eight high-quality mic/instrument inputs to your current system.

The 8pre FireWire audio interface delivers everything you need to turn your computer into a powerful 24-bit, 96kHz digital audio workstation. The 8pre provides eight microphone/instrument preamps with pristine 96kHz analog recording and playback, combined with 8 channels of ADAT optical digital I/O. Expand your system by connecting additional 8pres or other MOTU FireWire audio interfaces.

Use the included CueMix™ software to mix all 16 inputs from your computer. Eight channels of ADAT optical I/O make the 8pre an ideal companion for a digital mixer. Two ADAT lightpipe connections work together to support a full 8 channels of optical digital I/O at any sample rate up to 96kHz.

Connect all of your studio gear, including microphones, guitars, synths, keyboards, drum machines and even effects processors. Then monitor all of these live inputs via the 8preʼs main outs or headphone jack — with virtually no monitoring latency and no processor drain on your computer. You can even create separate monitor mixes for the main outs and headphones. Control everything, including talk-back and listen-back, from the included CueMix Console™ software, just like a large studio console.

The 8pre includes a 16-channel MIDI interface. Simply plug in your FireWire cable, and both MIDI and audio are ready to go. Connect any MIDI device, such as a controller keyboard, synth module, automated control surface or drum machine. Timing is sample-accurate with supporting software.

The 8pre provides cross-platform compatibility with Mac OS X 10.3 or higher, Windows XP and all of your favorite audio software and host-based effects via WDM/ASIO/Core Audio drivers. Or you can use the included AudioDesk workstation software for Mac OS, with 24-bit recording/editing and 32-bit mixing/processing/mastering.

The 8pre is really two products in one. When it is not connected to a computer via FireWire, the 8pre functions as an eight-channel analog to digital (optical) converter. Connect the 8pre to your MOTU 828, 896, Traveler or even another 8pre via the optical "lightpipe” connection to add eight high-quality microphone pre-amps to your system. Since the connection is digital, 100% pristine sound is maintained, down to the very last sample.

MOTU FireWire audio interfaces are fully compatible with FireWire 800-equipped Macs. All you need is a standard FireWire 400-to-800 cable. Just plug in and go. The FireWire bus operates at 400 Mb/sec, providing the same high speed, low latency and rock solid reliability that MOTU FireWire interfaces are known for.

The 8pre is the perfect way to instantly add eight more mic inputs to any audio interface or digital mixer with optical I/O. If you have a MOTU interface with on-board CueMix DSP mixing, such as the 828mkII, 896HD or Traveler, the 8pre inputs appear directly in the host interface's CueMix mixer to becomes a transparent extension of your system, operating together with your primary interface as a single, integrated unit — even when the host interface is not connected to a computer and is instead operating as a stand-alone mixer.

If you have a 2408mk3, digital mixer or other audio device that supports 96kHz optical and also has two optical inputs, the 8pre connects to it via both optical ports to provide a full eight channels of analog to optical conversion at the 88.2 or 96kHz sample rates.