Specifications Front panel LED displays indicate power, clip protect and signal status Balanced XLR and TRS Input connectors Speakon NL-4 locking output connectors and binding posts Detented 21-position input level control knobs Defeatable limiter and high pass filter per channel Short circuit, thermal, current limit, DC offset, current […]
Front panel LED displays indicate power, clip protect and
signal status
Balanced XLR and TRS Input connectors
Speakon NL-4 locking output connectors and binding posts
Detented 21-position input level control knobs
Defeatable limiter and high pass filter per channel
Short circuit, thermal, current limit, DC offset, current inrus, RF protection, Turn on/ Turn off muting protection
5-way binding post and Speakon output connectors
Flow-through cooling design prevents overheating with continuously variable speed, front to rear
Performance Data:
Frequency Response: 0/-0.5dB ; 20Hz-20KHz, 0/-3dB: 5Hz-60KHz
Rated Output Power (Stereo): 210 watts at 8 ohms; 320 watts at 4 ohms; 420 wats at 2 ohms
Rated Output Power (Mono): 650 watts at 8 ohms; 845 watts at 4 ohms
At Full Power @4 ohms: 10.5A / 5.5A
Signal to Noice Ratio: 20 Hz – 20k Hz – 100dB
Distortion (SMPTE-IM): .05%
Output Circuitry: AB
Damping Factor (400 Hz): 200
Weight
12.60 kg
Reviews
There are no reviews yet.
Be the first to review “CERWIN VEGA CV-900 HIGH PERFORMANCE PROFESSIONAL POWER AMPLIFIER 2Χ210W 8Ω” Cancel reply
Front panel LED displays indicate power, clip protect and
signal status
Balanced XLR and TRS Input connectors
Speakon NL-4 locking output connectors and binding posts
Detented 21-position input level control knobs
Defeatable limiter and high pass filter per channel
Short circuit, thermal, current limit, DC offset, current inrus, RF protection, Turn on/ Turn off muting protection
5-way binding post and Speakon output connectors
Flow-through cooling design prevents overheating with continuously variable speed, front to rear
Performance Data:
Frequency Response: 0/-0.5dB ; 20Hz-20KHz, 0/-3dB: 5Hz-60KHz
Rated Output Power (Stereo): 210 watts at 8 ohms; 320 watts at 4 ohms; 420 wats at 2 ohms
Rated Output Power (Mono): 650 watts at 8 ohms; 845 watts at 4 ohms
At Full Power @4 ohms: 10.5A / 5.5A
Signal to Noice Ratio: 20 Hz - 20k Hz - 100dB
Distortion (SMPTE-IM): .05%
Output Circuitry: AB
Damping Factor (400 Hz): 200
Solid DYNACORD technology for fixed installations at very competitive prices. DSA power amplifiers offer a very high, stable output with high efficiency at a high performance level and are therefore the ideal choice for typical fixed installation applications. The connectivity consequently provides Phoenix type in/outs, the input level controls are located on the rear panel, also a switchable high-pass filter (50 Hz, 18 dB/oct) and a Ground Lift switch. The POWER REMOTE connector makes the task of remote controlling the power amplifier as well as switching it on and off simple. For further remote-supervision and –control possibilities and integration into IRIS-Net networks, an optional remote control module (RCM-810) is available.
HPS 1500 is a 2 channel power amplifier that delivers up to 2 x 750 W RMS @ 4 Ω (1500 W RMS bridged @ 8 Ω).
XLR inputs for patching in signals as well as Speakon ports for connecting speaker systems are provided for the maximum flexibility.
A forced air cooling system maintains a low operating temperature.
Features
Fast response and low distortion
Easy to configure in stereo / mono / bridge modes
Extensive protective circuits ensure high reliability and operating safety
Front panel signal / clip / protect LED indicators
Minimum load impedance (stereo / mono): 4 Ohm
XLR input connectors
SPEAKON output connectors
Switchable limiter
2 unit 19" rack, low weight for easy transportation
AMPLIFIER SPECIFICATIONS
Power output stereo 4Ω:
2 x 750 Watt rms
Power output stereo 8Ω:
2 x 450 Watt rms
Power output bridged 8Ω:
1500 Watt rms
Frequency Response:
20 Hz ÷ 20 kHz
Signal/noise rate:
106 dB
Damping factor:
> 300
Slew rate:
50 V/μS
INPUT SECTION
Input connector:
xlr
Input sensitivity:
1.4 V (/ 32 – 26 dB) dBm/V RMS
Input impedance:
20 kΩ (balanced), 10 kΩ (unbalanced) kΩ
OUTPUT SECTION
Output connector:
Speakon
SYSTEM PARAMETERS
Cooling:
Forced
Amplifier class:
H
POWER REQUIREMENT
Operating voltage:
220 ÷ 240 V (50 / 60 Hz) V ~ Hz
PHYSICAL SPECIFICATIONS
Height:
88/3.4 mm/inch
Width:
482/18.9 mm/inch
Depth:
420/16.5 mm/inch
Net Weight:
17/37.4 Kg/Lbs
XB Series - Intelligent Power
Power Without Compromises. The XB is designed for paging, music and alarm signals. Versatile, dynamic and extremely rugged according to IEC286-3. For the highest requirements in safety and quality. Sequential power on, alive contacts and incorporated ground fault detection- the XB is the solution under all conditions. Without the need for additional equipment. For uninterrupted and troublefree operation.
