Content |
Genelec 7060B Active Subwoofer is powerful and precise bass monitoring tool for modern 6.1 or 5.1 channel Surround Sound or traditional stereo systems.
With its 19 Hz lower cut-off frequency, high sound pressure output capability and versatile bass management systems, it can be adapted to all low frequency monitoring situations.
The amplifier unit integrated into the cabinet contains active crossover filters, driver overload protection circuits and power amplifiers.
The in-built bass management unit has six signal input and output channels, summed signal output connectors and LFE input equipped with a selectable 85/120 Hz lowpass filter and a 0 / +10dB LFE sensitivity switch.
| 108 dB | | Main 19 - 85 Hz (± 3 dB)
LFE 19 - 120 Hz (± 3 dB) | | 0 to -270° (90° steps) | | 10" Active | | 120 W | | H x W x D 527 x 462 x 363 mm | | 26 Kg (57 lb) | | 6.1 XLR analog in
6 x XLR analog out
1 x XLR Link out |
|
The Sub6 is a large volume cabinet design, equipped with an 11" woofer and a rear laminar port. This configuration guarantees bass linearity whatever the intended SPL. The control board is extremely versatile, with connectivity which allows a 2.1, 2.2 and multichannel use via the L/R inputs and outputs and the LFE. The numerous settings such as the high-pass crossover dedicated to monitors, the adjustable phase and level control provide optimum coupling with the Solo6 Be and the Twin6 Be monitors. And finally, a small, but important point: the footswitch input. It enables one to connect a pedal to deactivate the subwoofer and the high-pass crossovers on the outputs that supply the monitors. This simplifies and greatly improves control during the different stages in monitoring.
Specifications Frequency response : | 30Hz - 250Hz | Maximum SPL : | 116dB SPL (peak @ 1m) |
Input :
|
Right, left, LFE
Electronically balanced, 10 kOhms
XLR 3 points socket
Adjustable
| Outputs (towards speakers) : | Type/Impedance: Electronically balanced / 50 Ohms - Connector: XLR 3 points plug |
Amplification :
|
350W rms, BASH® technology
|
Signal internal treatment :
|
Subwoofer section: Mono right/left summation
LFE + mono low-pass
24dB/octave
Phase adjustment
Polarity selection switch
Switch high-pass filter, cut-off frequency selection
Speaker section : 24 dB / octave
|
Electric supply :
|
Local supply wire: 230V (1.6A fuse)
or 115V (3.5A fuse)
Connection: removable IEC supply wire
|
Visualization and control :
|
Adjustable subwoofer level
Low-pass cut-off frequency setting
Phase adjustment
Polarity adjustment
Subwoofer switch (mute)
2.1 "Bypass" (external remote contol)
High-pass frequency selection
Releasable high-pass
| warning light : | Power on LED, Subwoofer switch (mute), Released high-pass |
Electric supply :
|
Local supply wire: 230V (1.6A fuse)
or 115V (3.5A fuse)
Connection: removable IEC supply wire
| Subwoofer : | 11W7670, 10-5/8" (27cm) Focal "W" composite sandwich cone driver | Box : | 7-1/2" (19mm) MDF panels |
Finish :
|
Dark red natural veneering side panels, black body.
| Dimensions (HxWxD) : | 14-15/16 x 13-9/16 x 17-5/16 " (380 x 344 x 440mm) | Weight : | 50.7lb (23kg) |
|
7" Subwoofer
Our range of Subwoofers follows our policy of using only high quality components. This has enabled us to bring the best possible products to the market place. We have paid the highest attention to properly extend the frequency range of our speakers and have put even more care into our subwoofer designs. Not only care, but also a lot of testing and abuse.
So you can rest assured that when you buy a TS (ThunderStorm) subwoofer from EVE Audio, you will be getting a first grade product that delivers adequate and precise control over the bass frequencies in your room, without any low-port noise distortion since all TS subwoofers have a passive radiator. Your system will sound as a whole, not just a sum of parts.
All subwoofers feature the powerful accurate and low distortion sound reproduction that is the hallmark of all EVE Audio studio monitors.
