Content |
LD Systems ROADBUDDY 10 B5
Battery Powered Bluetooth Speaker with Mixer and Wireless Microphone
- Battery-powered speaker solution
- Integrated radio receiver 584 - 607 MHz
- Bluetooth player with USB port and SD card slot
- Class D power amplifier with 480 watts of peak power
- 2 combo sockets for microphone or line inputs
- 3.5 mm Aux input
- Master section with 2-band EQ
- Built-in wheels, pull-out handle and fixing for 35 mm tripod mount
- Wireless microphone and IR-remote control included
ROADBUDDY 10 B5
The LD Systems Roadbuddy 10 is an elegant solution for voice and music transmission on the go. The 2-way speaker with a 10" custom woofer and a 1" compression driver is operated with a rechargeable battery for up to 8 hours and is powered by a class D power amplifier with a highly efficient switching power supply and 480 watts of peak power. The Roadbuddy relies fully on wireless transmission: it has an UHF radio receiver which operates in the 584 -607 MHz range, and can be expanded with an additional system. The on-board Bluetooth player with backlit multifunction display ,equalizer, USB port and SD card slot supports the mp3, wma and wav formats. A handheld microphone with 10 mW output power(LDRBUD10B5) or as an alternative a headset microphone with belt pack (LDRBUD10HSB5) and an IR-remote control for the player are included. For wired devices, the Roadbuddy has two channels with combo jacks and individual volume controllers that are switchable for microphone and line level, a stereo input via RCA (Cinch) sockets (mono summed) and a 3.5 mm Aux input. Treble, Bass, Echo and Master volume controllers complete the control panel. The LD Systems Roadbuddy is easily transportable thanks to built-in castor wheels and a pull-out handle. On the top, there is a handy storage compartment for up to two hand-held transmitter microphones. The plastic housing of this lightweight device has been designed to accommodate a 35 mm tripod mount.
Product type
Battery-powered PA speaker
Low/mid driver dimensions
10 "
Woofer Size
254 mm
Woofer magnet
Ferrite
Woofer brand
Custom-made
HF driver dimensions
1 "
HF Driver Size
25.4 mm
HF driver magnet
Ferrite
HF driver brand
Custom-made
Amplifier
Class D
RMS
120 W
Peak power
480 W
Frequency response
55 - 18000 Hz
SPL (1W/1m)
96 dB
Max. SPL
115 dB
Protection circuits
over-current , short circuit , thermal overload
Controls
AUX / MP3 switch , CD / Tape IN Level , Echo , high , low , Mic 1 Level , Mic 2 Level , Total volume
Indicators
Charge/battery status , Power
Media player
Supported media
Bluetooth , SD Card , USB stick
Supported formats
MP3 file , WAV-CD , WMA file
Media player controls
equalizer , Mode (Menu / Bluetooth /SD / USB) , Next Track , Play / Pause , Previous Track , Repeat , Stop
Media player display elements
Lighted multifunctional LC display
Line inputs
1
Line input connectors
2 x RCA , 2 x XLR , 3.5 mm jack , 6.3 mm Jack
Mic inputs
2
Mic inputs
2 x XLR , 6.3 mm Jack
Wireless Unit
Transmission frequency range
584 - 607 MHz
Modulation Type
FM
Channels
16
Frequency Response Wireless Unit
50 - 17000lx @ 1m Hz
Controllers Wireless Unit
ASC , Mute Level (Squelch) , Power / Volume , Value Down , Value Up
Indicators Wireless Unit
AF (LED) , LED Display , RF (LED)
Connections Wireless Unit
nTNC for receiver antenna
RF Transmitter Power Output
10 mW
Handheld Microphone Weight
0.285 kg
Handheld Microphone Material
aluminium
Operating voltage
Switching Power Supply
Operating voltage
220 V - 240 V AC / 50 Hz
Rechargeable batteries
12 V / 5 Ah
Cabinet material
polypropylene
Cabinet construction
vented
Width
415 mm
Height
525 mm
Depth
328 mm
Weight
16,5 kg
Other features
extendable handle , IR Remote for Media Player , Stand mount 36 mm , Transport casters , transport handle
| |
The Alesis TransActive Wireless 2 is a complete, active PA system with built-in lights designed for on-the-go use. Pull up the telescoping handle, tilt it back onto the recessed wheels, and take your TransActive Wireless 2 with you wherever you go. Once youʼre there, simple single-button pairing allows you to instantly stream audio from any Bluetooth-enabled device. You can also activate an exciting full-color light show that reacts to your music—no programming required! TransActive Wireless 2 is the ultimate mobile PA. Itʼs perfect for outdoor parties, live gigs, business meetings, sporting events and tailgate parties.
