Content | Product Description
Diamond dn245 , dms245 TYPE 1740-d7 Diamond Stylus for Turntable
Replacement Aftermarket Stylus: dual
Specs:
- Quality: Genuine stylus
- Stylus-name: DN 245
- Manufacturer: Dual
- Material: diamond, bonded
- Stylus-type: spherical
- Tracking force, recommended:
- Cartridge: DMS 245
Suitable to replace the following stylus models:
Replaces these needles.
Dual DN 245, DN245
Digitrac 25 S, 25S
Digitrac 25 SP, 25SP
Ortofon M 5, m5
Ortofon M 10, M10
Found in these cartridges:
Dual DMS 245, DMS245
Ortofon M 5 P, M5P
Ortofon M 10 P, M10P
May be found in these turntables if original cartridge still present and depending on the country in which the unit was sold.
Dual CS 2110
Dual CS 2115
Dual CS 2120
Dual CS 2125
Dual CS 430
Dual CS 435
Dual CS 450
Dual CS 455
Dual CS 455-1
Dual CS 503-1
Dual CS 540
Dual CS 545
Fisher MT-872
Schneider 6200 Concert
Telefunken HS 660
Telefunken HS 860
Telefunken HS 870
Telefunken R 660
Telefunken T 660
Telefunken T 860
Dual DN-149 styli, Dual DN-150E stylus, Dual DN-160E needles, Dual DN-211 styli, Dual DN-222 stylus, Dual DN-238 needles, Dual DN-22 styli, Dual DN-301 needles, Dual DN-305 stylus, Dual DN-4 stylis, Dual DN-7 styli, Dual DN-245 stylus | Stylus 2M Black
Technical data |
|
Frequency range |
20-31.000 Hz |
Frequency response |
20-20.000 Hz + 2 / - 0 dB |
Tracking ability at 315Hz at recommended tracking force *) |
80 µm |
Compliance, dynamic, lateral |
22 µm/mN |
Stylus type |
Nude Shibata |
Stylus tip radius |
r/R 6/50 µm |
Tracking force range |
1,4-1,7 g (14-17 mN) |
Tracking force, recommended |
1,5 g (15 mN) |
Tracking angle |
20° |
Stylus colour |
Black |
|
|
Recommended for following cartridges |
2M Black |
*) Typical value |
Ortofon 530MKII Stylus Technical Data
Frequency range 20-25.000 Hz
Frequency response 20-20.000 Hz + 2 / - 3 dB
Tracking ability at 315Hz at recommended tracking force 80 µm
Compliance, dynamic, lateral 30 µm/mN
Stylus type Nude Fine Line
Stylus tip radius r/R 8/40 µm
Equivalent stylus tip mass 0,3 mg
Tracking force range 1,25-1,75 g (12,5-17,5 mN)
Tracking force, recommended 1,75 g (17,5 mN)
Tracking angle 20°
Stylus colour Black
Recommended for following cartridges Series 530 Mkll, 530, 530 P |
| Replacement stylus for the Carl Cox Signature CS-1 Cartridge.
* Frequency response: 20 to 22,000Hz
* Output: 6mV
* Channel separation nominal: 32dB
* DC resistance: 430 ohms/ch
* Inductance: 400mH/ch
* Weight: 18.0g
* Channel balance: within 1.5dB
* Tracking force: 3–6g
* Recommended load: 47K ohms 200pf
* Stylus tip: fine circular diamond
* Application: club and mobile DJs, high output |
DJ E Replacement stylus
Basic model for scratch and back-cueing. Outstanding rigidity by extra-strengthened cantilever
Features Special Elliptical stylus and a special developed and extremely balanced cantilever.
Not only does the cartridge have a most sufficient tracking ability, it is also nearly unbreakable and provides the DJs with the most needed stringency. Furthermore, it equals very low record wear, an advantage for busy DJ.
The DJ series has been known to many as the "jack of all trades," with improved tracking, alongside of accurate sound reproduction. Featuring a low wear stylus design, the DJ provides excellent groove handling, even with less weight applied.
DJ E Stylus Technical data
Output voltage at 1000Hz, 5cm/sec. - 6 mV Channel balance at 1kHz - 2 dB Channel separation at 1kHz - 23 dB Channel separation at 15 kHz - 15 dB Frequency range at -3dB - 20-22.000 Hz Frequency response - 20-20.000 Hz +/-2 dB Tracking ability at 315 Hz at recommmende tracking force - 80 μm Compliance, dynamic lateral - 9 μm/m N Stylus type - Special Elliptical Stylus tip radius - r/R 13/25 μm
Tracking force range - 2,0-4,0 g (20-40 mN) Tracking force recommended - 3,0 g (30 mN) Tracking angle - 20° Internal impedance, DC resistance - 750 Ohm Internal inductance - 450 mH Recommended load resistance - 47 kOhm Recommended load capacitance - 200-600 pF Cartridge weight - 18,5 g
Compatible with cartridges - DJ S
| Genuine Original Stylus for OM 30, OM 30 Super, OMP30, LM 30, Concorde 30, TM 30H
Nude Fine Line
Interchangeability/Upgrade Group: A |
Reviews
There are no reviews yet.