Content | Subminiature lavalier design; ideal size for theater, television, broadcasting, video, film, and sound reinforcement
Small, inconspicuous mounting hardware
Full, clear sound comparable to larger microphones
Smooth extended frequency response with presence rise specially tailored for chest-worn microphone operation
Controlled low-frequency rolloff reduces low-frequency clothing and room noise
Low distortion, wide dynamic range
Uniform omnidirectional polar pattern
Preamplifier assembly (SM93) can be pocketed, strapped to the body, or clipped to belt or waistband
Wide-range phantom powering (SM93) accepts all commonly used voltages
Type
Condenser (electret bias)
Frequency Response
50 to 20,000 Hz
Response Curve Image Small SM93 WL93 View Larger
Polar Pattern
Omnidirectional, uniform with frequency
Output Impedance
3000 ohms
Output Level (1 Pascal = 94 dB SPL)
Open Circuit Voltage: -38 dBV/Pa (13 mV)
Output Clipping Level (at 1,000 Hz)
0.25 V at 120 dB
Total Harmonic Distortion
Less than 1% at 120 dB
Maximum SPL
120 dB
Dynamic Range (maximum SPL to A-weighted noise level)
102 dB
Output Noise (equivalent SPL)
18 dB typical, A-weighted
Signal-to-Noise Ratio
76 dB at 94 dB SPL (IEC 651)
Polarity
Positive pressure on microphone diaphragm produces positive voltage on pins 3 and 4 with respect to pin 1 (ground)*
*Produces positive voltage at pin 2 of Shure wireless receiver three-pin connector
Recommended Operating Voltage
2 to 10 V; 5 V nominal (pin 2 to pins 3 and 4)
Current Drain
40 microA typical
Environmental Conditions
Operating Temperatures: -18 to 57 degrees C (0 to 135 degrees F)
Storage Temperatures: -29 to 74 degrees C (-20 to 165 degrees F)
Cable
Black 1.27 m (4.17 ft), attached, two-conductor, shielded, terminated by miniature connector type TA4F (WL93T: Tan 1.27 m [4.17 ft])
Case
Microphone: Black ABS thermoplastic case with stainless-steel-mesh grille
Net Weight
Microphone: 16 g (0.57 oz) |
Micro-sized lavalier condenser microphone for wireless and wired applications.
Cardioid microphone with 8ʼ cable terminating to a mini-XLRf connector with phantom power adapter for hard wired applications.
Includes APS910
phantom power adapter. 9-52 V phantom power. Black.
|
Lavaliere Microphone for WS 100 BP Belt Pack and for WS 1616 BP Belt Pack - Uni-directional Electret Condenser Lavaliere Microphone
- Impedance
- Frequency range : 20 Hz – 20 KHz
- Sensitivity : -44 ± 2 dB (at 1 KHz)
Product type
Wireless Microphone System Accessories
Type
Microphones
Frequency response
20 - 20.000 Hz
Directivity
cardioid
Nominal impedance
680 Ohm(s)
Phantom power requierements
5 V
Microphone input
mini-XLR (3-pin, female)
Accessories (included)
attaching clip , Foam windscreen
Weight
0,04 kg
|
This miniature condenser microphone achieves full-sounding pickup and is known for outstanding consistency and dependable performance. Supplied with both a clothing clip and guitar mount, it provides natural and articulate vocal reproduction when used as a clip-on lavalier and excels in pickup of acoustic guitar. The PRO70 is designed to make music and speech clearly and comfortably audible, yet never draw attention to itself or its operation. The microphone is equipped with a low-frequency roll-off switch that allows for reduced pickup of room noise. The versatile PRO70 may be powered by either battery or phantom power. Its cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source. Miniature condenser microphone is ideal for both vocal and acoustic guitar applications Natural and articulate vocal reproduction when used as a clip-on lavalier - clothing clip included Excels in pickup of acoustic guitar with included instrument adapter Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source Switchable low-frequency roll-off Corrosion-resistant contacts from gold-plated XLRM-type connector Operates on battery or phantom power 6\' (1.8 m) cable permanently attached between microphone and power module Element: