Content |
E616A
Two-way activefull-range with DSP. 650 W.
2 x 6” woofers DʼAppolito config.
2.5” driver, 80° x 60° dispersion.
500 W + 150 W class-D power amplifier.
Optional: LD2.4 USB interface for remote PC connection
|
The SW10 STUDIO subwoofer has been designed specifically for optimum matching with the MSP series powered monitor speakers. Combined with MSP7 STUDIO or MSP5 STUDIO speakers in a stereo of surround system it can provide a seamlessly extended low end for accurate ultra wide range monitoring. A comprehensive selection of inputs and outputs as well as a phase switch and continuous high-cut and level controls make it easy to achieve optimum performance in any room and system. Whether you're simply mixing basic stereo programs or authoring DVD audio in full surround, MSP STUDIO series speakers plus an SW10 STUDIO will give you the ultimate monitoring experience.
GENERAL Type Powered Subwoofer
Crossover Frequency -
Overall Frequency Response 25Hz - 150Hz (-10dB)
Maximum Output Level 111dB, 1 m on Axis
Dimensions (W x H x D) 328 x 459 x 476 mm
Weight 26.5 kg
Magnetic Shielding Yes (Non-covered type)
SPEAKER SECTION Components LF 10" cone
HF -
Enclosure Type Bass-Reflex
Material MDF
AMPLIFIER SECTION Output Power * LF 180W
f = 100Hz, THD = 1%, RL = 8O
HF -
S/N, IHF-A filter > 100dB, LEVEL = Max
Input Sensitivity XLR-3-31 +4 dBu, LEVEL = Center
-6 dBu, LEVEL = Max
PHONE -
Input Connectors, Impedance XLR-3-31 (balanced), 10 kO
Output Connectors XLR-3-32 x 3 (balanced),
parallel connection with Input
Controls LEVEL control Center Click VR
(Min = -8 Attenuation)
LOW CUT switch -
HIGH TRIM -
LOW TRIM -
POWER SWITCH on/off
PHASE SWITCH Normal/Reverse
LPF control 40-120 Hz, 80 Hz at Center Click
Indicators LED Green: Power On
Red: Clipping
Power Consumption 160W
* These specifications apply to rated power supplies of 100, 120, 230 and 240 V.
* Specifications and appearance subject to change without notice.
|
The Genelec 5040B is an extremely compact active subwoofer designed to complement up to five 6010B's with accurate and dynamic bass response reaching down to 35 Hz. Matched perfectly with the 6010B's, the 5040B conveniently features a remote volume control allowing adjustment of the entire sound system as well as versatile acoustic controls for perfect room integration.
Our Intelligent Signal Sensing (ISS) feature, reduces power consumption to less than 0.5 watts by automatically switching the active monitor to standby, when no audio signal has been detected for some time. When it receives an audio signal again, the loudspeaker turns back on.
ISS is fully compliant with the latest EU requirements and the ErP 2013 Directive for electronic devices.
Designed by Genelec's R&D team in co-operation with internationally acclaimed Finnish designer Harri Koskinen, the 5040B subwoofer features an unobtrusive, modern appearance.
The 5040B features a magnetically shielded downward firing 6 1/2" bass driver attached to a die-cast aluminium base plate.
The base plate also serves as the chassis for the 40 Watt amplifier and crossover filter circuitry. The 5040B packs a respectable punch of 98 dB maximum sound pressure level
| 98 dB | | Main 35 - 85 Hz (± 3 dB)
LFE 35 - 120 Hz (± 3 dB) | | 0 to -270° (90° steps) | | 6.5" Active | | 40 W | | H x D 251 x 305 mm | | 6.3 Kg (13.9 lb) | | 5.1 RCA analog in
1 x 3.5 mm stereo jack in
5 x RCA analog out |
|
12" Subwoofer
Our range of Subwoofers follows our policy of using only high quality components. This has enabled us to bring the best possible products to the market place. We have paid the highest attention to properly extend the frequency range of our speakers and put even more care into our subwoofer designs. Not only care, but also a lot of testing and abuse.
So you can rest assured that when you buy a TS (ThunderStorm) subwoofer from EVE Audio, you will be getting a first grade product that delivers adequate and precise control over the bass frequencies in your room, without any low-port noise distortion since all TS subwoofers have a passive radiator. Your system will sound as a whole, not just a sum of parts.
All subwoofers feature the powerful accurate and low distortion sound reproduction that is the hallmark of all EVE Audio studio monitors.
