Shure P4HW Wired Bodypack Personal Monitor

344.00 incl. GR VAT

In stock

EAN: N/A
Installments calculation
CompareAdd to wishlist Submit Better Price
Shure P4HW Wired Bodypack Personal Monitor P4HW Wired Bodypack Hardwired Bodypack Key Features Attached input cable High-impact plastic chassis   Operating Controls:   Operating mode (Stereo, Mono, MixMode) Volume knob Balance knob Defeatable limiter High-frequency boost -15 db Pad   Backlit LCD Indicators : Battery life Input level Operating mode  Frequency Response 20 to 20,000 […]

 

Read more

Shure P4HW Wired Bodypack Personal Monitor

P4HW Wired Bodypack

Hardwired Bodypack
Key Features
Attached input cable
High-impact plastic chassis
 
Operating Controls:
 
Operating mode (Stereo, Mono, MixMode)
Volume knob
Balance knob
Defeatable limiter
High-frequency boost
-15 db Pad
 
Backlit LCD Indicators :

Battery life
Input level
Operating mode 

Frequency Response
20 to 20,000 Hz
Total Harmonic Distortion

Channel Separation
35 dB (minimum)
Signal-to-noise ratio
85 dB (minimum)
Maximum Output Level
+5 dBu at 1% THD
Maximum Input Level
+7 dBu, input pad OFF
+22 dBu, input pad ON
Actual Input Impedance
> 40 kilohms
Audio Output Connector
3.5 mm stereo (left=tip, right=ring, ground=sleeve)
Power Requirements
9 V Alkaline battery
Battery Life
Up to 8 hours, volume dependant
Phantom Power Protection
Up to 60 VDC

Weight 0.20 kg

Reviews

There are no reviews yet.

Be the first to review “Shure P4HW Wired Bodypack Personal Monitor”

Your email address will not be published. Required fields are marked *

Quick Comparison

Shure P4HW Wired Bodypack Personal Monitor removeAudio Technica ES945LED touch-sensitive capacitive switch and LED status ring removeAudio Technica AT8657LED table-mount microphone adapter removeAKG C 480B-ULS Ultra Low-Noise Preamplifier removeRODE Invisilav Lavalier Mounting System removeAKG B 23L PHANTOM POWER FOR LAVALIER , MINI MIXER remove
NameShure P4HW Wired Bodypack Personal Monitor removeAudio Technica ES945LED touch-sensitive capacitive switch and LED status ring removeAudio Technica AT8657LED table-mount microphone adapter removeAKG C 480B-ULS Ultra Low-Noise Preamplifier removeRODE Invisilav Lavalier Mounting System removeAKG B 23L PHANTOM POWER FOR LAVALIER , MINI MIXER remove
Image
SKUP4HWES945LEDAT8657LEDC 480B-ULSH99RD00078B 23L
Rating
Price 344.00 incl. GR VAT 246.59 incl. GR VAT 203.36 incl. GR VAT 543.00 incl. GR VAT 18.89 incl. GR VAT 103.31 incl. GR VAT
Stock

In stock

In stock

In stock

Available on backorder

In stock

Available on backorder

AvailabilityIn stockIn stockIn stockAvailable on backorderIn stockAvailable on backorder
Add to cart

Add to cart

Add to cart

Add to cart

Add to cart

Add to cart

Add to cart

Description
Content

Shure P4HW Wired Bodypack Personal Monitor

P4HW Wired Bodypack

Hardwired Bodypack
Key Features
Attached input cable
High-impact plastic chassis
 
Operating Controls:
 
Operating mode (Stereo, Mono, MixMode)
Volume knob
Balance knob
Defeatable limiter
High-frequency boost
-15 db Pad
 
Backlit LCD Indicators :

Battery life
Input level
Operating mode 

Frequency Response
20 to 20,000 Hz
Total Harmonic Distortion
Channel Separation
35 dB (minimum)
Signal-to-noise ratio
85 dB (minimum)
Maximum Output Level
+5 dBu at 1% THD
Maximum Input Level
+7 dBu, input pad OFF
+22 dBu, input pad ON
Actual Input Impedance
> 40 kilohms
Audio Output Connector
3.5 mm stereo (left=tip, right=ring, ground=sleeve)
Power Requirements
9 V Alkaline battery
Battery Life
Up to 8 hours, volume dependant
Phantom Power Protection
Up to 60 VDC

Introducing the ES945LED, the new LED-equipped version of the Engineered Sound ES945 table-mount boundary microphone. The ES945LED features a touch-sensitive capacitive switch and LED status ring.

