MARSHALL PEDL-91004 Double Footswitch

• Modulation, Delay and Reverb effects on/off
• Modulation and Delay tap tempo
• Full Looper functionality
• Effects Loop on/off
• Super Widestereo on/off
• Noise Gate on/off

 User's manual [1,27 MB]

The Palmer PEABI is more than a simple switcher for two sources; simultaneously, the PEABI also handles level adjustment for various sources. Whether microphone or line signal, the PEABI toggles silently between the two inputs and thus permits fast and simple comparison between signals or connection of various sources to one input. Three slide switches make it possible to select various attenuation levels (6, 15 or 21 dB attenuation) individually for both inputs. A ground lift helps to avoid ground loop hum. Housed in a solid metal case with extended edges for optimum protection of the in- and outputs. A red LED clearly indicates which input is currently active. Pre-drilled holes permit simple and secure mounting in a rack or on a pedal board. The PEABI's strictly passive circuitry means that it requires no power supply at all. A 9-volt block battery is required to power the LED.

• Product type: switcher
• Type: passive
• Switch function: Input switcher
• Number of channels: 2
• Number of Inputs: 2
• Input connections: XLR
• Number of outputs: 1
• Output connections: XLR
• Outputs transformer balanced: no
• Controls: Groundlift, Input PAD
• Indicators: Channel number
• Power Supply: 9-V block battery
• Case Material: Sheet steel
• Case surface: Powder coated
• Dimensions (W x H x D): 100 mm x 60 mm x 120 mm

• Function on/off
• Without LED
• 5m cable
• Screwed steel housing
• Kink protection and cable feed-through
• Mono jack
• “Channel" label
• Suitable for all amplifiers with simple on/off switch
• Dimensions: 84 x 45 x 112 mm
• Compatible with: Marshall DSL50, DSL100, DSL401, EL34 50/50, EL34 100/100, EL84 20/20, MB30, MB60, MB150, G30RCD, G50RCD, G80RCD, G100RCD, JCM600, JCM601, JCM602, JTM612, JTM60, JTM622, JTM610, JTM615, MG30DFX, JTM312, JTM310, VS30R, 1962, 2555SL, 2100, 2500, 7400, 7200, 72115, 72410, 9100, 9200, 8040, 3520, 5522, 9004

Designed to work with: ID:Core Stereo 20, ID:Core Stereo 40, ID:Core Stereo 40H and ID:Core BEAM, Connect a Blackstar FS-11 footcontroller (not supplied) to control your ID:Core in one of the following modes: In Alternative Mode (selected via INSIDER) patches will cycle on a ʻloopʼ. e.g. switching up from Bass 2 will move to Clean Warm. When in Manual Mode, the effect of any footcontroller switch will depend on its last state. Pressing Switch 1 will return the amplifier to Patch Mode. Pressing Switch 2 will toggle the effects off and on without returning to Patch Mode.