Content |
Shure WL-185 Lavalier Condenser Microphone
Models WL183, WL184 and WL185 are lavalier electret condenser mics designed for use
with a wireless body-pack transmitter. Each mic has a 1.2 meter (4 ft.) cable terminated
with a miniature 4-pin mini connector. Included tie clip can be rotated in 90 degree intervals for placement flexibility.
WL185 (Cardioid):
Recommended for general purpose sound reinforcement applications requiring good rejection of ambient noise.
Use of windscreen highly recommended. Pickup angle: 130 degrees.
Type
Condenser (electret bias)
Frequency Response
50 to 17,000 Hz
Output Impedance
1800 ohms
Sensitivity (1 Pa = 94 dB SPL)
WL183: -40.0 dBV/Pa
WL184: -44.5 dBV/Pa
WL185: -45.5 dBV/Pa
Maximum Sound Pressure Level
WL183: 125.0 dB SPL
WL184: 129.5 dB SPL
WL185: 130.5 dB SPL
Output Noise (A-weighted)
WL183: 22.5 dB SPL
WL184: 27.0 dB SPL
WL185: 28.0 dB SPL
Dynamic Range
102.5 dB
Polarity
Positive pressure on diaphragm produces positive voltage on pins 3 and 4 relative to pin 1.
Power Requirements
Regulated nominal +5 Vdc (1.5 Vdc to 10 Vdc) provided at microphone connector pin 2 relative to pin 1 of a Shure wireless microphone transmitter.
|
Micro-sized lavalier condenser microphone for wireless and wired applications.
Cardioid microphone with 8ʼ cable terminating to a mini-XLRf connector with phantom power adapter for hard wired applications.
Includes APS910
phantom power adapter. 9-52 V phantom power. Black.
|
- Miniature MU-55 is inconspicuous, lightweight and waterproof.
- Supplied with 4-pin mini XLR and fits all MIPRO bodypack transmitters.
- Featuring a smooth, warm, natural sound.
- Available in black or beige colors.
- Ideal for theater, houses of worship and educational applications.
| Capsule Module | 4.5 mm Ø omni-directional condenser microphone | | | Frequency Response | 40 Hz~20 kHz | | | Sensitivity | -49±3 dBV/Pa (0dB=1V/Pa) | | | Max. SPL | 135 dB (Typical,1%THD) | | | Plug | 4-pin mini XLR or TA4F | | | Color | Black or Beige | | | Cable Length | 150 cm / 59 " | | | Weight | Approx. 14 g / 0.5 oz | | | Note | Refer to actual product in the event of product description discrepancy. |
|
This miniature condenser microphone achieves full-sounding pickup and is known for outstanding consistency and dependable performance. Supplied with both a clothing clip and guitar mount, it provides natural and articulate vocal reproduction when used as a clip-on lavalier and excels in pickup of acoustic guitar. The PRO70 is designed to make music and speech clearly and comfortably audible, yet never draw attention to itself or its operation. The microphone is equipped with a low-frequency roll-off switch that allows for reduced pickup of room noise. The versatile PRO70 may be powered by either battery or phantom power. Its cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source. Miniature condenser microphone is ideal for both vocal and acoustic guitar applications Natural and articulate vocal reproduction when used as a clip-on lavalier - clothing clip included Excels in pickup of acoustic guitar with included instrument adapter Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source Switchable low-frequency roll-off Corrosion-resistant contacts from gold-plated XLRM-type connector Operates on battery or phantom power 6\' (1.8 m) cable permanently attached between microphone and power module Element: Fixed-charge back plate, permanently polarized condenser Polar Pattern: Cardioid Frequency Response: 100-14,000 Hz Low Frequency Roll Off: 80 Hz, 8 dB/octave Open Circuit Sensitivity: Phantom: -45 dB (5.6 mV) re 1V at 1 Pa Battery: -45 dB (5.6 mV) re 1V at 1 Pa Impedance: Phantom: 200 ohms Battery: 200 ohms Maximum Input Sound Level: Phantom: 123 dB SPL, 1 kHz at 1% T.H.D. Battery: 123 dB SPL, 1 kHz at 1% T.H.D. Dynamic Range: Phantom: 96 dB, 1 kHz at Max SPL Battery: 96 dB, 1 kHz at Max SPL Signal to Noise Ratio: 67 dB, 1 kHz at 1 Pa Phantom Power Requiremens: 11-52V DC, 2 mA typical Battery Type: 1.5V AA/UM3 Battery Current Life: 0.4 mA / 1200 hours typical (alkaline) Switch: Off, on-flat, on-roll-off Output Connector: Integral 3-pin XLRM-type Cable: Integral 6\' (1.8 m), permanently attached between microphone and power module Accessories: AT8411 clothing clip; AT8444 instrument adapter; power module; windscreen; battery; soft protective pouch |
Type Condenser - Omni
Frequency Ressponse 60Hz - 18kHz
Sensitivity -33.5dB re 1 Volt/Pascal (21.00mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Resistance 3000Ω
Dimensions 4.50mmW x 12.00mmH x 4.50mmD
Weight 1.00gm
Accessories Αntitrauma case,WS-LAV, Minifur LAV, Micon cable, Spanner |
Miniaturized lavalier condenser microphone for wireless or wired applications.
The ADX10 is a miniaturized condenser microphone designed for lavaliere applications such as speech, presentation and theatrical production. The ADX10 has the ability to accurately capture and reproduce vocals from a comfortable distance of 4“- 8“. This mic is clear, resistant to feedback and easy to use.
Designed with a uniformly controlled cardioid polar pattern, the ADX10 helps to isolate the area or section being miked from other vocals or instruments on stage. The ADX10 has a smooth, accurate frequency range of 50 Hz - 18 kHz. This mic is lightweight, low profile and has a natural sound with exceptional sound response.
Primarily for use with the Audix RAD360 Wireless System, the ADX10 includes a tie-clip and a 3' attached cable terminating to a mini-XLRf connector.
MODEL VARIATIONS:
ADX10P - For hard wired application. Includes an 8' cable terminating to a mini-XLRf connector tie clip, external windscreen and a phantom power adapter module. 9 - 48 V phantom power required.
Type | Pre-polarized Condenser | Polar Pattern | Cardioid | Frequency Response | 50Hz - 18kHz | Impedance | 250 Ohms | Sensitivity | 5 mV/Pa @1k |
|
Reviews
There are no reviews yet.