The omnidirectional condenser ES945/LED increases usability with a new toggle switch and LED status ring - which displays red when muted and green when switched on. The new LED-equipped version of the highly respected ES945 also features improved sensitivity and sound-to-noise ratio, perfectly suited to todayʼs digital matrix mixers.

The ES945/LED is available in black only.

 

ES945LED Specifications 263 KB

 

 

 


The new AT8657/LED table-mount microphone adapter adds functionality to quick-mount gooseneck models from the Audio-Technicaʼs Engineered Sound, Unipoint and ProPoint installation mic ranges and ES945 and ES947 boundary microphone models.

The new AT8657/LED features a touch-sensitive capacitive switch surrounded by an illuminated LED status ring that can be set between red (mute) and green (on). Its integrated 3-pin XLR allows the table-mounting of gooseneck microphones with XLR connectors while the AT8657/LED has a 5-pin XLR out for audio and control data.

AT8657LED Specifications 270 KB

 

 

 


The AKG C 480 B preamplifier powering unit is the latest model in the ULS series. It accommodates the CK 61/ULS, CK 62/ULS, CK 63/ULS capsules and the new CK 69/ULS shotgun capsule, providing a higher order of performance for these capsules than previously available.

The new preamp has a vastly improved noise floor, permitting self noise performance with the four associated capsules in the range of 9 to 11 dB-A. Maximum sound pressure levels in the range of 144 dB (in the -10 dB sensitivity position) can be attained with no greater than 0.5% distortion, giving the capsules a new level of overall performance. An integral low cut filter (12 dB/octave) can be set for either 150 or 70 Hz. The +6 dB sensitivity position is intended to enhance the performance of the CK 69/ULS interference tube capsules, which normally operate over large distances.

With the available CK 61/ULS cardioid, CK 63/ULS hypercardioid, CK 62/ULS omnidirectional, and highly directional CK 69/ULS shotgun element, the C 480 Series is intended primarily for studio, broadcast and a variety of live sound and speech reinforcement applications in which state-of-the-art performance is required. A complete line of optional accessories is available. The C 480 B operates only on 48 volts phantom powering. Check the Related Products.

Features:

  • Ultralow noise preamplifier for use with ULS series capsules
  • Multiple directional capsules and configurations available on a high performance powering/preamp module
  • Extremely flat on-axis response for all models
  • Three sensitivity settings (0, +6, and -10 dB)
  • High acoustic level capability

Specifications:

  • Polar pattern: 10 to 30,000 Hz
  • Preattenuation pad: +6, 0, -10 dB, selectable

  • Bass filter: 12 dB/octave at 70 or 150 Hz
  • Impedance: 2000 ohms/1000 pF
  • Supply voltage: 48 V phantom power to DIN 45596
  • Current consumption:

The RØDE invisiLav is designed to aid the concealing of the Lavalier and smartLav microphones.
Its soft construction absorbs noise and vibration, while the wide, flat profile provides coverage from the elements and allows for versatile mounting. There's two mounting points in case a redundant mic is required, and cable management on the side.
Available in either a pack of three or a bulk pack of ten, the invisiLav comes with pre-cut, skinsafe adhesive that can be used to stick the invisiLav to either the body or to fabric. The invisiLav itself is also made from a medical grade skin safe material so it can be mounted on the body without fear of irritation.

B23 L Battery-operated phantom power supply & mini recording mixer

 

 

The B23 L is a compact power supply unit that provides 9V phantom power to the AKG MicroMic series. Two mini-XLR-F inputs (L and R) ensure optimum use for up to two microphones. Both inputs of the B23 L can be switched either to mono or stereo mode. The output is a standard 3.5mm stereo jack. Two AA batteries guarantee an average use of 30 hours.

Another great feature of the B23 L is that it can be used as a small and portable mixer. Two separate volume controls allow the user to set the level of each microphone independently. Customers who want to compensate level differences between two audio sources (e.g. voice and instrument) will greatly benefit from this feature. On the rear panel of the B23 L there is the battery compartment and a metal clip for fixing the B23 L to a belt, guitar strap or the like.

The B23 L is an attractive solution for customers who are looking for a small and portable power supply capable of mixing up to two audio signals in one device.  

 

Weight0.20 kg0.10 kg0.10 kg0.45 kg0.50 kg0.50 kg
DimensionsN/AN/AN/AN/AN/AN/A
Additional information
Weight 0.20 kg
Weight 0.10 kg
Weight 0.10 kg
Weight 0.45 kg
Weight 0.50 kg
Weight 0.50 kg