BLACKSTAR ID: CORE 20 V2 Guitar Amplifier

ID:CORE V2 represents the culmination of more than nine years’ technical Research and Development. These amps have an intuitive control set like a traditional amp, but have the versatility of programmability. The unique controls allow you, the guitarist, to custom design your own sound. The unique and enhanced Voice control has six different channels - Clean Warm, Clean Bright, Crunch, Super Crunch, OD 1, OD 2. When used together with Blackstar\'s patented ISF control you can get the exact tone you\'re thinking of. The effects section delivers studio quality modulation, delay and reverb effects simultaneously that you can store with your sound.

• 2x10W programmable combo
• Super Wide Stereo
• EQ with patented ISF
• Voice - select from 6 classic channels
• 12 Stereo Effects
• Store up to 6 of your sounds
• Free INSIDER software
• USB Mini B for use with INSIDER and Recording (Cable Not Included)
• Stereo MP3/Line with dynamic EQ for great sounding music playback
• Speaker Emulated Line Out for silent practice or recording
• Stereo speaker configuration
• Mains powered via a separate PSU (Included)
• Presonus Studio One Blackstar Edition DAW Software

Vox AD50VT 50W Guitar Amplifier

Number of amp types: 11
Number of effects: 11, Noise reduction: 1
Number of programs: 11 preset, 2 channel.
Input/output jacks: Top panel ??? 1 x INPUT. Rear panel ??? 1 x FOOT SW , 1 x LINE/ PHONE,
(AD100VT, AD50VT & AD50VT121 only) 1 x EXTERNAL SPEAKER OUT, (AD100VT only) 1 x LOOP RETURN Jack
1 x LOOP SEND Jack.
Power amp output:AD100VT = maximum 100 RMS @ 8 ohms, AD50VT(212) = maximum 50W RMS @ 8 ohms
AD30VT = maximum 30W RMS @ 8 ohms, AD15VT = maximum 15W RMS @ 8 ohms.
Adjustable Output Wattage (AD100VT, 50VT, 50VT-212, 30VT).
Speaker: AD100VT = 2 x 12 inch VOX oringinal 16 ohm, AD50VT-212 = 2 x 12 inch VOX oringinal 16 ohm
AD50VT = 1x Celestion 70/80 (12 inch 8 ohm), AD30VT = 1x VOX original (10 inch 8 ohm), AD15VT = 1x VOX original
(8 inch 8 ohm),
Signal processing A/D conversion: 24-bit, D/A conversion: 24-bit, Sampling frequency: 44.1 kHz .
Power supply requirements: AC, local voltage.
Power consumption: AD100VT=100W, AD50VT(212)=52W, AD30VT=45W, AD15VT=23W
Dimensions: AD100VT = 55.3cms (21.77“) (H) x 68.4cms (26.93“) (W) x 26.8cms (10.55“) (D),
AD50VT-212 = 48.5cms (19.09“) (H) x 67.3cms (26.50“) (W) x 26.5cms (10.43“) (D),
AD50VT = 50.67cms (19.95“) (H) x 57.81cms (22.76“) (W) x 26.5cms (10.43“) (D),
AD30VT = 43cms (16.93“) (H) x 45.59cms (17.95“) (W) x 22.40 cms (8.82“) (D),
AD15VT = 39.5cms (15.55“) (H) x 42.8cms (16.85“) (W) x 22.4cms (8.82“) (D)
Weight: AD100VT = 29kg (63.93lbs), AD50VT-212 = 23kg (50.71lbs), AD50VT = 20kgs (44.09lbs)
AD30VT = 12kgs (26.46lbs), AD15VT = 10kgs (22.05lbs) .
Included items: power cable .
Options (sold separately): VFS2 dual foot switch.

Those instantly recognizable, warm British sounds you've come to expect from VOX are alive and well in the compact, 10-Watt Pathfinder 10 combo - plus a high gain capability that's thoroughly modern!

This 10-Watt, 1 x 6.5" combo's eye-catching looks are also classic VOX and include basket-weave, leather-look vinyl, our distinctive diamond grille cloth and, of course, chicken head knobs! Small but all-important details such as gold beading and white piping have also been faithfully reproduced, perfectly recapturing the legendary look of VOX.

Little Yet Loud!
The Pathfinder 10's powerful yet always tone-filled 10-Watt output, makes this amp perfect for home practice, backstage warm-up and recording. The Clean/Overdrive switch allows you to change instantly between clean and dirty sounds. With a mere press of this switch you can go from a crystal clear clean sound to our uniquely warm distortion; or from a slightly crunchy bluesy tone to a high-gain, modern-rock roar.

