LD Systems LDDJ500 Power Amplifier 2 x 250 W 4 Ohm

Discontinued

319.00 incl. GR VAT

Out of stock

CompareAdd to wishlist Submit Better Price
The DJ500 is a powerful, full-featured Class AB power amplifier with an output of 250W per channel 4 ohms and 500W in switchable bridge mode. It is especially suitable for mobile use by DJs and smaller bands and in permanent installations. The DJ500 has extensive protection circuitry and a power-on delay. The half perforated front […]

 

Read more

The DJ500 is a powerful, full-featured Class AB power amplifier with an output of 250W per channel 4 ohms and 500W in switchable bridge mode. It is especially suitable for mobile use by DJs and smaller bands and in permanent installations.

The DJ500 has extensive protection circuitry and a power-on delay. The half perforated front panel and a low-noise fan keep the amp cool. XLR and stereo TRS sockets are used as inputs and Speakon-compatible sockets and heavy-duty screw terminals as outputs. A ground lift switch helps eliminate ground loop hum. LEDs on the front panel next to the easy-grip volume controls indicate functional status, overloading, and triggering of the protection circuit.

The DJ500 functions in the entire frequency range of 20Hz – 20kHz with extremely high dependability, dynamics, and impulse fidelity.

  • Type: 2-channel
  • Output Power 1 KHz @ 4 ohms: 2 x 250 W
  • Output Power 1 KHz @ 8 ohms: 2 x 150 W
  • Output Power 1 KHz @ Bridge 8 ohms: 500 W
  • Output Circuity: Class A/B
  • Frequency Range: 20 – 20.000 Hz
  • THD: 0,05%
  • Voltage Gain: 30dB
  • Input Sensivity: 0,85V
  • Protection: Soft start, short circuit, DC, Temperature, over current
  • Controls:ON/ OFF, Volume, Mode (Bridge/ Stereo), Ground-Lift
  • Indicators: Power, Clip, Protect
  • Connectors Line Input: 2 x XLR, 2 x 6,3mm jack
  • Connectors Speaker Output: 2 x Speakon compatible, 2 x binding post
  • Cooling System: Fan
  • Power Supply: 230V / 50-60 Hz
  • Dimensions (W x H x D): 483 x 88 x 298 mm
Weight 7.00 kg

Reviews

There are no reviews yet.

Be the first to review “LD Systems LDDJ500 Power Amplifier 2 x 250 W 4 Ohm”

Your email address will not be published. Required fields are marked *

Quick Comparison

LD Systems LDDJ500 Power Amplifier 2 x 250 W 4 Ohm removeRCF ED 600: 600 W, 2 IN, EXTENDED DYNAMIC STEREO POWER AMPLIFIERS removeAMERICAN AUDIO VLP-600 Power Amplifier 2x300 Watts removeBEHRINGER EP2000 EUROPOWER STEREO AMPLIFIER 2x350W 8Ω 2x500W 4Ω removeLD Systems LDDP600 Power Amplifier 2 x 300W 8 Ohm removeInterM V-1000 Power amplifier 2Χ340W/4ohm, 2Χ180W/8ohm, 2Χ600W/2ohm remove
NameLD Systems LDDJ500 Power Amplifier 2 x 250 W 4 Ohm removeRCF ED 600: 600 W, 2 IN, EXTENDED DYNAMIC STEREO POWER AMPLIFIERS removeAMERICAN AUDIO VLP-600 Power Amplifier 2x300 Watts removeBEHRINGER EP2000 EUROPOWER STEREO AMPLIFIER 2x350W 8Ω 2x500W 4Ω removeLD Systems LDDP600 Power Amplifier 2 x 300W 8 Ohm removeInterM V-1000 Power amplifier 2Χ340W/4ohm, 2Χ180W/8ohm, 2Χ600W/2ohm remove
Image
SKULDDJ500ED600E002985E005275LDDP600V-1000
Rating
Price 319.00 incl. GR VAT 585.89 incl. GR VAT 470.00 incl. GR VAT 434.00 incl. GR VAT 450.00 incl. GR VAT 330.26 incl. GR VAT
Stock

Out of stock

Available on backorder

In stock

Available on backorder

In stock

In stock

AvailabilityOut of stockAvailable on backorderIn stockAvailable on backorderIn stockIn stock
Add to cart