Fixed-charge back plate, permanently polarized condenser Polar Pattern: Cardioid Frequency Response: 100-14,000 Hz Low Frequency Roll Off: 80 Hz, 8 dB/octave Open Circuit Sensitivity: Phantom: -45 dB (5.6 mV) re 1V at 1 Pa Battery: -45 dB (5.6 mV) re 1V at 1 Pa Impedance: Phantom: 200 ohms Battery: 200 ohms Maximum Input Sound Level: Phantom: 123 dB SPL, 1 kHz at 1% T.H.D. Battery: 123 dB SPL, 1 kHz at 1% T.H.D. Dynamic Range: Phantom: 96 dB, 1 kHz at Max SPL Battery: 96 dB, 1 kHz at Max SPL Signal to Noise Ratio: 67 dB, 1 kHz at 1 Pa Phantom Power Requiremens: 11-52V DC, 2 mA typical Battery Type: 1.5V AA/UM3 Battery Current Life: 0.4 mA / 1200 hours typical (alkaline) Switch: Off, on-flat, on-roll-off Output Connector: Integral 3-pin XLRM-type Cable: Integral 6\' (1.8 m), permanently attached between microphone and power module Accessories: AT8411 clothing clip; AT8444 instrument adapter; power module; windscreen; battery; soft protective pouch |
All models include foam windscreen, swiveling lapel clip, dual tie clip, pin mount, magnet mount
Subminiature size (5.8 mm diameter x 11 mm height)
Electret condenser cartridge
Unidirectional pattern
One termination: 4-pin mini connector (fits directly into Shure wireless transmitters)
High Boost equalization caps included for optimal clarity and response
Provides a 10 dB boost centered at 12 kHz
Used in applications that require a chest-worn microphone
Black and white models available
All models include magnet mount, lapel clip, dual tie clip, pin mount, and two foam windscreens and carry case
requency response: 20-20,000 Hz
Low visibility with a variety of options for mounting
Low handling noise
Legendary Shure quality, ruggedness, and reliability
|
The Shure MX150 Subminiature Lavalier Microphone is a subminiature, multi-positioned clip-on microphone well suited for broadcast operation, sermons, presentations, public address and much more. This version includes the RK100PK XLR in-line preamplifier for use with standard XLR connections in mixers, recorders, mic-pres, etc. Shure's CommShield technology makes the MX150 impervious to noise caused by cell phones, PDAs, WiFi and other RFI. The microphone ships with a snap-fit foam windscreen and multi-position tie clip with an integrated cable management system that minimizes noise without increasing cable strain and tension. Omnidirectional polar pattern and wired XLR connection CommShield Technology guards against interference from cellular RF devices and digital bodypack transmitters Matte black, sleek design for inconspicuous placement Multi-position tie clip allows for a variety of placement options and features an integrated cable management system for convenient cable dress with minimal handling noise Kevlar-reinforced soft-flex cable design further reduces handling noise while providing superior flexibility for routing and placement User-changeable equalization caps for response shaping (omnidirectional only) Snap-fit, concise windscreen provides protection from plosives and wind noise with minimal visibility Legendary Shure quality, ruggedness, and reliability Transducer | Electret condenser | Polar Pattern | Omnidirectional | Frequency Response | 20 to 20,000Hz | Output Impedance | 165.0 Ω | Sensitivity | -34.5 dBV/Pa (19.0 mV) | Max Input Sound Level (SPL) | 1000 Ω load: 125.0 dB SPL; 2500 Ω load: 130.0 dB SPL | Signal-to-Noise Ratio | 59.5 dB | Dynamic Range | @1kHz 1000 Ω: 90.5 dB SPL; 2500 Ω load: 95.5 dB SPL | Self Noise | 34.5 dB (equivalent SPL, A-weighted, typical) | Clipping Level | 1000 Ω load: 1.0 dBv; 2500 Ω load: -4.5 dBv | Operating Temperature | Operating: 0 to 135°F (-18 to 57°C) Storage: -20 to 165°F (-29 to 74°C) | Polarity | XLR: Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3 | Power Requirements | 11-52VDC phantom power (IEC-61938), | Dimensions (LxDiameter) | Length: 5' (1.52m) Diameter: 0.23" (5.8mm) | Weight | 4.3 oz (121 g) |
|
Reviews
There are no reviews yet.