Content |
Furman M10Lx E Power Conditioner form the Merit Series Power Conditioners is the perfect low cost AC power solution for any rack mount system. Install an Furman M10LxE in to the top slot of your rack, and the 10 switched outlets in the rear panel will power up and protect all your equipment up to a 10 amp load. It not only protects anything plugged into it from spikes and surges, but also has a built in AC noise filter to rid the system of RFI / EMI interference.
TheFurman M-10Lx E also features two slide out, swivelling light fixtures to provide discreet illumination of your equipment. A dimmer knob allows the user to adjust the level of illumination. Merit Series units are protected by a limited three year warranty covering defects in materials and workmanship.
Features
- AC Noise filtering to reduce radio frequency and electromagnetic interference (RFI/EMI)
- Spike & surge protection ensures equipment stays safe and your power stays clean
- 10 rear panel outlets, with front panel convenience outlet
- 10 amp rating, with circuit breaker
- Two retractable LED light fixtures with dimmer control for convenient rack illumination
- Three year warranty
Specification
- Maximum Output Current: 10 amps
- Lamps: LED
- Operating Voltage: 230VAC 50Hz
- Spike Protection Mode: Line to neutral
- Peak Impulse Current: 12,000 amps
- Maximum Continuous Operating Voltage: 650 Volts
- Noise Attenuation: Transverse mode: Greater than 20dB, 1.5Mhz to 200 Mhz
- Dimensions (inches, HxWxD): 1.75 x 19 x 7.5
- Weight: 2.3 kg
|
- Rated @ 250 V, 16 A
- 16 x 45° angled outlets
- 8 front and 8 rear outlets with individual on/off switches
- Overload protection
The 874716 provides 16 type F grounded outlets in a 19" aluminum enclosure with permanently attached 2 m cord and angled CEE 7/7 power plug. The 1 U rackmount power strip features individual illuminating on/off switches for the 8 front and rear outlets each plus overload protection with individual circuit breakers and reset buttons.
Product type
19" rack mains socket strips
Type
19" / 1 U
Number of outlets (Earthing contact / IEC 7/4)
2 x 8
Power input
cables
Cable length
2 m
Cable connector
angled , Earthing contact (CEE 7/7)
Cross section
1.5 mm²
Operating voltage
250 V
Max. current
16 A
Cabinet material
Aluminium
Colour
Black
Width
485 mm
Height
44 mm
Depth
126 mm
Special feature
8 x Sockets back side , 8 x Sockets front side , Overload protection for front and rear side , Separate front and rear switches
Weight
1,7 kg
|
Rack lighting panel with two gooseneck. Dimmer. 12 V. lamps. I
ncludes power supply.
Dimensions: (W x H x D) 482 x 43 x 43 mm.
Weight: 2,5 kgs. |
The Furman PL-Plus C Power Conditioner protects your valuable equipment from mains power spikes and sags. Advanced Series Multi-Stage Protection Plus SMP+ circuit provides rock-solid, maintenance-free extreme surge suppression with zero ground contamination thanks to Furman Linear Filtering Technology LiFT. The Furman PL-Plus features 8 rear-panel AC mains outlets and one front-panel AC mains outlet, a 10-amp rating with circuit breaker, retractable LED rack lights with on/off/dimmer control, BNC back panel connector for gooseneck lamp with front-panel switch, and a segmented LED voltmeter to monitor and display incoming line voltage. The Furman PL-Plus C fits in one 19-inch rack space.
Traditional surge suppression circuits "sacrifice" themselves when exposed to multiple transient voltage spikes, requiring the dismantling of your system, and repair of your surge suppressor. Not so withFurman SMP+. With the PL-PLUS C's SMP+, damaging transient voltages are safely absorbed, clamped and dissipated. No sacrificed parts, no maintananc, no down time.
Unique to the Furman PL-PLUS C's SMP+ is its clamping voltage. Other designs offer clamping voltages that are well above 375VAC peak, the Furman PL-PLUS C's SMP+ clamps at 375VAC peak, even when tested with multiple 6000VAC - 3000 Amp surges! This unprecedented level of protection is only available with Furman's SMP+ technology.
The Furman PL-PLUS C features LED rack lights which produce virtually no heat and provide an extremely long life. A dimmer control for the rack lights allows the user to adjust the level of illumination or simply switch the lights off. The Furman PL- PLUS C includes a rear mounted BNC jack which accepts any standard 12VAC, 0.5A gooseneck lamp for rear rack illumination, as well as a front panel switch which controls the gooseneck's operation
FURMAN PL-PLUS C E CLASSIC SERIES POWER CONDITIONER WITH VOLTMETER FEATURES
8 Rear-panel outlets and one front-panel outlet.
10-amp rating with circuit breaker.
Retractable LED rack lights with on/off/dimmer control.
BNC back panel connector for gooseneck lamp with front-panel switch.
Segmented LED voltmeter to monitor and display incoming line voltage.
Multi-stage protection.
Extreme voltage shutdown.
Linear filtering technology.
FURMAN PL-PLUS C CLASSIC SERIES POWER CONDITIONER SPECIFICATIONS
Maximum Output Current: 10 amps.
Pull-out Lights: Two multi-LED, dimmable lamps.
BNC Socket with Switch: Rear rack lamp, 12VAC 500mA maxx. Lamp not included.
Operating Voltage: 180 to 274 VAC.
Spike Protection Mode: Line to neutral, zero ground leakage.
Spike Clamping Voltage: 375 VAC peak @ 3,000 Amps.
Maximum Surge Current: 6,500 Amps.
Noise Attenuation: 10 dB @ 10 kHz, 40 dB @ 100 kHz, 50 dB @ 500 kHz.
Dimensions (mm, WxDxH): 482.6 x 266.7 x 4.45.
Weight: 6 kg.
Power Consumption: 12 watts.
|
Lighting unit for rack 19?. Eight mains outputs (IEC connector) with independent switch and
individual filter. Adjustable lighting level. | A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-10x E in to the top slot of your rack, and the ten switched outlets in the rear panel will power up and protect all your equipment up to a 10-amp load.
SPECIFICATIONS:
Maximum Output Current: |
10 amps |
Line Cord: |
1.5 meter, removable, IEC C-13 female to Schuko male |
Operating Voltage: |
230VAC 50Hz |
Spike Protection Mode: |
Line to neutral |
Energy Dissipation: |
305 joules |
Peak Impulse Current: |
12,000 amps |
Maximum Continuous Opterating Voltage: |
650 Volts |
Noise Attenuation: |
Transverse mode: Greater than 20dB, 1.5Mhz to 200 Mhz |
Dimensions: |
1.75” H x 19” W x 7.5” D |
Weight: |
2.3 kg. |
Safety Agency Listing: |
CE |
Warranty: |
Merit Series units are protected by a limited three year warranty covering defects in materials and workmanship. |
|
Reviews
There are no reviews yet.