Read more

Add to cart

Add to cart

Add to cart

Add to cart

Add to cart

Description
ContentThe DJ500 is a powerful, full-featured Class AB power amplifier with an output of 250W per channel 4 ohms and 500W in switchable bridge mode. It is especially suitable for mobile use by DJs and smaller bands and in permanent installations. The DJ500 has extensive protection circuitry and a power-on delay. The half perforated front panel and a low-noise fan keep the amp cool. XLR and stereo TRS sockets are used as inputs and Speakon-compatible sockets and heavy-duty screw terminals as outputs. A ground lift switch helps eliminate ground loop hum. LEDs on the front panel next to the easy-grip volume controls indicate functional status, overloading, and triggering of the protection circuit. The DJ500 functions in the entire frequency range of 20Hz - 20kHz with extremely high dependability, dynamics, and impulse fidelity.
  • Type: 2-channel
  • Output Power 1 KHz @ 4 ohms: 2 x 250 W
  • Output Power 1 KHz @ 8 ohms: 2 x 150 W
  • Output Power 1 KHz @ Bridge 8 ohms: 500 W
  • Output Circuity: Class A/B
  • Frequency Range: 20 - 20.000 Hz
  • THD: 0,05%
  • Voltage Gain: 30dB
  • Input Sensivity: 0,85V
  • Protection: Soft start, short circuit, DC, Temperature, over current
  • Controls:ON/ OFF, Volume, Mode (Bridge/ Stereo), Ground-Lift
  • Indicators: Power, Clip, Protect
  • Connectors Line Input: 2 x XLR, 2 x 6,3mm jack
  • Connectors Speaker Output: 2 x Speakon compatible, 2 x binding post
  • Cooling System: Fan
  • Power Supply: 230V / 50-60 Hz
  • Dimensions (W x H x D): 483 x 88 x 298 mm

The high efficiency of the ED series enables maximum efficiency with low heat generation.

A new and unique Class-H circuity technology using state of the art SMD Surface Mount Technology with a reduced number of components offering performance levels exceeding audiophile levels like a slew rate of 50V/µs and high-end extended dynamic sound. The amplifier provides 2x300W into 4 Ohm is equipped complete with temperature-controlled fan cooling, all common protective circuits such as over-temperature, short circuit, RFI and soft start.
The integral soft clip limiter protects against damage to the connected loudspeakers, the activity of a protective circuit, signal and limiter are shown for each channel by LEDʼs.

AMPLIFIER SPECIFICATIONS
Power output stereo 4Ω:2 x 300 Watt rms 
Power output stereo 8Ω:2 x 180 Watt rms 
Power output bridged 8Ω:600 Watt rms 
Frequency Response:20 Hz ÷ 20 kHz  
Signal/noise rate:> 105 dB 
Crosstalk:> 70 dB 
Distortion (THD+N): 
Intermodulation: 
Damping factor:200:1 (8 Ω) 
Slew rate:50 V/μS 
INPUT SECTION
Input connector:2 x XLR balanced, 6,3mm jack unbalanced 
Input sensitivity:0 / 0.775 dBm/V RMS 
Input impedance: 10.000 kΩ 
Controls:Volume control for each channel 
OUTPUT SECTION
Output connector:2 x Neutrik Speakon 4 ways 
SYSTEM PARAMETERS
Cooling:Two-speed fan 
Protections:Temperature, DC, RFI short circuit, Soft-Start thermal on transformer 
Amplifier class:H 
POWER REQUIREMENT
Operating voltage:220÷240 / 110÷120 ~ 50 / 60 V ~ Hz  
Max.current:6 A 
Power Consumption:1300 W 
PHYSICAL SPECIFICATIONS
Height:88 / 3.46 mm/inch 
Width:483 / 19.01 mm/inch 
Depth:350 / 13.77 mm/inch 
Net Weight:11.45 / 25.24 Kg/Lbs 
SHIPPING INFORMATION
Package height:120 / 4.72 mm/inch 
Package width:540 / 21.25 mm/inch 
Package depth:470 / 18.05 mm/inch 
Shipping Weight:13.81 / 30.44 Kg/Lbs

 

VLP Series Powere Amplifier

 

Output Power: 300W RMS Per Channel @ 4 Ohms, 1kHz, 0.1% THD 200W RMS Per Channel @ 8 Ohms, 1kHz, 0.1% THD (Bridge Mode, Mono) 600W RMS @ 8 Ohms, 1K Hz, 1% THD

Total Harmonic Distortion: Less Than 0.1% (20Hz - 20kHz @ 8 Ohms)

Frequency Response: (+/-01db, @rated output Power, 8 Ohms): 20Hz - 20K Hz

Slew Rate: 15V Per usec

Damping Factor @ 8 Ohm: 300

Impedance: 20 Ohms balanced / 10 Ohms unbalanced

Cooling System: 2 indivdual fans

Special Features: High/Low Pass Filter / Input Sensitivity Selector / Ground Lift Limiter

Dimensions (LxWxH): 14" x 19" x 3.5" / 360 x 482 x 88mm 2-rack mount spaces

Weight: 33 lbs. / 15 Kgs.