Headphone/Lineout jack
Want to practice late at night without disturbing your neighbours? No problem! Just plug your headphones into the Headphone/Line Out jack and away you go - your sleeping neighbours won't hear a thing because using this jack automatically mutes the amp's speaker! This jack also doubles as a specially filtered Line Out which is perfect for recording your amp without having to worry about setting up any pesky microphones. The Pathfinder 10 also features controls for Gain, Treble, Bass and Volume plus a Clean/Overdrive switch.

• Input Jacks. This, believe it or not, is where you plug your guitar into the amp!
• Gain Control. This adjusts the overall preamp gain of the amplifier. This control can produce a wide variety of killer tones - from clean to crunchy to crazy and all points in-between! What you get all depends on how you set this control and also how you have the Clean/Overdrive Switch (3) set. In both Switch modes - Clean & Overdrive - turning the Gain control down (i.e. counter clockwise) will clean up your sound while cranking it up (i.e. turning it clockwise) will dirty things up. The possibilities are endless.
• Clean/Overdrive Switch. As its name suggests, this switch puts the preamp of the Pathfinder 10 in one of two distinctly different modes -Clean (switch "out“) or Overdrive (switch "in“). And, as you'd expect, the Overdrive mode has bags more gain than the Clean mode. So, if you want more gain just press this button in and let rip!
• Treble Control. This adjusts the treble (high) frequencies in your tone. It can take your sound from soft and round, to bright and cutting, and any point in-between.
• Bass Control. This adjusts the bass (low) frequencies in your tone. It can take your sound from warm and light, to dark and heavy and any point in-between.
• Volume Control. This determines the overall volume of the amplifier. Setting this control high while keeping the Gain low works well for clean sounds (HINT: make sure the Clean/Overdrive Switch is "out" if you wanna go clean!), while setting the Master Volume lower, engaging the Overdrive mode and turning up the Gain will give you a fat, distorted sound at a lower, "bedroom friendly" volume.
• Headphone/Line Out Jack. This dual output carries a specially filtered signal for use with either headphones or for direct connection to a soundboard or recording console. The LINE OUT gives you a good sounding signal for recording or live work without having to mic up the amp. Inserting a jack-plug into this jack will mute the internal speaker.
• Power ON/OFF Switch & LED. On/Off switch for mains (AC) power to amplifier. Plus power indicator LED.

• Circuitry: Solid-State
• Output: 10-Watts RMS
• Speakers: Vox Bulldog x 1 (6.5“, 8 ohm)
• Controls: Gain, Treble, Bass, Volume, Clean/Overdrive Switch, Power On/Off
• Input: Input Jack
• Outputs: Headphone/Line Out Jack
• Dimensions: 380mm(w) x 260mm(h) x 170mm(d) / 14.96“(w) x 10.24“(h) x 6.69“(d)
• Weight: 4.8Kg/10lbs

• Hand-built and hand-wired 120-Watt Class A/B amplifier driven by 4 x 6L6 tubes (now fully compatible with EL34 and 5881, etc.)
  
• 2 original 12" BUGERA guitar speakers optimized for tight low-end and modern-vintage mids
  
• Modern 3-channel preamp design (Clean, Crunch, Lead) featuring 4 x 12AX7 valves for boutique clean and face-melting hi-gain tone
  
• Integrated high-class reverb is assignable per channel and has a dedicated Reverb control
  
• Revolutionary INFINIUM Tube Life Multiplier technology:
  
  • Extends the life of your amplifierʼs expensive power valves up to 20 times.
    
  • Provides incredible reliability and consistent tone over the complete lifespan of your valves
    
  • No need for expensive matched valve sets
    
  • Allows you to mix and match any combination of compatible valve types and brands
    
  • Monitors performance of each power tube continuously and displays defective valves to allow for easy and individual replacement

• Fully independent Equalizer sections for each channel with dedicated Bass, Mid and Treble control
  
• Power amp damping switchable (High, Medium, Low) for total sound control
  
• Remote controlled FX Loop with adjustable Send and Return level also serves as Boost function
  
• Heavy-duty footswitch for Channel selection and FX Loop/Boost function included
  
• Line output with dedicated Level control
  
• Impedance switch (4, 8 and 16 Ohms) to match virtually any speaker cabinet
  
• High-quality components and exceptionally rugged constructionensure long life

The 2266C 50-watt 2X12 combo is an all-valve single channel amplifier with a choice of 2 "dynamic ranges" selectable by a footswitch. The Low range equates to the performance you would come to expect from a stock vintage Marshall amplifier in terms of tone and available gain. The High range adds an extra preamp valve into the signal path, facilitating those classic hard rock tones of the '70s.

Specification
Output (RMS): 50 watts
Speakers: 2 x G12C
Pre-amp Valves: 4 x ECC83
Power Amp Valves: 2 x KT66
Footswitch (Supplied): PEDL-00041
Dimensions (mm): 690 x 5700 x 270
Weight (kg): 30