In addition to Bluetooth connectivity, TransActive Wireless 2 also offers a combo XLR+1/4” microphone/line input, a ¼” instrument/line input, and a stereo 1/8” auxiliary input to accommodate almost any source—microphone, guitar, keyboard, computer, drum machine, CD or MP3 player—whatever you need. Use TransActive Wireless 2 for live performances, to play recorded music or to make announcements with the included microphone. TransActive Wireless 2 is has a powerful low-distortion amplifier and a high-efficiency 2-way speaker with a rugged 8-inch woofer. This audio system delivers solid lows and crisp, detailed highs that can be heard more than 150 feet away—ideal for for any outdoor activity.
|
Portable PA System Max. 180 Watt incl. CDM-3A Player with Remote Control Robust, rugged enclosure, built-in class D amplifiers system with 8" woofer and 1" tweeter. Up to 4 UHF or 2.4 GHz diversity receiver modules with 16 auto-scannable frequencies and built-in active antenna prevents accidental antenna breakage. Plug-&-play CD/MP3 player, plus certified Bluetooth receiver for music streaming. Voice Priority mutes music when a wireless mic is used. Echo effect for richer-sounding vocals. Industry’s only Master volume with "Memory” and "Standard” mode options. "Memory” mode saves and recalls last volume level during next power on. "Standard” mode resets to zero level. Industry’s only master volume that can be remotely controlled by an optional ACT-32HR transmitter microphone directly instead of a separate remote. Retractable handle and rugged wheels make it amazingly easy to transport. Built-in storage compartment for 2 handhelds or bodypack transmitters. Wirelessly link 2 or more MA-708 systems for more sonic coverage (industry’s only MTM-92 trans-mitter module is required). Active limiter prevents speaker damage from loud signal spikes. Can be powered via AC power, battery or direct DC. Weight:16kg
Max. Power Output |
190 Watts |
Amplifier |
Class D |
Sensitivity Typical |
89db |
Maximum |
108db |
T.H.D. |
< 1% |
Frequency Response |
50 Hz - 18 kHz |
Speaker Tweeter |
1" Compression Driver |
Bass |
8" Woofer |
Coverage |
H80° x V60° |
Audio Inputs Wired |
XLR x 1, 6.3 mm (1/4 ") x 1 |
Wireless |
Up to 4 wireless microphones |
Audio Player |
CDM-2︱DPM-3 |
Line-In |
Unbalanced RCA jack |
Bluetooth Connectivity |
Yes |
Audio Output |
Unbalanced line RCA jack |
Extension Speaker |
Ø 6.3 mm (1/4 ") Phone jack |
Master Volume Control Manually or Wirelessly via ACT-32HR |
|
Controls |
Tone, Voice Priority & Echo on wireless mics |
Storage |
2 handheld or bodypack transmitters |
Installation |
Speaker stand, flat surface or retractable handle & wheels |
Power Supply AC |
Built-in 100 ~ 240 V AC switching power supply (Max. Power Consumption 220 W) |
DC & Battery |
24 - 32 V DC, 12 V / 4.5 AH rechargeable gel cell battery (MB-70 × 2) or optional MB-80 × 2 |
Charge Time |
8 hours (automatic charging management) |
Standby Time |
> 7 hours |
Battery Indicator |
4-level indicator (25/50/75/100%) |
Color |
Black or white option |
Dimensions |
336 x 545 x 325mm |
Weight |
16.3 kg 36 lbs (MB-70 batteries included) |
Wireless System (optional) |
|
Receiver |
1 or 2 MRM-70B︱MRM-70W︱MRM-80︱MRM-24 Scan & ACT sync |
Max. Receiver |
Up to 4 |
Frequency Range |
|
MRM-70B︱MRM-70W︱MRM-80 |
UHF 480 ~ 934 MHz (country dependent) |
MRM-24 |
2.4 GHz |
Preset Channels & Bandwidth |
See Accessories - Receiver Modules |
Transmitters |
See Accessories - Receiver Modules |
