LD Systems WS 100 BNC 10 Antenna Cable BNC to BNC 10 m

Product type Wireless Microphone System Accessories

The Sennheiser NT1-UK power adaptor supplies 12v D.C. regulated power for the Sennheiser ASP 2 passive antenna splitter.

The ASP 2 also powers up to 4 x EM100 / 300 / 500 G2 radio mic receivers and 2 x AB 2 active mast head amplifiers 240 volt A.C. input. (UK 3 pin). The ASP 2 with NT1-UK combination helps reduce Antenna and PSU requirements in a multi receiver system.

Sennheiser NT1-UK Features:

• 12 volt D.C. regulated output, centre pin polarised positive
• 1.5 amp current rating

The Sennheiser NT1-UK power adaptor supplies 12v D.C. regulated power for Sennheiser ASP 2 passive antenna splitter.

Technical Data
    RF frequency range        470 ..... 870 MHz
    Transmission loss        0 dB (+/- 1 dB)
    Nominal impedance        50 Ohm
    Antenna connector        BNC
    Remarks        max. 100 mW RF input power per channel
    Dimensions        19 ʼʼ, 1 U
    Mains voltage        100 - 240 V
    Mains frequency        50 - 60 Hz

Φορτιστής μπατταριών για το IR-200M και τα IR-300M ασύρματα infrared μικρόφωνα. Για μπατταρίες τύπου NiMH. Πλήρης φόρτιση εντός 3 ωρών.

Rackkit for:

• LDWS100HHD(X)
• LDWS100HHC(X)
• LDWS100BPH(X)
• LDWS100BPG(X)
• LDWS100BPL(X)
• LDWS100R(X)
• LDWS1000HHD(X)
• LDWS1000HHC(X)
• LDWS1000BPH(X)
• LDWS1000BPG(X)
• LDWS1000BPL(X)
• LDWS1000R(X)
• LDWS1616HHD
• LDWS1616BPH
• LDWS1616BPG
• LDWS1616BPL
• LDWS1616R

• Frequency Range: 790.850 MHz - 813.800 MHz
• Switching bandwith: 0.025 MHz
• No. of channels: 160 (10 groups of 16 CHN)
• Sensitivity: -94 dBm for 30 dB SINAD, typical
• Image Rejection: >60 dB
• S/N Ratio: >105 dB (A)
• T.H.D
• Audio Output Level XLR connector: -12 dBV
• 1/4inch connector: -18 dBv
• Audio Response: 60 Hz - 16 kHz
• Dynamic Range: >95 dB A-weighted
• Dimensions (W x H x D): 212 mm x 45 mm x 160 mm
• Power Requirements: 12-18 V dc at 400mA