| Content |
The FC 3 is a high quality dual capsule condenser microphone, inspired by classical microphone models.
The FC 3 is a very versatile microphone with a wide frequency response and a large dynamic range. It will perform great in the studio or in live sound and broadcast applications.
It´s sound character is similair to vintage microphones and it is well suited to be used with most instruments and voices. Use it on vocals and choirs, acoustic and electric guitars and other fretted instruments, as a drum overhead or room mic and in any other application where you would use a big capsule condenser mic.
The FC 3 is, in spite of it´s low cost, suitable for critical recording applications.
The FC 3 comes with a spider style shock mount. |
- Polar pattern: Cardioid
- Switchable -10dB PAD
- Frequency response: 20 - 20,000 Hz
- Max. SPL: 140/150 dB (THD = 0.5%)
- Electrical impedance: 200 Ohm
- Requires phantom power
- Diameter: 53 mm
- Length: 162 mm
- Net weight: 320 g
- Colour: Black
- Incl. shock mount
- Highly affordable AKG large-diaphragm microphone technology
- Cardioid polar pattern for multiplicity of vocal and instrument applications
The earlier model C 3000 has had a large fan club in the project studio and home recording worlds for years. For the new C 3000 B, AKG designed a special 1-inch large-diaphragm transducer that closely approximates the vibration performance of top-class studio microphones, but can be made at much lower cost.
Due to its surface area and special capsule tuning, the C 3000 B large-diaphragm transducer produces an exceptionally pleasing, smooth sound. Unlike in the C 3000, the switchable 10-dB preattenuation pad immediately follows the transducer in the signal path, thus increasing the C 3000 B\'s SPL capability by a true 10 dB. Loud sound sources are therefore no problem.
An acoustically optimized cardioid polar pattern makes the C 3000 B an excellent choice for both recording and live sound applications where high gain before feedback is paramount.
| Polar pattern |
cardioid |
| Frequency range |
20 to 20,000 Hz |
| Sensitivity |
25 mV/Pa (-32 dBV) |
| Max. SPL |
140/150 dB (k=0,5%) |
| Equivalent noise level (CCIR 468-3) |
25 dB |
| Equivalent noise level |
14 dB-A |
| Signal/noise ratio (A-weighted) |
80 dB |
| Preattenuation pad |
10 dB, switchable |
| Bass filter |
6 dB/octave below 500 Hz |
| Impedance |
200 ohms |
| Recommended load impedance |
>1000 ohms |
| Supply voltage |
9 to 52 V phantom power to DIN 45596 |
| Current consumption |
|
| Connector |
3-pin XLR |
| Finish |
silver gray |
| Net weight |
320 g / 11.3 oz. |
| Shipping weight |
950 g / 2.1 lbs. |
| Patent(s) |
Electrostatic transducer (Patent no. AT 395.225, DE 4.103.784, JP 2.815.488) |
|
NT2000 - ?Explore, Control, Create?? Seamlessly Variable Dual 1? Condenser Microphone.
The world's first large diaphragm condenser studio microphone with seamlessly variable Polar
Patterns, Filter and Pad located conveniently on the microphone body. The NT2000?s state of
the art surface-mount electronics combined with the new Australian designed and manufactured
HF1 Capsule, provide extremely low self-noise (7 dBA) and a maximum SPL of 147 dB (157 dB
with pad fully engaged) ensuring exceptional results and the ultimate in recording creativity.
The NT2000 is supplied with the SM2 Shock Mount, together in a durable custom carry case.
SPECIFICATIONS:
Acoustic principle:
Externally polarised 25 mm (1?) dual diaphragm condenser
Directional pattern: Multipattern
Frequency range: 20Hz - 20KHz
Output impedance: 200 ohms
Signal noise ratio din iec 651: 87 dB (1kHz rel 1Pa)
Equvalent noise: 7 dBA SPL (per IEC651, IEC268-15)
Maximum spl:
147 dB (@ 1% THD into 1K ohm) 157dB (@ 1% THD into 1K ohm) with pad set to maximum
Sensitivity:
-36 db re 1 Volt/Pasca (16 mv @94db SPL) +/- 2 dB
Dynamic range din iec 651: 140 dB (per IEC651, IEC268-15)
Power supply voltage: Phantom P48
Weight without battery: 831 gm
Weight with battery: 2.6 kg
| Behringer C-2 2 Matched Studio Condenser Microphones
2 Matched Studio Condenser Microphones
- 2 matched condenser microphones for stereo studio recording and live applications
- Ideal as main and support microphones for studio and live applications
- Cardioid pickup pattern for effective feedback elimination
- Low-mass diaphragm for ultra-wide frequency response and ultimate sound reproduction
- Switchable low-frequency roll-off and input attenuation
- Ultra low-noise transformerless FET input eliminates low-frequency distortion
Excellent Source Isolation
Our C-2 mics also feature a low-frequency rolloff switch to eliminate infrasonics (mic handling noise, sound created by creaky stages), as well as a switchable -10 dB input pad to accommodate hot signals, such as a really loud vocalist or overzealous cellist.