Tech Talk
Every ThunderStorm subwoofer has detailed controls like switchable satellite filters (full range and 80Hz), phase switch controls (0°, 180°). and variable subwoofer filter frequencies (60....140Hz) to let you tailor and adjust your ThunderStorm to your specific room.
The TS107 is the smallest model in the range of EVE Audio subwoofers and features a very efficient 100W PWM amplifier that drives a proprietary 6.5" woofer. This guarantees a frequency response of down to 36Hz up to 300 Hz, for a maximum output power of 102 dB (SPL @ 1m).
The included remote control will let you adjust not only the subwoofer's volume but also the complete stereo system's volume while sitting comfortably in your sweet spot.
All in all, the ThunderStorm subwoofers will make any system sound better and more complete.
As with every other EVE Audio subwoofer, you get balanced XLR In- and Outputs (Stereo In and Out, LFE In, LFE/Sub Out) for greater convenience.
Passive Radiator
The particularity of our extremely powerful and accurate subwoofer resides in the passive radiator used that replaces the common bass reflex tube. With this design all audible noise due to air turbulences disappear completely.
Unwanted disturbing pipe resonances (at lambda/2 and multiples) are eliminated, which are unavoidable when applying the principle of a two-sided pipe opening (bass reflex port). The suspension of the passive radiator has a restoring force underneath its tuning frequency and reduces inaudible excursions in the subsonic range. This in turn results in reduced intermodulation distortion in the working range.
The passive radiator allows a particularly low tuning or lower cut-off frequency in a very compact cabinet.
Product | TS107 | Description | Subwoofer | Dimensions (WxHxD) [mm] | 230 x 355 x 300 | Dimensions (WxHxD) [“] | 9.06 x 13.98 x 11.81 | Free-field frequency range (-3dB) | 36Hz - 300Hz | Woofer | 165mm/6.5“ | Maximum SPL @ 1m | 102dB | Number of amplifiers | 1 | Total short-term output power | 100W | Protection limiter | YES | Settings |
| System volume (Satellite & Sub) | -inf. - +6dB | Subwoofer volume | -inf. - +6dB | Level-lock dip switch | YES | Filter-lock dip switch | YES | Input level dip switch | +7dBu/+22dBu | Phase inversion | 0°/180° | Switchable Satellite filter | flat/80Hz | Variable Subwoofer filter | 60Hz-140Hz + LFE | Remote control | Sys. & Sub. Vol. | Connectors |
| XLR in left (impedance) | (10k) | XLR in right (impedance) | (10k) | XLR in LFE (impedance) | (10k) | XLR out satellite left (impedance) | (10k) | XLR out satellite right (impedance) | (10k) | XLR out (LFE) (impedance) | (10k) | Power consumption |
| Standby | | Full output | 120VA | Misc. |
| Weight kg/lb. | 8.2 / 18.1 |
|
10" Subwoofer
Our range of Subwoofers follows our policy of using only high quality components. This has enabled us to bring the best possible products to the market place. We have paid the highest attention to properly extend the frequency range of our speakers and have put even more care into our subwoofer designs. Not only care, but also a lot of testing and abuse.
So you can rest assured that when you buy a TS (ThunderStorm) subwoofer from EVE Audio, you will be getting a first grade product that delivers adequate and precise control over the bass frequencies in your room, without any low-port noise distortion since all TS subwoofers have a passive radiator. Your system will sound as a whole, not just a sum of parts.
All subwoofers feature the powerful accurate and low distortion sound reproduction that is the hallmark of all EVE Audio studio monitors.
Tech Talk
Every ThunderStorm subwoofer has detailed controls like switchable satellite filters (full range and 80Hz), phase switch controls (0°, 180°). and variable subwoofer filter frequencies (60....140Hz) to let you tailor and adjust your ThunderStorm to your specific room.
The TS110 model features a very efficient 250W PWM amplifier that drives a proprietary 10" woofer. This guarantees a frequency response of down to 28Hz, up to 300Hz, for a maximum output power of 108 dB (SPL @ 1m) with plenty of power for most needs.
The included remote control will let you adjust not only the subwoofer's volume but also the complete stereo system's volume while sitting comfortably in your sweet spot.