Special Features: High/Low Pass Filter; Input Sensitivity Selector; Ground Lift; Limiter

  • 2Χ350W 8Ω 2x500W 4Ω 2x650W  STEREO MODE


  • BRIDGE 2000W 4 Ω
  • 16Kg

  • 2 x 1,000 Watts into 2 Ohms; 2 x 750 Watts into 4 Ohms; 2,000 Watts into 4 Ohms (bridge mode)
  • Precise Power, Signal and Clip LEDs to monitor performance
  • XLR and 1/4" TRS input connectors for compatibility with any source
  • Professional speaker connectors and "touch-proof” binding posts support most speaker wiring systems
  • Selectable low-frequency filters (30 Hz or 50 Hz) remove distracting infra-sound frequencies
  • Independent limiters per channel offer reliable protection against overload and distortion
  • High-current toroidal transformer for ultra-high transient response and absolute reliability
  • Ultra-reliable Toshiba/Fairchild power transistors
  • Independent DC and thermal overload protection on each channel automatically protects amplifier and speakers without shutting down the show
  • “Back-to-front” ventilation system including air filter for reliable operation
  • “Built-like-a-tank,” impact-resistant, all-steel 2U rackmount chassis
  • High-quality components and exceptionally rugged construction ensure long life
  • Conceived and designed by BEHRINGER Germany

The LD Systems DP600 Power Amplifier offers an amplifiying level of 2 x 300 W  2 Ohm

The new DEEP2 amp series features four class-H power amplifiers with toroidal core offering amplifying levels from 2 x 400 W till 2 x 810 W at 4 Ohm. During the development of this series we attached a great importance to the reliability and the durability of the amps in continuous operation, this is why we used exclusively high end and selected components for the construction of these products. The DEEP2 series features a Clip Limiter as well as every common protection circuits. These amps are 2 Ohm and 4 Ohm (bridge) stable in continuous operation. On the rear panel you will find all the common In- and Outputs. The DEEP2 series will convince every user thanks to a dynamic and very clear sound which is perfectly adapted for Subbass applications as well as for multifunctional speakers. All models are lightweight and feature a robust steel plate housing and a very user friendly and compact design. The DEEP2 series will prove to be a profitable and reliable choice for bands, renting companies and professional users thanks to its excellent price/performance ratio.
Product type
Power Amplifiers

Type
PA Power Amplifiers

Rated ouput power (1kHz @ 2 Ohms)
2 x 300 W

Rated ouput power (1kHz @ 4 Ohms)
2 x 400 W

Rated ouput power (1kHz @ 8 Ohms)
2 x 300 W

Rated ouput power (1kHz @ 4 Ohms, bridged)
600 W

Rated ouput power (1kHz @ 8 Ohms, bridged)
800 W

Output circuitry
Class H

Frequency response
20 - 20000 Hz

THD
< 0.1 %

Signal-to-noise ratio
105 dB

Damping factor
> 400

Crosstalk
>80 dB

Gain
35 dB

Input sensitivity
0.75 V

Protection circuits
clip limiter , DC protection , short circuit , thermal overload

Controls
2 x volume , bridge/stereo mode selector , ground lift , mains switch (on/off)

Indicators
level , Limit , Power , Protect (protection circuit engaged) , Signal

Loudspeaker outputs
2

Speaker output connections
Speakon compatible , Terminal posts

Cooling
highly efficient, automatic

Operating voltage
transformer

Operating voltage
230 V AC / 50-60 Hz

Weight
12,8 kg

Features
Volex mains socket

InterM V-1000 Power amplifier 2Χ340W/4ohm, 2Χ180W/8ohm, 2Χ600W/2ohm bridge 1200W/4ohm 10-83kHz

high pass filter 30Ηz & 50Ηz

Weight7.00 kg13.81 kg15.00 kg16.00 kg13.00 kg10.30 kg
DimensionsN/AN/AN/AN/AN/AN/A
Additional information
Weight 7.00 kg
Weight 13.81 kg
Weight 15.00 kg
Weight 16.00 kg
Weight 13.00 kg
Weight 10.30 kg