The cardioid pickup pattern provides unparalleled sound source separation and feedback rejection. C-2 mics contain ultra low-noise transformerless FET input circuitry that can handle extreme dynamics with a maximum sound pressure level of 136 dB. So even if the featured performer at your next recording session or live show happens to be a revved-up jet engine, this workhorse mic will not distort!
Sound That Astounds
Every stitch of these mics is designed to deliver beautiful sound. Beginning with the gold-plated 3-pin XLR connector, you get the highest signal integrity.
Once connected to your system, youʼll notice these twin pro-caliber microphones have a 4 dB boost in the 1 kHz - 8 kHz range. For those of you new to condenser mics, this basically means youʼll get a slightly brighter sound that will give the perfect shape to cymbals and overhead miking. Acoustic pianos and choirs also benefit greatly from this type of frequency response.
Excellent Source Isolation
The cardioid pickup pattern provides unparalleled sound source separation and feedback rejection. C-2 mics contain ultra low-noise transformerless FET input circuitry that can handle extreme dynamics with a maximum sound pressure level of 136 dB. So even if the featured performer at your next recording session or live show happens to be a revved-up jet engine, this workhorse mic will not distort!
Our C-2 mics also feature a low-frequency rolloff switch to eliminate infrasonics (mic handling noise, sound created by creaky stages), as well as a switchable -10 dB input pad to accommodate hot signals, such as a really loud vocalist or overzealous cellist.
You Are Covered
We always strive to provide the best possible Customer Experience. Our products are made in our own MUSIC Group factory using state-of-the-art automation, enhanced production workflows and quality assurance labs with the most sophisticated test equipment available in the world.
As a result, we have one of the lowest product failure rates in the industry, and we confidently back it up with a generous 3-Year Warranty program. |
| Acoustical operating principle | Pressure gradient transducer | | Directional pattern | Cardioid | | Frequency range | 20 Hz ... 20 kHz | | Sensitivity at 1 kHz into 1 kohms | 18 mV/Pa | | Rated impedance | 50 ohms | | Rated load impedance | 1000 ohms | | Equivalent SPL CCIR 468-3 | 21 dB | | Equivalent SPL DIN/IEC 651 | 10 dB-A | | S/N ratio CCIR 468-3 | 73 dB | | S/N ratio DIN/IEC 651 | 84 dB | | Maximum SPL for THD 0.5% | 140 dB | | Maximum output voltage | 13 dBu | | Dynamic range of the microphone amplifier DIN/IEC 651 | 130 dB | | Supply voltage | 48 V ± 4 V | | Current consumption | 3 mA | | Matching connectors | XLR 3F | | Weight | 480 g | | Diameter | 49 mm | | Length | 175 mm |
| A/B, X/Y, and M/S stereo recording
Ambience recording
Grand piano, woodwind and brass instruments
Percussions
Drums
Classical music recording
Studio applications
- Back-to-back large-diaphragm multi-pattern transducer
- True condenser technology
- High sensitivity and 155 dB maximum SPL capability
- Switchable 20 dB preattenuation pad
- Switchable bass cut filter
- Legendary, pristine AKG sound quality
- Complete with spider-type shock mount and aluminium carrying case
| Type |
Dual-capsule,1-inch large-diaphragm, true condenser pressure-gradient microphone |
| Polar pattern |
Cardioid, omnidirectional, figure-eight |
| Frequency range |
20 to 20,000 Hz |
| Sensitivity |
28 mV/Pa (-31 dBV) |
| Max. SPL |
135/155 dB SPL (0/-20 dB) for 0.5% THD |
| Equivalent noise level |
16 dB-A (IEC 60268-4) |
| Signal/noise ratio (A-weighted) |
78 dB |
| Preattenuation pad |
0 dB, -20 dB |
| Bass filter |
12 dB/octave, 300 Hz |
| Impedance |
=1000 ohms |
| Current consumption |
|
|
Reviews
There are no reviews yet.