Content | Master Audio MA826 Outdoor Rock style Speaker 6,5'' 30W - 100V Waterproof
WATERPROOF speaker pair 8 Ohms / 100 Volts
Speaker: 6,5" FULLRANGE
RMS power: 30W (8 Ohms / 100V)
Frequency range: 80Hz-16,000Hz
SPL(@1W/m): 92 dB
Dimensions: 430 x 340 x 270 mm.
Cabinet: ABS
Guaranty: 1 year |
| - SYSTEM POWER CONTROL You can control the power of your system by using this model. - AC AND DC POWER SUPPLY You can distribute AC and DC power through the AC outlet and DC terminals on the rear panel. - USE OF EMERGENCY POWER SUPPLY For emergency equipment power supply, an extra DC terminal is provided. - REMOTE CONTROL You can control the system power by remote control function even though the power switch on front is off. - AC AND DC VOLT METER This model uses digital volt meter displays of AC and DC. - OPERATING MODE DISPLAY You can easily check the operating mode by LEDs, AC or DC operating and emergency power. | | | | | PD-659 | AC Outlet | Switched 2000W ⅹ3 | Unswitched 700W ⅹ1 | Remote Control | 1 | DC Power Output | DC 24V 5A | Operation Temperature | -10℃~+40℃ | Power Source | 100-120VAC or 220-240VAC; 50/60Hz (Supplied ACmains transformer depends on country requirements) | Power Consumption | 190W | Weight(SET) | 6.2Kg/13.6Ib | Dimension(SET) | 482(W) x 88(H) x 380(D)mm/19(W) x 3.5(H) x 15(D)in | ※ Specifications and design subject to change without notice. | | | |
|
Specifications Frequency Response (at 1 watt into 4 ohms, 20Hz - 20 kHz) |
+0/–1 dB
| Signal to Noise Ratio (below rated 8-ohm power at 1 kHz, A-weighted) |
100 dB
| Damping Factor (8 ohm): 20 Hz to 400 Hz |
> 500
| Input Stage |
Input is electronically balanced and employs
precision 1% resistors
| AC Line Current |
CDi 1000: 11.50A, CDi 2000: 11.93A, CDi 4000: 11.75A
At idle: Draws no more than 45 watts.
| Crosstalk (below rated power) 20 Hz to 1 kHz |
> 70 dB
| Input Impedance (nominal) |
20 kilohms balanced, 10 kilohms unbalanced
| Load impedance (note: safe with all types of loads)
Dual
Bridge mono |
2–8 ohms
4–16 ohms
| Voltage Gain (at 1 kHz, 8 ohm rated output) |
CDi 1000: 30.5 dB, CDi 2000: 32.9 dB, CDi 4000: 34.2 dB
| Sensitivity (at 8 ohm rated output) |
1.4V
| Maximum Input Signal |
+22 dBu typical
| Operating Temperature |
0° C to 40° C at 95% relative humidity (non-condensing)
| AC Line Voltage and Frequency Configurations Available (± 10%) |
100V, 120V-240V, 50/60 Hz
| Ventilation |
Flow-through ventilation from front to back
| Cooling |
Heat sinks and proportional-speed fan
| Dimensions: Width, Height, Depth (behind mounting surface) |
EIA Standard 19 in. W (EIA RS-310-B)
x 3.5 in. (8.9 cm) H x 12.25 in. (31.1cm) D
| Net Weight, Shipping Weight |
19 lb (8.6kg), 22 lb (10.0 kg)
| |
XB Series - Intelligent Power
Power Without Compromises. The XV is designed for paging, music and alarm signals. Versatile, dynamic and extremely rugged according to IEC286-3. For the highest requirements in safety and quality. Sequential power on, alive contacts and incorporated ground fault detection - the XV is the solution under all conditions. Without the need for additional equipment. For uninterrupted and troublefree operation. Needless to say that the Bittner High-End toroidal output transformers in the XV series are some of the best available.
High Tech SMT Design Protection Circuits: DC, LF, HF, Thermal, Short Circuit, Current Limiter, 3 ms Muting Delay PHOENIX High-End Toroidal Output 100V Transformers Ground Fault Detection LED Indicators for POWER, SIGNAL, CLIP, PROTECT, GNDFAULT Temperature controlled, variable speed low noise fans Volume Controls at the back Stereo / Bridged / Parallel Mode Softstart Sequential Remote Power On Alive Contact Ground Lift 3 Years Warranty
TECHNICAL DATA: XV 1000: 2x500 W/100 V Class: AB Frequency Response: 20 Hz - 20 kHz (0 / -0.3 dB) THD: < 0.07% Signal-to-Noise Ratio: < 101 dB Channel Seperation: > 70 dB Input Sensitivity: +6 dBu Input Clipping: 22 dBu Input Impedance: 20 kOhm Cooling: 2 to 3 fans (temp. reg. variable speed) Weight: 33 kg Dimensions: 2 RU / 483 x 88 x 382 mm (19" x 3.5" x 15“) |
- Weatherproof IP56 outdoor speaker
- 5.25" woofer
- 1.2" high-frequency driver
- 40 watts continuous power
- Frequency range up to 15 kHz
- Operated at 8 ohms and 100 volts
- For gardens, parks etc.
The Contractor COGS 52 is a rugged outdoor speaker in army green with an IP56 rating. It is operated at 8 ohms and 100 volts with taps for 2, 4, 8, 16 and 32 watts and is equipped with a 5.25" woofer and 1" tweeter. It achieves a sound pressure level of 86 dB at 1 W / 1 m with a power capacity of 40 watts of continuous power.
Product type
Installation Loudspeakers
Type
Outdoor Loudspeaker
Version
Outdoor Loudspeaker
Speaker type
2-way speaker
Colour
Army green
Woofer dimensions
5.25 "
Woofer size
133 mm
Tweeter dimensions
1.2 "
Tweeter dimensions (mm)
30 mm
Mounting depth
74 mm
Impedance (low-impedance)
8 Ohm(s)
100 V Inputs
16 W , 2 W , 32 W , 4 W , 8 W
Frequency response
80 - 15000 Hz
Height
372 mm
Diameter
345 mm
Weight
3,88 kg
| Max Power : 20W
Frequency Resp. : 200-20000Hz
Sensitivity : 88dB
Impedance : 100V / 8OHM
SPEAKER : 2,5“
Dimensions (WHD) : 96x139x139mm |
Reviews
There are no reviews yet.