Content |
AC Current Capactiy:
Input - 10 Amp capacity required
Output - 10 Amps RMS (both outlets combined)
Linear Noise Attenuation:
> 40 dB @ 100 kHz.
>50 dB @ 500kHz
(Linear attenuation curve from 0.05 to 100 ohms line impedance)
Transient Voltage Surge Suppression:
230 VAC - Series Multi-Stage Protection
Non-Sacrificial with Zero Ground Contamination.
376V peak clamping @ 6000V 3000A input
Extreme Voltage Shutdown (>135 VAC)
Extreme Voltage Shutdown: 275 VAC (Auto-Reset)
Dimensions: 1.75ʼ H x 5ʼ W x 8.5ʼ D
Weight: 3 lbs.
Safety Agency Listing: CE
|
- Rated @ 250 V, 16 A
- 16 x 45° angled outlets
- 8 front and 8 rear outlets with individual on/off switches
- Overload protection
The 874716 provides 16 type F grounded outlets in a 19" aluminum enclosure with permanently attached 2 m cord and angled CEE 7/7 power plug. The 1 U rackmount power strip features individual illuminating on/off switches for the 8 front and rear outlets each plus overload protection with individual circuit breakers and reset buttons.
Product type
19" rack mains socket strips
Type
19" / 1 U
Number of outlets (Earthing contact / IEC 7/4)
2 x 8
Power input
cables
Cable length
2 m
Cable connector
angled , Earthing contact (CEE 7/7)
Cross section
1.5 mm²
Operating voltage
250 V
Max. current
16 A
Cabinet material
Aluminium
Colour
Black
Width
485 mm
Height
44 mm
Depth
126 mm
Special feature
8 x Sockets back side , 8 x Sockets front side , Overload protection for front and rear side , Separate front and rear switches
Weight
1,7 kg
|
The Furman PL-PRO DMC is the latest generation of Furman's 16 amp power conditioners, featuring 8 rear-panel mains outlets and one front-panel mains outlet, Furman's exclusive Series Multi-Stage Protection Plus SMP+ with Linear Filtering Technology LiFT and Extreme Voltage Shutdown EVS for ultra-reliable protection of your gear. The PL-PRO DMC also incorporates a USB port on the front panel to allow for the charging of MP3 players and other such devices that can be recharged via USB.
The Furman PL-Pro DMC power conditioner features dimmable LED rack lights that produce virtually no heat and provide an extremely long lifespan. A rear-mounted BNC jack accepts any standard 12VAC, 0.5A gooseneck lamp for rear rack illumination, as well as a front-panel switch which controls the gooseneck's operation. A front-panel mounted master power switch is protected by a hinged cover, preventing accidental disconnection of AC power to the unit's outlets.
The Furman PL-Pro DMC power conditioner has a front-panel digital voltmeter, and the circuit breaker power switch can be easily reset should the unit be overloaded. Portable music players are becoming a staple on live sound gigs and the PL-PRO DMC includes a front-panel USB port for charging and powering of these devices.
Traditional surge suppression circuits "sacrifice" themselves when exposed to multiple transient voltage spikes, requiring the dismantling of your system, and repair of your surge suppressor. Not so with SMP+. With the Furman PL-PRO DMC's SMP+, damaging transient voltages are safely absorbed, clamped and dissipated. No sacrificed parts, no service calls, no down time.
FURMAN PL-PRO DMC E CLASSIC SERIES POWER CONDITIONER FEATURES
Retractable LED rack lights with on/off/dimmer control.
Isolated outlet banks to minimize inter-component interference and noise contamination.
BNC back panel connector for gooseneck lamp with front-panel switch.
Maintenance-free surge suppression thanks to Series Multi-Stage Protection Plus (SMP+) circuit with extreme voltage shutdown.
8 rear-panel outlets and one front-panel outlet.
LED status indicators warn you when voltage is outside of nominal range or when protection has been compromised.
Front panel USB charger for small USB devices.
Three widely spaced outlets accommodate bulky AC power transformers.
LiFT Linear Filtering Technology with zero ground contamination.
Advanced EVS circuitry detects dangerous voltage irregularities and safely powers down itself and connected equipment in unsafe conditions.
Segmented LED Voltmeter monitors and displays incoming line voltage.
16 amp rating, with high-inrush thermal circuit breaker for added protection.
Two, pull out multi-LED, dimmable lamps.
One rack unit space.
FURMAN PL-PRO DMC E CLASSIC SERIES POWER CONDITIONER SPECIFICATIONS
Maximum Output Current: 16 amps.
Pull-out Lights: Two multi-LED, dimmable lamps.
BNC Socket w/Switch: Rear rack lamp, 12VAC 500mA maxx. Lamp not included.
Operating Voltage: 180 to 274 VAC.
Spike Protection Mode: Line to neutral, zero ground leakage.
Spike Clamping Voltage: 375 VAC peak @ 3,000 Amps.
Maximum Surge Current: 6,500 Amps.