High Tech SMT Design Protection Circuits: DC, LF, HF, Thermal, Short Circuit, Current Limiter, 3 ms Muting Delay PHOENIX / Speakon LED Indicators for POWER, SIGNAL, CLIP, PROTECT Temperature controlled, variable speed low noise fans Volume Controls at the back Stereo / Bridged / Parallel Mode Softstart Sequential Remote Power On Alive Contact Ground Lift 3 Years Warranty
TECHNICAL DATA: XB 800: 2x 400 W @ 4 Ohm Class: AB Frequency Response: 20 Hz - 20 kHz (0 / -0.3 dB) THD: < 0.025% Signal-to-Noise Ratio: < 103 dB Channel Seperation: > 85 dB Input Sensitivity: +6 dBu Input Clipping: 22 dBu Input Impedance: 20 kOhm Damping Factor: 500 @ 4 Ohm Cooling: 2x fan (temp. reg. variable speed) Weight: 13 kg/(29 lbs) Dimensions: 2 RU / 483 x 88 x 382 mm (19" x 3.5" x 15“)
This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Cookie settingsACCEPT
Privacy & Cookies Policy
Πολιτική χρήσης
Αυτός ο ιστότοπος χρησιμοποιεί cookies για να βελτιώσει την εμπειρία σας ενώ περιηγείστε στον ιστότοπο. Από αυτά τα cookies, κάποια cookie κατηγοριοποιούνται ως απαραίτητα να αποθηκεύονται στο πρόγραμμα περιήγησης σας, καθώς είναι απαραίτητα για τη λειτουργία βασικών λειτουργιών του ιστότοπου. Χρησιμοποιούμε επίσης cookies τρίτων που μας βοηθούν να αναλύσουμε και να κατανοήσουμε πώς χρησιμοποιείτε αυτόν τον ιστότοπο. Αυτά τα cookies θα αποθηκευτούν στο πρόγραμμα περιήγησης σας μόνο με τη συγκατάθεσή σας. Έχετε επίσης την επιλογή να εξαιρεθείτε από αυτά τα cookies. Ωστόσο, η εξαίρεση από ορισμένα από αυτά τα cookie μπορεί να επηρεάσει την εμπειρία περιήγησης σας.
Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.
Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies. It is mandatory to procure user consent prior to running these cookies on your website.
<br>
- Frequency Response: (+/-01db, @rated output Power, 8 Ohms): 20Hz - 20K Hz<br>
- Slew Rate: 15V Per usec<br>
- Damping Factor: @ 8 Ohm: 300<br>
- Impedance: 20 Ohms balanced / 10 Ohms unbalanced<br>
- Cooling System: 2 individual fans<br>
- Special Features: High/Low Pass Filter / Input Sensitivity Selector / Ground Lift; Limiter<br>
- build in clip limiter<br>
- Input: XLR 3pin + Jack 6,3mm<br>
- output: Speakon + Binding post<br>
- Dimensions (LxWxH): 360 x 482 x 88mm 2-rack mount spaces<br>
- Weight: 15 KG. <br></p></td><td>
<ul><li>2Χ350W 8Ω 2x500W 4Ω 2x650W STEREO MODE<br>
<br>
<br>
</li><li>BRIDGE 2000W 4 Ω</li><li> 16Kg</li></ul><br>
<ul><li>2 x 1,000 Watts into 2 Ohms; 2 x 750 Watts into 4 Ohms; 2,000 Watts into 4 Ohms (bridge mode)</li><li>Precise Power, Signal and Clip LEDs to monitor performance</li><li>XLR and 1/4 "acrobat_reader_logo."){kind=logo}
Reviews
There are no reviews yet.