SHOWTEC 80310 Professional Blacklight 120 cm arm

Info

Extension Cable DMX, IP65, 3 meters, with XLR 3 pin, male and female.

The Detonator is an optional, dedicated remote control tool for easy command of the Atomic strobe's flash rate and intensity. It includes "blinder effect” and "single flash” detonator buttons as well as a chase/synchronization toggle switch. Easy to set up and operate, the Atomic Detonator requires no external power source.


    * Dedicated remote control for Atomic strobe series
    * Fader-controlled flash rate and intensity
    * Single button for Detonator blinder effect
    * Separate button for single flash and flash sync
    * Chase effect operation with multiple units
    * No external power necessary
    * Easy set-up and operation

 

• 4-way power strip with plastic housing
• Sockets are 45° rotated /Ability to connect corner plugs
• Surge protection / child protection
• Voltage: 230V
• Maximum load: 3500W/16A
• 2 USB ports 5.0V/2.1A
• Degree of protection: IP20
• Light switch On/Off to save energy
• Cable length: 1.5m
• Cable type: H05VV-F 3G1.5mm²
• Dimensions (HxWxD): 34x6x5 cm
• Colour: Black

FULL-BRIDGE PWM MOTOR DRIVER

The L6219 is a bipolar monolithic integrated circuits intended to control and drive both winding of a bipolar stepper motor or bidirectionally control two DC motors.

The L6219 with a few external components form a complete control and drive circuit for LS-TTL or microprocessor controlled stepper motor system. The power stage is a dual full bridge capable of sustaining 46V and including four diodes for current recirculation.

A cross conduction protection is provided to avoid simultaneous cross conduction during switching current direction.

An internal pulse-width-modulation (PWM) controls the output current to 750 mA with peak startup current up to 1 A.

Wide range of current control from 750 mA (each bridge) is permitted by means of two logic inputs and an external voltage reference. A phase input to each bridge determines the load current direction. A thermal protection circuitry disables the outputs if the chip temperature exceeds safe operating limits.

*ABLE TO DRIVE BOTH WINDINGS OF BIPOLAR STEPER MOTOR *OUTPUT CURRENT UP TO 750mA EACH WINDING *WIDE VOLTAGE RANGE 10V TO 46V *HALF-STEP, FULL-STEP AND MICROSTEPPING MODE *BUILT-IN PROTECTION DIODES *INTERNAL PWM CURRENT CONTROL *LOW OUTPUT SATURA TION VOLTAGE *DESIGNED FOR UNSTABILIZED MOTOR SUPPLY VOLTAGE *INTERNAL THERMAL SHUTDOWN

STEPPER MOTOR DRIVER, 6219, DIP24; Motor Type:Stepper; No. of Outputs:4; Output Current:1A; Driver Case Style:DIP; No. of Pins:24; Operating Temperature Range:0°C to +70°C; SVHC:No SVHC (20-Jun-2011); Base Number:6219; Device Type:Motor; IC Generic Number:6219; IC Temperature Range:Commercial; Logic Function Number:6219; Operating Temperature Max:70°C; Operating Temperature Min:0°C; Output Current Max:0.75A; Package / Case:DIP; Supply Voltage Max:46V; Supply Voltage Min:10V; Termination Type:Through Hole

• Able to drive both windings of bipolar stepper motor
• Output current up to 750 mA each winding
• Wide voltage range: 10 V to 46 V
• Half-step, full-step and microstepping mode
• Built-in protection diodes
• Internal PWM current control
• Low output saturation voltage
• Designed for unstabilized motor supply voltage
• Internal thermal shutdown