Tech Talk
Every ThunderStorm subwoofer has detailed controls like switchable satellite filters (full range and 80Hz), phase switch controls (0°, 180°). and variable subwoofer filter frequencies (60....140Hz) to let you tailor and adjust your ThunderStorm to your specific room.
The TS112 is our largest, "no-compromise" subwoofer. The highly efficient PWM amp is capable of 400 W of short term output power. The powerful amp, coupled with a large proprietary 12" woofer will guarantee you a clean frequency response down to 24Hz and up to 300Hz, for a maximum output power of 112 dB (SPL @ 1m). As with the highly efficient TS110, don't let your neighbours see you unloading this subwoofer into your house!
The included remote control will let you adjust not only the subwoofer's volume but also the complete stereo system's volume while sitting comfortably in your sweet spot.
All in all, the ThunderStorm subwoofers will make any system sound better and more complete.
As with every other EVE Audio subwoofer, you get balanced XLR In- and Outputs (Stereo In and Out, LFE In, LFE/Sub Out) for greater convenience.
Passive Radiator
The particularity of our extremely powerful and accurate subwoofer resides in the passive radiator used that replaces the common bass reflex tube. With this design all audible noise due to air turbulences disappear completely.
Unwanted disturbing pipe resonances (at lambda/2 and multiples) are eliminated, which are unavoidable when applying the principle of a two-sided pipe opening (bass reflex port). The suspension of the passive radiator has a restoring force underneath its tuning frequency and reduces inaudible excursions in the subsonic range. This in turn results in reduced intermodulation distortion in the working range.
The passive radiator allows a particularly low tuning or lower cut-off frequency in a very compact cabinet.
Frequency response curve
Product | TS112 | Description | Subwoofer | Dimensions (WxHxD) [mm] | 390 x 560 x 508 | Dimensions (WxHxD) [“] | 15.35 x 22.05 x 20 | Free-field frequency range (-3dB) | 24Hz - 300Hz | Woofer | 300mm/12“ | Maximum SPL @ 1m | 112dB | Number of amplifiers | 1 | Total short-term output power | 400W | Protection limiter | Yes | Settings |
| System volume (Satellite & Sub) | -inf. - +6dB | Subwoofer volume | -inf. - +6dB | Level-lock dip switch | Yes | Filter-lock dip switch | Yes | Input level dip switch | +7dBu/+22dBu | Phase inversion | 0°/180° | Switchable Satellite filter | flat/80Hz | Variable Subwoofer filter | 60Hz-140Hz + LFE | Remote control | Sys. & Sub. Vol. | Connectors |
| XLR in left (impedance) | (10k) | XLR in right (impedance) | (10k) | XLR in LFE (impedance) | (10k) | XLR out satellite left (impedance) | (10k) | XLR out satellite right (impedance) | (10k) | XLR out (LFE) (impedance) | (10k) | Power consumption |
| Standby | | Full output | 410VA | Misc. |
| Weight kg/lb. | 25.5 / 56.2 |
|
10" Subwoofer
Our range of Subwoofers follows our policy of using only high quality components. This has enabled us to bring the best possible products to the market place. We have paid the highest attention to properly extend the frequency range of our speakers and have put even more care into our subwoofer designs. Not only care, but also a lot of testing and abuse.
So you can rest assured that when you buy a TS (ThunderStorm) subwoofer from EVE Audio, you will be getting a first grade product that delivers adequate and precise control over the bass frequencies in your room, without any low-port noise distortion since all TS subwoofers have a passive radiator. Your system will sound as a whole, not just a sum of parts.
All subwoofers feature the powerful accurate and low distortion sound reproduction that is the hallmark of all EVE Audio studio monitors.
Tech Talk
Every ThunderStorm subwoofer has detailed controls like switchable satellite filters (full range and 80Hz), phase switch controls (0°, 180°). and variable subwoofer filter frequencies (60....140Hz) to let you tailor and adjust your ThunderStorm to your specific room.
The TS110 model features a very efficient 250W PWM amplifier that drives a proprietary 10" woofer. This guarantees a frequency response of down to 28Hz, up to 300Hz, for a maximum output power of 108 dB (SPL @ 1m) with plenty of power for most needs.
The included remote control will let you adjust not only the subwoofer's volume but also the complete stereo system's volume while sitting comfortably in your sweet spot.
All in all, the ThunderStorm subwoofers will make any system sound better and more complete.