Noise Attenuation: 10 dB @ 10 kHz, 40 dB @ 100 kHz, 50 dB @ 500 kHz.
Dimensions (mm, WxHxD): 482.6 x 266.7 x 4.45.
Weight: 6 kg.
Power Consumption: 12 watts.
| A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-10x E in to the top slot of your rack, and the ten switched outlets in the rear panel will power up and protect all your equipment up to a 10-amp load.
SPECIFICATIONS:
Maximum Output Current: |
10 amps |
Line Cord: |
1.5 meter, removable, IEC C-13 female to Schuko male |
Operating Voltage: |
230VAC 50Hz |
Spike Protection Mode: |
Line to neutral |
Energy Dissipation: |
305 joules |
Peak Impulse Current: |
12,000 amps |
Maximum Continuous Opterating Voltage: |
650 Volts |
Noise Attenuation: |
Transverse mode: Greater than 20dB, 1.5Mhz to 200 Mhz |
Dimensions: |
1.75” H x 19” W x 7.5” D |
Weight: |
2.3 kg. |
Safety Agency Listing: |
CE |
Warranty: |
Merit Series units are protected by a limited three year warranty covering defects in materials and workmanship. |
| The 6 Amp P-1400 AR E delivers a stable 230 volts of AC power to protect equipment from problems caused by AC line voltage irregularities such as sags, brownouts, or overvoltages - all of which can cause sensitive electronic equipment to malfunction or sustain damage. The P-1400 AR E accepts any input voltage from 188V to 270V and transforms it to a constant output of 230V or 240V (switchable), ±10V. Voltages beyond that range may also be converted to usable levels, depending on the range variance.
Additionally, the P-1400 AR E is a full-featured power conditioner that filters and purifies AC power, reducing line noise and ensuring optimum performance. Not only will your equipment perform better with Furmanʼs Linear Filtering Technology (LiFT), but it will also be fully protected by our exclusive Series Multi-Stage Protection (SMP), and Extreme Voltage Shutdown (EVS). This circuitry provides the highest level of power protection available.
Maximum Current: |
6 amps |
Line Cord: |
Captive AWG, 2.5M black cord with IEC Female to Schuko plug |
BNC Socket w/Switch: |
12VAC 500MA maxx (lamp not included) |
Operating Voltage: |
170 to 274 VAC |
Over-Voltage Shutdown: |
275 VAC Nominal |
Approximate Input Voltage Capture Range: |
174 to 264 VAC |
Spike Protection Mode: |
Line to neutral, zero ground leakage |
Spike Clamping Voltage: |
375 VAC peak @ 3,000 Amps |
Response Time: |
1 nanosecond |
Maximum Surge Current: |
6,500 Amps |
Noise Attenuation: |
10 dB @ 10 kHz, 40 dB @ 100 kHz, 50 dB @ 500 kHz |
Dimensions: |
19” W x 12” D x 1.75” H (483mm W x 305mm D x 45mm H) |
Weight: |
7 kg. |
Power Consumption: |
5 watts |
SPECIFICATIONS:
Maximum Current: |
6 amps |
Line Cord: |
Captive AWG, 2.5M black cord with IEC Female to Schuko plug |
BNC Socket w/Switch: |
12VAC 500MA maxx (lamp not included) |
Operating Voltage: |
170 to 274 VAC |
Over-Voltage Shutdown: |
275 VAC Nominal |
Approximate Input Voltage Capture Range: |
174 to 264 VAC |
Spike Protection Mode: |
Line to neutral, zero ground leakage |
Spike Clamping Voltage: |
375 VAC peak @ 3,000 Amps |
Response Time: |
1 nanosecond |
Maximum Surge Current: |
6,500 Amps |
Noise Attenuation: |
10 dB @ 10 kHz, 40 dB @ 100 kHz, 50 dB @ 500 kHz |
Dimensions: |
19” W x 12” D x 1.75” H (483mm W x 305mm D x 45mm H) |
Weight: |
7 kg. |
Power Consumption: |
5 watts |
| Adam Hall Cables 87471 X7
19" Power Strip 1U 7-way with switch & protection cap
- Mountable Power Strip from our 19" PDU range
- With recessed, illuminated switch and protective cap
- 7 Schuko sockets rotated 45°
- With 8-way adjustable mounting brackets
- 1.4 m PVC cable with angled Schuko plug
The practical solution for your 19" rack. Our 87471 X7 with 8-way adjustable stable mounting ears and 7 Schuko sockets comes with a protective cap for the switch. This prevents the power distributor from being switched off accidentally. The cable routing on the side is supplied with a PVC cable (H05VV-F) with 3 x 1.5 mm² inner conductor and an angled Schuko plug.
Product type
19" rack mains socket strips
Number of outlets (Earthing contact / IEC 7/4)
7, Rotated 45°
Cable connector
angled, Earthing contact (CEE 7/7)
Cabinet material
Aluminium, Plastic
Other features
Illuminated on / off switch with protective cap, Mounting brackets can be inserted in 8 positions
|
Reviews
There are no reviews yet.