Content |
The BEYERDYNAMIC DT-297-PV/80 is a double-sided headset Microphone with Cable
All DT 297 versions are supplied with connecting cable.
Technical Specifications
Transducer type Condenser (back electret)
Operating principle Closed
Polar pattern Cardioid
Open circuit voltage at 1 kHz (0dB = 1V/Pa) 5 mV/Pa at f = 1 kHz
Nominal impedance approx. 300 Ω
Load impedance > 1000 Ω
Weight without cable 240 g
Frequency response 40 - 20,000 Hz
Current consumption approx. 3.5 mA
Ambient noise isolation approx. 16 dBA
T.H.D.
Max. SPL 132 dB
Phantom supply 12 - 48 V
S/N ratio 62 dB
Weight 30 g
Nominal SPL at 1 kHz 100 dB
Average pressure on ears 4.5 N
Gooseneck length 120 mm
Capsule diameter 19 mm | Specs:
- Semi - Open
- Innovative bass refelx system
- Rugged headband cosntruction
- Single-sided coiled cable
- Soft headband pad
- Gold plated stereo mini jack (3.5mm) and 1/4" adapter
- Transducer type: Dynamic
- Frequency response: 5 - 35,000 Hz
- Nominal impedance: 250 ohm
- Nominal SPL : 96 dB
- T.H.D: < 0.2%
- Power handling capacity: 100 mW
- Sound coupling to ear: Circumaural
- Weight (without cable) 295 g
| DT770 Closed headphone for drummers and monitoring purposes (FOH), with extreme isolation against ambient noise.
The dynamic, closed DT 770 M has especially been designed for drummers and FOH monitoring. The strengthened headband and the softskin ear pads provide an excellent isolation against ambient noise. The single sided straight cable allows a volume control directly at the headphone.
▲ Closed headphone
▲ Excellent ambient noise attenuation (35 dBA)
▲ Superb sound quality with high sound pressure level (105 dB)
▲ Extended frequency range
▲ Single-sided cable with volume control
▲ Robust, easy serviceable construction as all parts are replaceable
▲ Excellent comfort for long-term wearing, softskin ear pads
▲ Secure and comfortable fit due to rugged, adjustable headband construction with soft padding
▲ Single-sided cable
▲ Supplied in a carrying case (nylon)
Transmission type |
|
Wired |
Headphone design (operating principle) |
|
Closed |
Headphone impedance |
|
80 ohms |
Headphone frequency response
The frequency response specifies the highest and lowest frequencies reproduced by the acoustic transducer of the headphones. |
|
5 - 30.000 Hz |
Nominal sound pressure level
The (nominal) sound pressure level is the pressure in pascals (Pa) with which the air and the eardrum are caused to vibrate, better known as the volume. The sound pressure level is therefore a measure of the volume of a set of headphones under standardized conditions. However, it says nothing about whether the distortion is low and the sound is good at such a high volume. |
|
105 dB |
Construction |
|
Circumaural (around the ear) |
Cable & plug |
|
Straight connecting cable with mini-jack plug (3.5 mm) & ¼" adapter (6.35 mm) |
Net weight without packaging |
|
300 g |
| The ATH-M20x professional monitor headphones are a great introduction to the critically acclaimed M-Series line. Modern design and high-quality materials combine to deliver a comfortable listening experience, with enhanced audio and effective isolation. An excellent choice for tracking and mixing.
- Advanced build quality and engineering
- 40 mm drivers with rare earth magnets and copper-clad aluminum wire voice coils
- Tuned for enhanced low-frequency performance
- Circumaural design contours around the ears for excellent sound isolation in loud environments
- Convenient single-side cable exit
Specifications
- Type: Closed-back dynamic
- Driver Diameter: 40 mm
- Magnet: Neodymium
- Voice Coil: Copper-clad aluminum wire
- Frequency Response: 15 - 20,000 Hz
- Maximum Input Power: 700 mW at 1 kHz
- Sensitivity: 96 dB
- Impedance: 47 ohms
- Weight: 190 g (6.7 oz), without cable and connector
- Cable: 3.0 m (9.8'), straight, left-side exit
- Accessory Included: 6.3 mm (1/4“) snap-on adapter
|
Transmission Type: Wired
Headphone frequency response: 10 - 30.000 Hz
Nominal sound pressure level: 100 dB SPL
Sound coupling to the ear: Circumaural (around the ear)
Cable & Plug: Detachable cable – various connectors available
Polar Pattern For Microphone: Hypercardioid
Transducer type for microphone: Dynamic - Hypercardioid
| 80 Ohm specs
- Type Over-ear (Closed)
- Channels Stereo
- Noise isolation 18 dB reduction
- Connections 3.5mm stereo, 6.25mm stereo
- Weight 9.52 oz
General
- Type Over-ear (Closed)
- Cable type Y-cable
- Channels Stereo
Other features
- Plug type Straight
- Gold-plated connector Yes
Audio quality
Noise reduction
- Noise isolation 18 dB reduction
Connections
- Connections 3.5mm stereo, 6.25mm stereo
|
Reviews
There are no reviews yet.