Microphones |
MM-107︱MM-39︱MM-59 Wired Dynamic Microphone |
Interlinking Transmitter |
MTM-92 |
Installation |
Plug-in Module |
Antenna |
Built-in |
Audio Player (optional) |
|
Model |
CDM-2 | DPM-3 |
Installation |
Plug-in Module |
Note Refer to actual product in the event of product description discrepancy |
|
|
Info
Portable PA system with UHF receiver unit, audio player and Bluetooth - Portable all-in-one PA system for mobile use - Ideal for mains independent and wireless applications, e.g. at sales events, lectures and gyms - 4-channel power mixer (40 W RMS) and 2-way speaker system with a 20 cm woofer (8“) - MP3 player with Bluetooth receiver and IR remote control - SD card slot and USB input - Stream music wirelessly from your mobile devices (e.g. smartphone, tablet) via Bluetooth - Integrated UHF receiver unit and matching wireless microphone - Mains operation or battery operation for up to 4 hours of music playing - Integrated automatic charging of the battery - Lead gel battery optionally available (E6506305) - 2 mono input channels mic/line with adjustable echo effect - 1 stereo stereo input channel for line signal sources e.g. CD players and notebook - Common 2-band EQ for highs and lows - Link output for the combination of several amplifier systems - Jack for external 12V battery operation (e.g. car battery) - Black plastic enclosure with metal grille and carrying handle - Operation of the hand-held microphone via 2 x AA batteries (not included) - Flange for speaker stand installation etc.
| Portable Battery-powered Loudspeaker with 8" Subwoofer and 1" Driver, 2-channel XLR Output, Bluetooth Connectivity, and Removable Lithium-ion Battery
- Ultra-efficient Class-D amplifier with lightweight (17.6-pound) design
- Dimensions: 18 inches (H) x 9.1 inches (W) x 11.2 (D) inches
- 8-inch custom high-output woofer with 1-inch compression driver for full, even projection
- Removable lithium-ion battery with 12 hours of life; tri-colored battery life indicator
- Bluetooth connectivity with linking for a second Thump GO and easy streaming control via the Thump GO Connect App
- 2-channel digital mixer with XLR output and gain balance for PA use
- 4 application-specific speaker modes; indoor/outdoor voicing modes
- Smart input and thermal limiters; "Music Ducking mode" for automatically lowering Ch. 2 level when Ch.1 receives signal
- Great for outdoor spaces with built-in pole mounts
- Durable lightweight molded enclosure, powder-coated steel grille, and 45° resting monitor angle
- 45-degree monitor angle
- Built-in tripod mount
- Robust, powder-coated steel grille
- Frequency response: 57 Hz - 20 kHz
- Beam angle: 90° x 60
- Power output: 200 watts
- Maximum sound pressure: 115 dB
- Inputs: 2x combo, 1x mini jack
- Outputs: XLR Thru
- Weight: 8 kg
- Dimensions (HxWxD): 457 x 230 x 285 mm
- Manufacturer: Mackie
- Typ: Head
- Signal Processing: Active
- Size of Woofer (Inches): 8
- Size of Tweeter (Inches): 1
- max. Peak SPL (dB): 115
- Weight (kg): 8
- Housing Material: Plastic
- Multi-Function Housing: Yes
- Flange: 35mm
- Airworthy: No
- Frequency Response from (Hz): 57
- Frequency Response to (Hz): 20000
- Crossover Network: No
- EQ: No
- Link: Yes
- Input: Combo Socket
- Output: XLR
- Integrated Mixer: Yes
- Mic Input: 1
- WLAN: No
- Bluetooth: Yes
- Battery operation: Yes
- RJ45 Interface / Network: No
- Height (mm): 45.7
- Width (mm): 23
- Depth (mm): 28.5
- incl. Stand: No
- incl. Cover: No
|
Reviews
There are no reviews yet.