| Content |
GENERAL
The PSA Systems JB-15 is the active variant of the PS-15. This active full range speaker has a built-in amplifier of the bi-amp type and delivers 300 watts RMS. In combination with the active crossover the audio signal is distributed efficiently on a woofer and tweeter. The PSA-15 has a 15-inch woofer, which effortlessly displays the low frequencies, starting at 40Hz. Here he is fed with less than 245 watts. The 1.35-inch compression driver takes it high for his account and get 55 watts of power. This was in fact the RMS power; peaks that are higher are no problem for the amplifier. You are assured of a solid, non-pinched sound.
JB Systems PSA-15 Speaker: Polypropylene
The PSA-15 has a smooth shaped casing made of polypropylene. A light but very strong type of plastic, which is good for long-term protection of the internal components. In addition, he is very practical, with a built-in carrying handle, M8 mounting points, a 35 mm stand adapter and support for monitor use. The latter is excellent as possible, thanks to the angle of the housing.
CONNECTIONS
The back contains the connections with two microphone inputs (XLR, 6.3 mm jack) and a line input (XLR, RCA). The inputs and outputs are balanced. As per the level can be controlled, there is also a master volume and a two-band tone control devices. The PSA 15 is very suitable for mobile use and permanent installation and can be used as PA speaker and be used as a monitor. Monitor Brackets are included. |
Inside our rigid custom designed cabinet is a 15" driver designed exclusively for this project. It's matched with a new 1.75" Titanium high frequency driver, aimed through a 1" diameter horn. The dB500a features 500 watts of clean power (400 watts low frequency/100 watts high frequency) and has a crossover designed for high SPL. Our exclusive Optimax(TM) signal processing circuitry provides total speaker protection but won't cut the low end at high volumes, as similar speakers with sliding filters do.
The back panel has a built-in mixer-like preamp section with mic and line inputs, XLR connectors and level controls. Controls for the selectable low pass filter and Optimax processing are also included.
The dB500a speaker cabinet features an array of mounting options. Designed with floor monitoring in mind, they are also easily stacked or permanently installed. A 1 3/8" pole receptacle is built in, and 10 reinforced fly points are available.
|
|
The Titan™ 15 Active is a self-powered, two-way professional loudspeaker system incorporating a high grade Bi-Amp Class D and Class A/B Amplifiers. The model also has intelligent electronics, such as full protection system: DC, overload, short circuit, thermal, On / Off mute and LF / HF Limiters, which protects the system from overload and allows reliable operation right up to the power limit.
The bottom of the Titan™ 15 ACTIVE provides a convenient built in pole mount socket for easy mounting on a standard 35mm diameter speaker stand pole.
The speaker stand receptacle features a locking screw to ensure stability.
Ten M8 threaded rigging points are provided for a variety of safe flying
configurations with four of these inserts available, bottom-mounted, in an OmniMount® 60.0 bracket footprint.
Mixer and Controls
The Titan™ 15 ACTIVE provides basic mixing functions with a variety of input options. Two inputs with separate level controls and a common equalization section allow for overall balance and tonal characteristic control. Easy interfacing to external mixers and processors provide for easy expansion to larger, more sophisticated systems.
| |
SPECIFICATIONS
| | MODEL | TITAN 15 ACTIVE | | GENERAL INFO |
| | System type | Active 15" 2-way Bi-Amplified | | Frequency response +/- 3db | 50-20kHz | | HF SECTION |
| | Hf type | Titanium Compression Driver | | Horn dispersion (H x V) | 90° x 60° | | Hf exit size mm / inches | 25mm / 1“ | | PHYSICAL FEATURES |
| | Enclosure Material | Injection Moulded Polypropylene | | Enclosure Colour | Grey or White or Black | | Size (mm/inches) | 381mm / 15“ | | IN / OUT PANEL (speaker Level) |
| | Input connector | XLR - 1/ 4" Combo jack | | AMPLIFIER POWER |