As with every other EVE Audio subwoofer, you get balanced XLR In- and Outputs (Stereo In and Out, LFE In, LFE/Sub Out) for greater convenience.
Passive Radiator
The particularity of our extremely powerful and accurate subwoofer resides in the passive radiator used that replaces the common bass reflex tube. With this design all audible noise due to air turbulences disappear completely.
Unwanted disturbing pipe resonances (at lambda/2 and multiples) are eliminated, which are unavoidable when applying the principle of a two-sided pipe opening (bass reflex port). The suspension of the passive radiator has a restoring force underneath its tuning frequency and reduces inaudible excursions in the subsonic range. This in turn results in reduced intermodulation distortion in the working range.
The passive radiator allows a particularly low tuning or lower cut-off frequency in a very compact cabinet.
Product | TS110 | Description | Subwoofer | Dimensions (WxHxD) [mm] | 330 x 485 x 430 | Dimensions (WxHxD) [“] | 12.99 x 19.09 x 16.93 | Free-field frequency range (-3dB) | 28Hz - 300Hz | Woofer | 250mm/10“ | Maximum SPL @ 1m | 108dB | Number of amplifiers | 1 | Total short-term output power | 250W | Protection limiter | Yes | Settings |
| System volume (Satellite & Sub) | -inf. - +6dB | Subwoofer volume | -inf. - +6dB | Level-lock dip switch | Yes | Filter-lock dip switch | Yes | Input level dip switch | +7dBu/+22dBu | Phase inversion | 0°/180° | Switchable Satellite filter | flat/80Hz | Variable Subwoofer filter | 60Hz-140Hz + LFE | Remote control | Sys. & Sub. Vol. | Connectors |
| XLR in left (impedance) | (10k) | XLR in right (impedance) | (10k) | XLR in LFE (impedance) | (10k) | XLR out satellite left (impedance) | (10k) | XLR out satellite right (impedance) | (10k) | XLR out (LFE) (impedance) | (10k) | Power consumption |
| Standby | | Full output | 250VA | Misc. |
| Weight kg/lb. | 19.6 / 43.2 |
|
The Sub6 is a large volume cabinet design, equipped with an 11" woofer and a rear laminar port. This configuration guarantees bass linearity whatever the intended SPL. The control board is extremely versatile, with connectivity which allows a 2.1, 2.2 and multichannel use via the L/R inputs and outputs and the LFE. The numerous settings such as the high-pass crossover dedicated to monitors, the adjustable phase and level control provide optimum coupling with the Solo6 Be and the Twin6 Be monitors. And finally, a small, but important point: the footswitch input. It enables one to connect a pedal to deactivate the subwoofer and the high-pass crossovers on the outputs that supply the monitors. This simplifies and greatly improves control during the different stages in monitoring.
Specifications Frequency response : | 30Hz - 250Hz | Maximum SPL : | 116dB SPL (peak @ 1m) |
Input :
|
Right, left, LFE
Electronically balanced, 10 kOhms
XLR 3 points socket
Adjustable
| Outputs (towards speakers) : | Type/Impedance: Electronically balanced / 50 Ohms - Connector: XLR 3 points plug |
Amplification :
|
350W rms, BASH® technology
|
Signal internal treatment :
|
Subwoofer section: Mono right/left summation
LFE + mono low-pass
24dB/octave
Phase adjustment
Polarity selection switch
Switch high-pass filter, cut-off frequency selection
Speaker section : 24 dB / octave
|
Electric supply :
|
Local supply wire: 230V (1.6A fuse)
or 115V (3.5A fuse)
Connection: removable IEC supply wire
|
Visualization and control :
|
Adjustable subwoofer level
Low-pass cut-off frequency setting
Phase adjustment
Polarity adjustment
Subwoofer switch (mute)
2.1 "Bypass" (external remote contol)
High-pass frequency selection
Releasable high-pass
| warning light : | Power on LED, Subwoofer switch (mute), Released high-pass |
Electric supply :
|
Local supply wire: 230V (1.6A fuse)
or 115V (3.5A fuse)
Connection: removable IEC supply wire
| Subwoofer : | 11W7670, 10-5/8" (27cm) Focal "W" composite sandwich cone driver | Box : | 7-1/2" (19mm) MDF panels |
Finish :
|
Dark red natural veneering side panels, black body.
| Dimensions (HxWxD) : | 14-15/16 x 13-9/16 x 17-5/16 " (380 x 344 x 440mm) | Weight : | 50.7lb (23kg) |
|
Reviews
There are no reviews yet.