SHOWTEC 61120 Wireless Remote Dragon Series

Specifications Remote frequence: 433.97Mhz (20mW)
Compatible models: Dragon 1000 / 1500 / 2000 / F-350 / 1500 Upright

 Martin JEM CLUB SMOKE Machine -  Remote Control 

Digital technology and a new Design

The viper nt originate from the continued development and improvement of the Viper fog machine.
It unites the current digital technology with the proven technique and power of its predecessor.
New features guarantee a much more simple operation ? place and fog, reducing the amount of
time needed to set up the machine.

Features
? Control panel
The control panel with LED-display, simple symbols allow for easy operation. It also protects
the control buttons against dirt.
? Finest adjustments of the output
Digital technology makes fine adjustment of the pump possible. In steps of 1% the output can
be adjusted from 0 - 99%. Thus, any desired effect from a tiny fog-cloud to the thickest fog can
be produced. This enables the viper nt to be used in both small and large locations.
? DMX 512 as standard
The viper nt can be controlled via DMX 512. The connection is done with 5pin-XLR-plugs.
The DMX start address can be adjusted and saved via the control panel.
The machine can also be controlled with analog (0 - 10 V) via a lighting desk or via XLR-remote
(option). This connection is done with 3pin-XLR-plugs.
A stand-alone-mode is also possible. The adjustments are done directly at the machine. A short
press at the start button makes the machine run. Therefore a permanent pressing of the start button
is unnecessary.
? Internal timer
With the internal timer the fog time can be exactly adjusted in seconds, the wait time in minutes
and the output in %.

Safety
The change of the design is not only cosmetic, it also has improved safety features.
The viper nt is equipped with new safety features.
On the front and the back part of the cover there are fixing points for safety bonds.
At both sides of the bottom of the machine are three holes to which a hanging yoke complete with
a collecting tray for fluid drips can be fixed.
Fluid
The following Look-fluids are available for the viper nt:
Quick-Fog (thick, quick disappearing fluid)
Regular-Fog (thick, long lasting fluid)
Slow-Fog (thick, extremly long lasting fluid)
Advantages
? DMX as standard, analog and stand-alone-mode
? Internal timer 
? Fog output adjustable in steps of 1% (0 - 99%)
? Continuous output
? Easy handling
? Powerful output
? Made in Germany

Technical Data:
Procedure: vaporizing fog generator
Power requirement: 1300 Watt
Voltage: 230 V / 50 Hz
              110 V / 60 Hz
Warm up time approx.  7 min.
Fluid consumption
at max. output
at continuous output: 120 ml/min.
.                                   35 ml/min.
Fluid tank capacity: 5 liter
Fog output: adjustable in 99 steps
Output projection:max. 15 m
Fogging time at Control: DMX 512
             0 ? 10 V analog
             Stand-alone-Mode
             Radio remote (Option)
Temperature control: Microprocessor controlled
Overheating protection: Heater block/Thermostat
                                       Pump/Thermal switch
Dimensions (L x W x H): 470 x 230 x 240 mm
Weight without bottle: approx. 8,3 kg

The cutting-edge wireless control system gives Antari W series a simple setting and operation interface. Additionally, the state-of-the-art heater design upgrades the W Series fog machines to a higher level in terms of good quality fog and energy efficiency. In conclusion, Antari W Series bring users to a professional scene in an easier method. Main Features: 1. Intelligent Wireless Control System Each machine comes with a set of wireless receiver and transmitter as standard controller. The working distance of wireless control is 50 meters in open area. 2. Opto-electronic Fluid Sensor When the fluid recipient runs dry,the fluid sensor stops pumping automatically to protect pump from burning. 3. More Efficient New Heat Exchanger Design It can generate drier fog with smaller particles.This leads to a fairly low fog fluid consumption.Compare to the equivalent power consumption heat exchangers, the same quantity of fog fluid in W series can produce 20% more fog than others. 4. New Advanced PCB (Printed Circuit Board) Design The new system can control temperature precisely and rule out the influence from outside environments as much as possible to make W series fog machines be able to work stably between - 20 and + 60 degree Celsius.

Specification

» Power : AC100V/AC120V/AC230V/AC240V,50Hz-60Hz » Heater : 800 W » Output : 3,000 cu.ft / min » First Heat-up Time : 100 seconds » Tank Capacity : 0.8 liter » Fluid Consumption Rate : 60 min / 0.8liter (100% Output) » Remote Included : W-1 Wireless Remote » Weight : 3.8 Kg » Dimensions (mm) : L 315 W 128 H 166 » Liquid Used : Antari FLR / FLG Liquid

1200 watt fogger with DMX

• Continuous output
• Rugged metal housing with handle, mounting bracket and safety eyelet
• Heating element with Unicore technology
• Economic temperature control of the heating element
• Adjustable timer with interval, duration and output volume, continuous output, manual activation
• Output distance: Approx. 7 m
• Control via Wireless remote control (optional); DMX; wired remote control
• For application areas such as: Party room; Clubs/dancing school; restaurants, bars and hotels
• Removable tank with level indication
• Operates on water-based fluid

Package contents

• 1 x device, 1 x user manual, 1 x mounting bracket, 1 x remote control, 2 x knurled screw, 2 x screw, 4 x washer, 1 x container, 1 x tube, 1 x filter

• Fog machine for small party rooms
• On/off cable remote control
• Mounting bracket
• Overheat protection
• Fluid level indication
• Smoke-output: ca. 2 m
• Control: Wired remote control provided
• Power supply of device: Fix fehlt