| | Power On Protection | Power switch on / off mute | | Thermal Protection | Amplifier shutdown, auto reset | | Low Line Voltage Shut Down | 60% Nominal line voltage | | Driver Protection | Independent LF and HF limiters | | DC Protection | Yes | | Short Protection | Yes | | Controls | High (±10dB) 10kHz Shelving | | Dimensions (HxWxD) |
| | mm | 708.3mm x 477.8mm x 401.77mm | | inches | 27.9" x 18.8" x 15.8“ | | Microphone / Transmitter |
| | Maximum Input Level | +22dBu | | Impedance | 4 Ω | | MIXER MODEL |
| | INPUT IMPEDANCE | Balanced: 20k ohms Unbalanced: 10k ohms | | Clip Limiter | Turns on approx 350W output | | Limiter Indicator | Red LED | | Power Indicator | Red LED | | AC Power details |
| | Power Supply | High Efficiency Switching Mode Power Supply | | AC Power Options | AC100~120V / 220~240V, 50 / 60Hz | | Power On Indicator | LED | | Rigging / Bracket / | 10 M8 threaded inserts including 4 | | Mounting Options | M8 threaded inserts on bottom in OmniMount 60.0-type footprint Pole-mount receptacle with lock screw 2 carry handles (one on each side) Optional wall-mount bracket | | Impedance Balanced | Balanced: 1k ohm - Unbalanced: 500 ohm | | Line Output |
| | Line Output Connector | Switchable LOOP / MIX Balanced Male XLR | | Input A - type | Switchable balanced mic or line level input | | Input Sensitivity | Mic: -36dBu (-38.2dBv or 12.28mVrms)
Line: +4dBu (1.78dBv or 1.228Vrms) | | Maximum Input Level | +22dBu | | Input Connector | XLR - 1/ 4" Combo jack | | Input Impedance | Balanced: 20k ohms Unbalanced: 10k ohms | | Input B - type | Line level input | | Input Sensitivity | XLR - 1/4" Combo jack: 1.78dBv or 1.228Vrms
RCA: 0dBu (-2.2dBv or 0.775Vrms) | | Maximum Input Level | +22dBu | | Input Connectors | Combo jack: 1/4" - XLR / Summed dual RCA jacks | | Bass Response Optimizer |
| | (“BRO“™) circuit | +5dB at 60Hz | | Subsonic Filter | 30Hz, Second-order filter | | Amplifiers |
| | Low-Frequency (Class D) | Rated 350W RMS, 700W Peak | | High- Frequency (Class A/B) | Rated 70W RMS, 140W Peak | | Electronic Crossover | 24dB/octave Linkwitz-Riley | | Crossover Frequency | 1.8kHz | | Controls | High (±10dB) 10kHz Shelving | | Equalization | Low (±10dB) 100Hz Shelving | | DIMENSIONS & WEIGHT |
| | Net weight ( kg / lbs ) | 23.7kg / 52.67lbs | | Gross weight ( kg / lbs ) | 26.94kg / 59.27lbs | |
|
The DBR15 achieves best-in-class SPL of up to132dB and delivers the lowest frequency in its lineup. The DBR15 delivers outstanding performance for the main front-of-house sound for the live performance or DJ events that require highly prominent low and more power. |
Features
400 Watt digital bi-amplification
129 dB max spl
Wide dispersion 90 x 60 constant directivity horn
15" High power woofer, 3" voice coil
2" Titanium dome, high frequency driver
DSP processing, boost eq, soft limiter and protection
Xlr/jack input, xlr signal output
Acoustical Specifications
Frequency Response -3 dB: 45 Hz ÷ 20 kHz
Max SPL: 129 dB
Horizontal coverage angle: 90°
Vertical coverage angle: 60°
Compression Driver: 2" 2.5" voice coil
Woofer: 15" 3" voice coil
Input/Output Section
Input connectors: xlr-jack
Output connectors: xlr
Processor Section
Crossover frequencies: 1300 Hz
Controls: Flat, Boost
Amplifier Specifications
Total power: 400 W
High frequencies: 100 W
Low frequencies: 300 W
Cabinet
Cabinet Material: Composite PP
Handles: 1 on top, 2 on sides
Pole Mount/Cap: yes
Grille: steel
Physical Specifications
Height: 708/27.8 mm/inch
Width: 437/17.2 mm/inch
Depth: 389/15.3 mm/inch
Net Weight: 26/57.32 kg/lbs
|
Specifications
- LF Amplifier Power (RMS): 1000 watts
- HF Amplifier Power (RMS): 250 watts
- Frequency Response (-3dB): 58-18000 Hz
- Frequency Response (-10dB): 50-20000 Hz
- Max. SPL/1m (calc); half space: 133 dB
- Coverage (nominal -6dB) Horizontal: 90°
- Coverage (nominal -6dB) Vertical: 50°
- LF Transducer: DVX3150
- HF Transducer: ND2
- Crossover Frequency: 1500 Hz
- Enclosure Material: Polypropylene
- Flying: Yes
- Input Connections: XLR
- Chassis Size: 15“
- Speaker Type: Full-range, powered monitors, poweredspeakers, two-way wedges
- Weight (net): 50.49 lbs
- Dimensions (H x W x D): 27.24" x 17.56" x 16.18“
|
Reviews
There are no reviews yet.