Content |
This UHF antenna uses a log periodic dipole array to produce a cardioid pattern toward the desired coverage area, achieving greater rejection of RF signals outside the area than standard ½ wave omnidirectional antennas.
An integrated amplifier with four gain settings compensates for varying degrees of coaxial cable signal loss.
The UA874 can be stand-mounted, suspended from the ceiling, or wall-mounted using the included swivel adapter bracket.
Compatible with all Shure wireless receivers and antenna distribution systems that provide 12 V DC bias
Four-position gain selector switch
Low-noise signal amplifier that compensates for transmission loss in coaxial cable
Integrated threaded adapter that mounts easily to microphones stands
Legendary Shure build quality and reliability
|
The Sennheiser NT1-UK power adaptor supplies 12v D.C. regulated power for the Sennheiser ASP 2 passive antenna splitter.
The ASP 2 also powers up to 4 x EM100 / 300 / 500 G2 radio mic receivers and 2 x AB 2 active mast head amplifiers 240 volt A.C. input. (UK 3 pin). The ASP 2 with NT1-UK combination helps reduce Antenna and PSU requirements in a multi receiver system.
Sennheiser NT1-UK Features:
- 12 volt D.C. regulated output, centre pin polarised positive
- 1.5 amp current rating
The Sennheiser NT1-UK power adaptor supplies 12v D.C. regulated power for Sennheiser ASP 2 passive antenna splitter.
|
Shure PS9E Power Supply for P4HW
- Suitable for the follpwing: T11, LX1, UT1, ULX1, MX1BP, P2R, P4R
- For external power supplies
- Consists of a PS21E power supply + 9V block
| Directional antenna for setting up larger systems.
- Frequency range: 500 ~ 900 MHz
- Cable and stand not included
This product is compatible with the LDWS100, LDWS1000, LDWIN42 and LDU500 series.
Product type
Wireless Microphone System Accessories
Type
Directional Antennas
Frequency band
500 - 900 MHz
Frequency bandwidth
400 MHz
Impedance
50 Ohm(s)
Antenna gain
7 dBi
Antenna connector
TNC
Threaded connector
5/8 "
Width
290 mm
Height
260 mm
Depth
3 mm
Weight
0,953 kg
Accessories (included)
Adapter 5/8" to 3/8“ |
General Description | Antenna front mount for connecting the antennas of EM 100 G2, EM 300 G2, EM 500 G2 receivers or SR 300 IEM G2 transmitters to the front of the rack. To be used in combination with the GA 2 rack mount. | Delivery Includes | | 2 x 50-ohm BNC cables | | Mounting accessories |
| The Reloop RWM-10 system is the wireless solution for professional demands. True Diversity Technology ensures that the two antennaes maintain a parallel connection with the transmitter, while the stronger signal is always chosen. For outstanding transmission stability and quality which virtually prevents any signal loss. The high-quality dynamic processors of Reloopʼs professional system facilitate an excellent timbre; the customised frequency range with a clear mid-range makes the RWM-10 the ideal solution for precise voice reproduction. The HH set comes with a hand-held transmitter microphone for classic performance.
features:
* Ready-to-go set consists of:
1 x stationary 1 channel rack receiver with mains adapter
1 x Reloop hand-held transmitter mic with wireless transmitter
* 1 channel UHF microphone with condenser capsule
* True Diversity Technology for maximum receiving quality and reliable transmission
* Crystal clear sound thanks to dynamic processor
* 16 interference-free pre-set channels
* Noise cancellation: Compressing-expanding
* Quartz-controlled oscillation
* Volume control
* Symmetrical outputs (XLR and 6.3 mm jack plug)
technical data:
* UHF carrier frequencies: 853.1 – 864.8 MHz
* Stability: +/- 0.003%
* S/N ratio: > 90 dB
* Distortion:
* Frequency range: 40 Hz - 15 kHz
* Sensitivity (receiver): 10 dB
* Weight (receiver): 1.5 kg
* Includes battery |
Reviews
There are no reviews yet.