Content |
The surface mount CM11B has an Omni-directional pickup pattern that captures sound in a 180 degree pattern. A perfect application would be to place a CM11B microphone in the center of a board room or conference table to pick up everyone in the meeting.
* Surface mount Omni-directional boundary microphone
* Condenser element
* Half Omni Pickup Pattern
* Internal Hi-pass filter
* Mini XLR connector
* Includes 30-foot cable with mini to standard XLR connectors
* 9-52 Volt Phantom Power Operation
* Available in Black and White
|
C 562 CM
Small, low-profile boundary layer microphone Wide frequency range High sensitivity Ideal for inconspicuous installation in a room Suited for surveillance or recording The C 562 CM flush-mount boundary microphone uses the same transducer as the C 562 BL. The C 562 CM has been designed specifically for permanent, "invisible" mounting in ceilings, walls, tables, stage props, etc. Owing to its high sensitivity, the C 562 CM is a perfect tool for surveillance or live recording since a single microphone can cover an entire room. The supplied XLR phantom power adapter connects to the microphone cable through a miniature connector so installation holes can be smaller than the diameter of the phantom power adapter. SPECIFICATIONS: Polar pattern omnidirectional (hemispherical) Frequency range 20 to 20,000 Hz Sensitivity 25 mV/Pa (-32 dBV) Max. SPL 130 dB (k=1 %) Equivalent noise level 16 dB-A Signal/noise ratio (A-weighted) 78 dB Impedance 600 ohms Recommended load impedance >2000 ohms Supply voltage 9 to 52 V phantom power to DIN/IEC Current consumption Connector 3-pin XLR Cable 0.5 m (20 in.) Finish matte nickel plated Dimensions 20 dia. x 28 mm (0.8 dia. x 1.1 in.) Net weight 30 g (1.1 oz.) Shipping weight 195 g (76.9 oz.) |
The APM series are digital paging microphones equipped with a condenser microphone with cardiologic characteristics, mounted on a 30 cm long gooseneck. By means of a built-in compressor / limiter, the output level of the microphone signal is constantly maintained. The status of the reproduced signal is indicated on the front panel, to ensure the speaker that the message is clear and audible in all situations. Each console has 3 standard buttons (except the APM01 which has only PTT) with pre assigned functions: PTT (Push To Talk), Select all and Clear. All other buttons can be freely programmed, using the free APM configuration software. |
The half-cardioid e 901 is the perfect condenser microphone for kick drum. It is highly robust and step-resistant. It benefits from an integrated preamp.
Pick-up pattern : half-cardioid
Frequency response : 20...20 000 Hz
Sensitivity in free field, no load : (1kHz) 0,5 mV/Pa
Max. Sound pressure level (aktiv) : 154 dB / SPL
Phantom powering : 48 V / 1,1 mA
Nominal impedance :
Min. terminating impedance : 1000 Ohm
Dimensions : 126,5 x 105 x 26,5 mm
Weight : ca. 550 g
|
t is hard to believe that such small, unobtrusive microphones can produce such great sound, but it's true. Available in black or white finishes, and with in-line or plate mount preamps, MX202 Microflex® Overhead condenser microphones capture high-quality sound in a compact, adjustable package. Each model features a choice of interchangeable cardioid or supercardioid condenser microphone cartridges attached to a flexible, four inch gooseneck with a 30 foot cable.
Cartridge polar pattern indicated by model number suffix:
C = Cardioid, S = Supercardioid, N = No cartridge
Available Options
MX202B/C Black mini-condenser Cardioid mic, w/cable, in-line preamp, stand adapter
MX202B/S Black mini-condenser Supercardioid mic, w/cable, in-line preamp, stand adapter
MX202W/C White mini-condenser Cardioid mic, w/cable, in-line preamp, stand adapter
MX202W/S White mini-condenser Supercardioid mic, w/cable, in-line preamp, stand adapter
MX202W/N White mini-condenser mic, w/cable, in-line preamp, stand adapter, No Cartridge
MX202BP/C Black mini-condenser Cardioid mic; includes cable and plate-mounted preamplifier
MX202BP/S Black mini-condenser Supercardioid mic; includes cable and plate-mounted preamplifier
MX202BP/N Black mini-condenser mic; includes cable and plate-mounted preamplifier, No Cartridge
MX202WP/C White mini-condenser Cardioid mic; includes cable and plate-mounted preamplifier.
MX202WP/S White mini-condenser Supercardioid mic; includes cable and plate-mounted preamplifier.
MX202WP/N White mini-condenser mic; includes cable and plate-mounted preamplifier, No Cartridge |
Boundary-layer Microphone
The LD Systems BM1 is an electret condenser microphone with a hemispherical directional characteristic.
For micing upright and grand pianos on stage or in the studio. Additional applications in the area of conference technology, transmission of roundtable discussions and theatrical performances.
Product type
Microphones
Type
Installations
Frequency response
50 - 20000 Hz
Directivity
half ball
Nominal impedance
250 Ohm(s)
Max. SPL (1% THD @ 1kHz)
135 dB
Phantom power requierements
48 V
Microphone input
XLR (3-pin)
Width
27 mm
Height
74.5 mm
Diameter
93.5 mm
Accessories (included)
cables (Mini-XLR / XLR, 6 m)
Weight
0,345 kg
|
Reviews
There are no reviews yet.