AC Current Capactiy: 
Input - 10 Amp capacity required
Output - 10 Amps RMS (both outlets combined) 

Linear Noise Attenuation: 
> 40 dB @ 100 kHz.
>50 dB @ 500kHz
(Linear attenuation curve from 0.05 to 100 ohms line impedance) 

Transient Voltage Surge Suppression: 
230 VAC - Series Multi-Stage Protection
Non-Sacrificial with Zero Ground Contamination. 
376V peak clamping @ 6000V 3000A input
Extreme Voltage Shutdown (>135 VAC) 

Extreme Voltage Shutdown: 275 VAC (Auto-Reset) 

Dimensions: 1.75ʼ H x 5ʼ W x 8.5ʼ D 

Weight: 3 lbs. 

Safety Agency Listing: CE

The Furman PL-Plus C Power Conditioner protects your valuable equipment from mains power spikes and sags. Advanced Series Multi-Stage Protection Plus SMP+ circuit provides rock-solid, maintenance-free extreme surge suppression with zero ground contamination thanks to Furman Linear Filtering Technology LiFT. The Furman PL-Plus features 8 rear-panel AC mains outlets and one front-panel AC mains outlet, a 10-amp rating with circuit breaker, retractable LED rack lights with on/off/dimmer control, BNC back panel connector for gooseneck lamp with front-panel switch, and a segmented LED voltmeter to monitor and display incoming line voltage. The Furman PL-Plus C fits in one 19-inch rack space.

Traditional surge suppression circuits "sacrifice" themselves when exposed to multiple transient voltage spikes, requiring the dismantling of your system, and repair of your surge suppressor. Not so withFurman SMP+. With the PL-PLUS C's SMP+, damaging transient voltages are safely absorbed, clamped and dissipated. No sacrificed parts, no maintananc, no down time.

Unique to the Furman PL-PLUS C's SMP+ is its clamping voltage. Other designs offer clamping voltages that are well above 375VAC peak, the Furman PL-PLUS C's SMP+ clamps at 375VAC peak, even when tested with multiple 6000VAC - 3000 Amp surges! This unprecedented level of protection is only available with Furman's SMP+ technology.

The Furman PL-PLUS C features LED rack lights which produce virtually no heat and provide an extremely long life. A dimmer control for the rack lights allows the user to adjust the level of illumination or simply switch the lights off. The Furman PL- PLUS C includes a rear mounted BNC jack which accepts any standard 12VAC, 0.5A gooseneck lamp for rear rack illumination, as well as a front panel switch which controls the gooseneck's operation

8 Rear-panel outlets and one front-panel outlet.
10-amp rating with circuit breaker.
Retractable LED rack lights with on/off/dimmer control.
BNC back panel connector for gooseneck lamp with front-panel switch.
Segmented LED voltmeter to monitor and display incoming line voltage.
Multi-stage protection.
Extreme voltage shutdown.
Linear filtering technology.

Furman M10Lx E Power Conditioner form the Merit Series Power Conditioners is the perfect low cost AC power solution for any rack mount system. Install an Furman M10LxE in to the top slot of your rack, and the 10 switched outlets in the rear panel will power up and protect all your equipment up to a 10 amp load. It not only protects anything plugged into it from spikes and surges, but also has a built in AC noise filter to rid the system of RFI / EMI interference.

TheFurman M-10Lx E also features two slide out, swivelling light fixtures to provide discreet illumination of your equipment. A dimmer knob allows the user to adjust the level of illumination. Merit Series units are protected by a limited three year warranty covering defects in materials and workmanship.

Features

• AC Noise filtering to reduce radio frequency and electromagnetic interference (RFI/EMI)
• Spike & surge protection ensures equipment stays safe and your power stays clean
• 10 rear panel outlets, with front panel convenience outlet
• 10 amp rating, with circuit breaker
• Two retractable LED light fixtures with dimmer control for convenient rack illumination
• Three year warranty

Specification

• Maximum Output Current: 10 amps
• Lamps: LED
• Operating Voltage: 230VAC 50Hz
• Spike Protection Mode: Line to neutral
• Peak Impulse Current: 12,000 amps
• Maximum Continuous Operating Voltage: 650 Volts
• Noise Attenuation: Transverse mode: Greater than 20dB, 1.5Mhz to 200 Mhz
• Dimensions (inches, HxWxD): 1.75 x 19 x 7.5
• Weight: 2.3 kg

The 6 Amp P-1400 AR E delivers a stable 230 volts of AC power to protect equipment from problems caused by AC line voltage irregularities such as sags, brownouts, or overvoltages - all of which can cause sensitive electronic equipment to malfunction or sustain damage. The P-1400 AR E accepts any input voltage from 188V to 270V and transforms it to a constant output of 230V or 240V (switchable), ±10V. Voltages beyond that range may also be converted to usable levels, depending on the range variance.

Additionally, the P-1400 AR E is a full-featured power conditioner that filters and purifies AC power, reducing line noise and ensuring optimum performance. Not only will your equipment perform better with Furmanʼs Linear Filtering Technology (LiFT), but it will also be fully protected by our exclusive Series Multi-Stage Protection (SMP), and Extreme Voltage Shutdown (EVS). This circuitry provides the highest level of power protection available.

SPECIFICATIONS:

Adam Hall Cables 87471

19" Power Strip 1U 8-way with switch

• Illuminated 2-pole switch on the front panel
• 8 mains outlets on the rear panel
• Black aluminium housing
• 54 mm deep
• 19 "angle can be mounted in four positions