Content |
JTS CM-501 Lavalier Condenser Microphone
Electret lavalier microphone
This microphone is cut out for presentations and discussions. It guarantees good audibility
a secure fit due to the supplied tie clip, and is quickly to install. The cartridge design of cardioid
characteristic allows to pick up a precise voice of high quality over a wide dynamic range.
Supplied with windshield.
Features:
System electret/cardioid
Frequency range 100-15,000Hz
Impedance 2.2kΩ
Sensitivity 3.2mV/Pa/1kHz
Max. SPL 130dB
Power supply pocket transmitter
PT series or PS-500
Connections cable with 4-pole mini XLR
Weight 20g
|
Low-profile, cost efficient clip-on microphone for applications including houses of worship, lecturers, etc. Connects to AKG bodypack transmitters. The CK 99 L provides a natural sound, with a slight rise above 10 kHz for added clarity. Its cardioid polar pattern and bass rolloff combine to suppress unwanted ambient noise. Hide and speak for house-of-worship, conference and theater applications The CK99 L is a condenser lavalier microphone with cardioid polar pattern. It provides a natural sound, with a slight rise above 10kHz for added clarity, perfect for applications in houses of worship, lectures and theaters. Thanks to its small housing and the included durable metal clip, it can be inconspicuously and securely mounted on jackets and costumes. The CK99 L provides a professional three-pin mini XLR connector that fits the body pack transmitters of all AKG wireless microphone systems. Cardioid polar pattern eliminates noise from the rear 125° pickup angle for inexperienced or very vivacious talkers Small housing and durable metal clip for inconspicuous, secure mounting Technical Specification General | Audio Frequency bandwidth | 15 to 18000 Hz | Sensitivity | 8.8 mV/Pa | Equivalent Noise Level | 34 dB-A | Signal to Noise | 60 dB-A | Electrical Impedance | 200 Ohms | Recommended Load Impedance | 2000 Ohms | | Polar Patterns | Cardioid | | | Powering Interface | Voltage | 1.5 to 10 V | Current | 2 mA | | Audio Output | Type | Mini XLR | Gender | Female | Contacts | 3-pin | | Design | | Dimensions / Weight | Height | 23 mm | Diameter | 8 mm | Net Weight | 2.5 g | |
|
The e 608 is a super-cardioid microphone ideal for almost invisible clip-miking
of woodwind (except certain Flutes), brass and drums. A newly developed clamp
and gooseneck mounting enables the capsule to be positioned close to the signal
source for high realism and high-level output.
Features
Rugged reinforced glass-fibre body
Shock-mounted capsule provides low sensitivity to impact and handling noise
Hum compensating coil
Extremely robust connection cable with XLR connector
Delivery Includes
1 e 608
1 microphone clip
1 pouch
Technical Data
Frequency Response 40.....16000 Hz
Sensitivity in free field, no load (1kHz) 0,8 mV/Pa
Min. terminating impedance 1000 Ohm
Dimensions d 17 x 185 mm
Weight w/o cable 20 g
|
Shure SLX14 Instrument Wireless System Features:
SLX4 Wireless Receiver:
Automatic Frequency Selection
Automatic Transmitter Setup
960 Selectable frequencies across 24MHz bandwidth
Detachable 1/4 wave antennas
Microprocessor-controlled diversity
RF presence LED
5-segment audio meter
Multi-function, backlit LCD
Low battery indicator
Frequency and power lockout
Rugged metal chassis
Volume control on rear of unit
1/2 rack design
Furnished rack hardware
Non-slip bumpers for use out of rack
XLR and 1/4" outputs
SLX1 Bodypack Transmitter
Automatic Transmitter Setup
Backlit LCD with timeout feature
Frequency and power lockout
3-segment battery fuel gauge
2 AA batteries (included) provide 8 hours of continuous use
518 - 782 MHz operating range
Shure SLX14 Instrument Wireless System Specifications:
SLX4 Wireless Receiver:
Audio Output Level (ref. ± 38kHz deviation with 1kHz tone): XLR connector (into 600 Ohm load): —13dBV; 1/4" connector (into 3000 Ohm load): —2dBV
Output Impedance: XLR connector: 200 Ohms; 1/4" connector: 1kohms
XLR output: Impedance balanced; Pin 1: Ground; Pin 2: (+); Pin 3: (-)
Sensitivity: —105 dBm for 12 dB SINAD, typical
Image Rejection: >70 dB, typical
Power Requirements: 12—18 Vdc at 150 mA, supplied by external power supply
Operating Range Under Typical Conditions: 300 ft. (100m)
Note: Actual range depends on RF signal absorption, reflection, and interference
Audio Frequency Response (+/— 2 dB): Minimum: 45 Hz: Maximum: 15 kHz
Note: Overall system frequency depends on microphone element.
Total Harmonic Distortion (ref. +/— 38 kHz deviation, 1 kHz tone): 0.5%, typical
Dynamic Range: >100 dB A-weighted
Operating Temperature Range: —18 degree C (0 degree F) to +50 degree C (+122 degree F)
Note: battery characteristics may limit this range
Dimensions (H x W x D): 1.65 x 7.76 x 5.28 in., (42 x 197 x 134 mm)
Weight: 1 lb. 13 oz. (816 g )
Housing: Galvanized steel
Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with
respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output.
Logic Connections: Pin 1: Logic output, Transmitter Mute Status. Mute=low (0 V). Sinks up to 100 mA. Absolute maximum -0.7 to 5.5V DC; Pin 2: Logic ground; Pin 3: Logic output, Battery Status. Good=low (0 V). Sinks up to 100 mA; Absolute maximum -0.7 to 5.5V DC
SLX1 Bodypack Transmitter
Audio Input Level: -10 dBV maximum at mic gain position, +10 dBV maximum at 0 dB gain position, +20 dBV maximum at -10 dB gain position
Gain Adjustment Range: 30dB
Input Impedance: 1 Mohms
RF Transmitter Output: 30 mW maximum (dependent on applicable country regulations
Dimensions (H x W x D): 4.25 x 2.50 x 0.75 in. (108 x 64 x 19 mmD)
Weight: 81 grams (3 oz.) without batteries
Housing: Molded ABS case
Power Requirements: 2 "AA" size alkaline or rechargeable batteries
Battery Life: >8 hours (alkaline)
|
Lavaliere Microphone for WS 100 BP Belt Pack and for WS 1616 BP Belt Pack - Uni-directional Electret Condenser Lavaliere Microphone
- Impedance
- Frequency range : 20 Hz – 20 KHz
- Sensitivity : -44 ± 2 dB (at 1 KHz)
Product type
Wireless Microphone System Accessories
Type
Microphones
Frequency response
20 - 20.000 Hz
Directivity
cardioid
Nominal impedance
680 Ohm(s)
Phantom power requierements
5 V
Microphone input
mini-XLR (3-pin, female)
Accessories (included)
attaching clip , Foam windscreen
Weight
0,04 kg
|
Shure cable with base WL180N fits with R183/184/185 |
Reviews
There are no reviews yet.