CELESTION CDX1-1070 ORIGINAL DRIVER FOR YAMAHA STAGEPAS T5866A YE271A00 400i

Celestion Original spare part CDX1-1070 T5916AXP compatible with YAMAHA T5866A

Spare part tweeter 2.5 cm

Power : 20W / 8 Ohm

As used by Celestion CDX1-1010 - 

CELESTION CDX1-1070 8 Ohm Tweeter Magnet inkl. Diaphragm for Yamaha Stagepas 400i

• 1” exit light weight, low-profile ferrite magnet compression driver with
  1” copperclad aluminium voice coil
• 20Wrms (AES standard) power handling and 106dB sensitivity, 1500Hz – 20kHz frequency range
• Single piece PETP film diaphragm and surround
• Finite element analysis (FEA) used to optimise magnetic, acoustic and electro mechanical design
• Ideal for entry level two-way sound reinforcement cabinets

General Specifications
Power rating: 12Wrms
Nominal impedance: 8 Ω
Frequency range: 1.5kHz 20kHz
Sensitivity: 106dB
Recommended min. crossover: (12dB/oct) 2200Hz
Voice coil diameter: 25mm/1in
Voice coil material: Copper clad aluminium
Magnet type: Ferrite
Diaphragm material: PETP film
Surround material: PETP film

Mounting Information
Overall width: 70mm/2.8in
Overall depth: 50mm/2in
Fitting Flange: (2xM6 holes on 76mm/3in PCD)
Throat exit: 25mm/1in
Unit weight: 0.5kg/1.1lb

1” high frequency compression driver, titanium
diaphragm, flat aluminium wire voice coil, low distortion,
extremely good response from 1.5 kHz. to 18 kHz.

Specifications1
Throat Diameter 25 mm. (1 in.)
Nominal Impedance 8 Ω
Minimum Impedance 7.6 Ω
Power Handling
(1500 –20000 Hz)
Nominal2 60 W
Continuous Program3 120 W
Sensitivity (1W/1m)4 106 dB
Frequency Range 1 – 18 kHz
Recommended Crossover5 1.5 kHz
Voice Coil Diameter 44 mm. (1.7 in.)
Winding Material Aluminium
Inductance 0.11 mH
Diaphragm Material Titanium
Flux Density 1.7 T
Also available in 16 Ω, data upon request

Mounting and Shipping Informations
Two M6 holes 180° on 76 mm. (3 in.) diameter
Three M6 holes 120° on 57 mm. (2.2 in.) diameter
Overall Diameter 134 mm. (5.3 in.)
Depth 68 mm. (2.7 in.)
Net Weight (1 unit) 2.9 Kg. (6.4 lb.)
Shipping Weight (4 units) 12.5 Kg. (27.5 lb.)
Shipping Box (4 units) 300x160x180 mm.
(12x6.3x7.1 in.)
1 Driver mounted on B&C ME 45 horn.
2 2 hours test made with continuous pink noise signal (6 dB crest factor) within
the specified range . Power calculated on rated minimum impedance.
3 Power on Continuous Program is defined as 3 dB greater than the Nominal
rating.
4 Applied RMS Voltage is set to 2.83V for 8 ohms and 4V for 16 ohms Nominal
Impedance. Average SPL from 1000 to 18000 Hz.
5 12 dB/oct. or higher slope high-pass filter.