SHURE PGA98H-TQG Instrumental Condencer Microphone

The super-cardioid e 609 instrument microphone has been specially developed for miking guitar cabs face on and extremely close to the signal source.

Pick-up pattern : Super-cardioid
Frequency response : 40.....15000 Hz
Sensitivity in free field, no load (1kHz) : 1,5 mV/Pa
Nominal impedance : 350 Ohm
Min. terminating impedance : 1000 Ohm
Dimensions : 55 x 34 x 134 mm
Weight : 140 g

• Frequency response shaped specifically for kick drums and bass instruments
• Built–in dynamic locking stand adapter with integral XLR connector simplifies setup, especially inside a kick drum
• Studio quality performance, even at extremely high sound pressure levels
• Supercardioid pattern for high gain before feedback and superior rejection of unwanted noise
• Hardened steel mesh grille that resists wear and abuse
• Advanced pneumatic shock mount system that minimizes transmission of mechanical noise and vibration
• Neodymium magnet for high signal–to–noise ratio output
• Low sensitivity to varying load impedance
• Legendary Shure quality and reliability

The D 40 with its solid all-metal body will stand up to the hardships of night-after-night onstage use "with a smile“.
The Varimotion diaphragm deep-drawing process allows the diaphragm itself to be fine-tuned with no need for tuning resonators, leading to a quantum leap in audio performance.
The transducer is protected by a sturdy wire-mesh cap and takes extremely high sound pressure levels with ease.
An integrated stand adapter and standard H 440 mounting bracket for snare drums, tom-toms, etc. make the D 40 a highly versatile tool for use on drums, percussions, wind instruments, and guitar amps.

Musical instruments, Live applications.
Dynamic microphone designed for drums and percussions, wind instruments, and guitar amps
Patented AKG Varimotion diaphragm
Custom built capsule mounting
Spring steel wire-mesh cap
Rugged all-metal body withstands typical tough handling on stage

Type Cardioid
Polar pattern 75 to 20,000 Hz
Sensitivity 4 mV/Pa (-48 dBV)
Max. SPL 144/156 dB SPL (for 1%/3 % THD)
Equivalent noise level 18 dB-A
Impedance =1000 ohms
Connector 3-pin XLR
Finish dark stage blue
Dimensions length 104 mm (4.1 in.) height (incl. stand adapter): 79 mm (3.1 in.) max. dia.: 44 mm (1.7 in.)
Net weight 245 g (8.6 oz.)
 

Complete With Stereo Bar, Windshield's and Cradle'

The C 414 B-XL II/ST is especially useful for stereo recordings taken from the far field with the inclusion of useful and often valuable room acoustics. The matched pairs consist of two microphones that are within 1 dB to each other in sensitivity and also within 1 dB to each other in the range of 300 Hz to 8,000 Hz of the individual frequency response when used in cardioid mode and are selected from a large quantity of individual microphones using the described criteria by using a proprietary computer program.

Using this matched pair for stereo recordings utilizing various techniques will provide for a good and stable balance without frequency-dependent shifting of the stereo panorama.

The kit comes complete in an all-metal 'Soundtool' Hard Shell road case with 2 x AKG H-85 shock mounts, 2 x W414X external windscreens, an H50 stereo bar and an individually-measured chart showing the response curve of the microphone. See www.dv247.com Alternative Products and Related Products on this page for your options.

The C 414B-XLII has been carefully designed to maintain the legendary sonic character of the C 414 family while integrating new features and performance enhancements made possible by new technology. A classic microphone with a distinctive timbre especially designed for recording of solo vocals and solo instruments.

Whats the difference between the C 414B-XLII and the C 414 B XLS? The main difference between the two current C414 models lies in their frequency responses. The C 414B-XLII has a series of presence rises between 2.5 KHz and 9 KHz. This will make any recording with this microphone brighter or more sibilant than the original sound. This upper mid range boost is quite helpful on vocals and certain instruments such as classical acoustic guitars using nylon or natural strings. The C 414B XLS, see www.dv247.com Alternative Products on this page, has a very flat response that will not color the original sound which is important especially in instrumental recordings. It more suited for general use.

The microphone's 5 pickup patterns are easily selectable via an electronic switch with LED indication and offer the selection of omnidirectional, cardioid wide cardioid, hyper cardioid and figure-eight patterns. The pickup pattern selector switch utilizes a dual-color LED indicator that provides visual indication of the pattern selected and also changes from green to red to indicate if the microphone's output electronics are being overloaded. The pattern selector can also be used to "lock" the microphone's switch settings by pressing and holding it for 3 seconds. On the rear of the microphone, an electronic switch allows the selection of -6, -12 and -18 dB pre-attenuation levels which are accomplished by changing the polarization voltage to the capsule. The C 414B-XLII has switchable bass cut filters of 12 dB-per-octave at 40 Hz and 80 Hz, and a 6 dB-per-octave filter at 160 Hz for control of proximity effect. On-axis sensitivity for all patterns is 23 mV/Pa and its self-noise is an extremely low 6 dB-A.

The C 414B-XLII has a transformerless output and all-metal chassis, making it immune to electrical interference and RF from digital equipment, video monitors and wireless systems.

Features:

• High sensitivity and extremely low self noise
• Five switchable polar patterns for placement and application flexibility
• Two-color LEDs provide quick visual indication of selected polar pattern and output overload
• Elastic capsule suspension greatly minimizes structurally-transmitted noise from chassis vibration
• Supplied with Hard Shell road case with 2 x AKG H-85 shock mounts, 2 x W414X external windscreens and an H50 stereo bar
• High sound pressure level capability, 140 - 158dB, and wide dynamic range
• Completely immune to electrostatic and electro-magnetic interference from digital gear, computer monitors, etc. thanks to solid metal housing and transformerless output stage
• Three switchable bass cut filters and three pre-attenuation pads with LEDs for quick visual indication
• All switchable components operate in low impedance circuits for ultra-high relability even in extremely humid conditions

Specifications:

• Type: 1" large diaphragm pressure gradient microphone
• Polar Patterns: Omnidirectional, wide cardioid, cardioid, hypercardioid, figure eight
• Frequency Range: 20 to 20,000 Hz
• Sensitivity: 23 mV/Pa (-33 dBV) +/-0.5 dB
• Max. SPL: 140/146/152/158 dB SPL (at 0/-6/-12/-18 dB)
• Preattenuation Pad: -6, -12,-18 dB, switchable
• Bass Cut Filter Scope: 12 dB/octave at 40 Hz and 80 Hz; 6 dB/octave at 160 Hz
• Impedance: = 2,200 ohms
• Supply voltage: 48 V phantom power to DIN/IEC
• Current consumption: Approximately 4.5 mA
• Dynamic range: 134 dB minimum
• Environment Temperature range: -10° C to +60° C (14° F to 140° F)
• Relative humidity: 95% (+20° C/68° F), 85% (+60° C/140° F)
• Connector: 3-pin XLR to IEC
• Dimensions: 50 x 38 x 160 mm (2.0 x 1.5 x 6.3 in.)
• Net weight 300 g (10.6 oz.)