All in all, the ThunderStorm subwoofers will make any system sound better and more complete.
As with every other EVE Audio subwoofer, you get balanced XLR In- and Outputs (Stereo In and Out, LFE In, LFE/Sub Out) for greater convenience.
Passive Radiator
The particularity of our extremely powerful and accurate subwoofer resides in the passive radiator used that replaces the common bass reflex tube. With this design all audible noise due to air turbulences disappear completely.
Unwanted disturbing pipe resonances (at lambda/2 and multiples) are eliminated, which are unavoidable when applying the principle of a two-sided pipe opening (bass reflex port). The suspension of the passive radiator has a restoring force underneath its tuning frequency and reduces inaudible excursions in the subsonic range. This in turn results in reduced intermodulation distortion in the working range.
The passive radiator allows a particularly low tuning or lower cut-off frequency in a very compact cabinet.
Product | TS110 | Description | Subwoofer | Dimensions (WxHxD) [mm] | 330 x 485 x 430 | Dimensions (WxHxD) [“] | 12.99 x 19.09 x 16.93 | Free-field frequency range (-3dB) | 28Hz - 300Hz | Woofer | 250mm/10“ | Maximum SPL @ 1m | 108dB | Number of amplifiers | 1 | Total short-term output power | 250W | Protection limiter | Yes | Settings |
| System volume (Satellite & Sub) | -inf. - +6dB | Subwoofer volume | -inf. - +6dB | Level-lock dip switch | Yes | Filter-lock dip switch | Yes | Input level dip switch | +7dBu/+22dBu | Phase inversion | 0°/180° | Switchable Satellite filter | flat/80Hz | Variable Subwoofer filter | 60Hz-140Hz + LFE | Remote control | Sys. & Sub. Vol. | Connectors |
| XLR in left (impedance) | (10k) | XLR in right (impedance) | (10k) | XLR in LFE (impedance) | (10k) | XLR out satellite left (impedance) | (10k) | XLR out satellite right (impedance) | (10k) | XLR out (LFE) (impedance) | (10k) | Power consumption |
| Standby | | Full output | 250VA | Misc. |
| Weight kg/lb. | 19.6 / 43.2 |
|
- 8' bass-reflex powered subwoofer delivers low frequencies down to 22Hz
- 22Hz - 150Hz frequency response
- High-power 150W amplifier exclusively designed for low frequencies
- LOW CUT switch, LOW CUT control (80-120Hz) HIGH CUT control (80-120 Hz)
- PHASE switch allow users to set up a subwoofer system with simple connections and no additional equipment
- XLR and TRS phone for outputs and XLR for L and R and EXT SUB
Type |
Studio monitor subwoofer |
Woofer |
8'' |
Midrange |
- |
Tweeter |
- |
Amplifiers Power |
150W |
Input/Output Plugs |
XLR3-31 type (balanced) x2, PHONE (balanced) x2 / Out: XLR3-32 type (balanced) x2 (L&R) |
Frequency Response |
22Hz - 160Hz |
Εqualizer |
Yes (Low cut switch) |
Dimensions (W x H x D) |
300mmx350mmx389mm |
Weight |
12.5kg |
|
Genelec SE7261A Active DSP Subwoofer brings the flexibility and accuracy of room response equalization to smaller production environment. At the heart of the Genelec SETM (Small Environment) DSP loudspeaker system is the SE7261A DSP subwoofer with DSP processing.
The SE7261A DSP subwoofer provides all necessary network connections to the host computer and supply extensive DSP resources through its eight AES/EBU high-passed channels to the 8130A active loudspeakers.
The proprietary GLM.SETMsoftware kit includes a measurement microphone, AutoCalTM function and other key features of the standard GLM software.
| 108 dB | | Main 19 - 100 Hz (± 3 dB)
LFE 19 - 120 Hz (± 3 dB) | | GLM tone controls | | 10“ | | 120 W | | H x W x D 527 x 462 x 363 mm | | 27 Kg (59 lb) | | 4 x XLR digital in
4 x XLR digital out
(8 channels AES/EBU) |
|
Reviews
There are no reviews yet.