TASCAM IF-AN/DM Expansion Card Digital Mixing Desk

Adds eight balanced line inputs and outputs to the DM-3200 or DM-4800. It's a great solution for adding more wireless receivers and monitor outs in a live sound installation. Internal jumpers allow you to set the operating level to -11, -16dB or -20dBfs. Uses DB25 connector wired with "TASCAM standard" pinout. Also works with older TASCAM gear such as the DM-24, DS-M71 and SX-1.

• Recording media: SD card(64MB to 2GB), SDHC card(4GB to 32GB), SDXC card(48GB to 128GB)
• Recording format

• Number of channels: 4-channel (stereo × 2, mono × 4)
• Analog audio input

• Set to "LINE“

• 1/2 connector

• CAMERA IN connector

• LINE OUT connector

• CAMERA OUT connector

• PHONES connector

• REMOTE Connector: 2.5mm TRS jack
• Power: 4 AA batteries(Alkaline or NI-MH), USB bus power, Dedicated AC adapter(TASCAM PS-P515U, sold separately), Dedicated external battery pack(TASCAM BP-6AA, sold separately)
• Power consumption: 5.0W
• Continuous operation time: 2ch WAV, 44.1kHz, 16bit rec, Phantom power not used
• Dimensions: 169(W)×55.2(H)×106.5(D)mm (with the top adapter attached)
• Weight: 625g ( including batteries) / 530g (without batteries )

The DNRP-WRC provides two button record control and visual status indication of a connected Denon® DN-F450R/F650R recorder.

The mouse sized unit, once connecte to the recorder using its integral 5 metre lead, can be placed in a convenient location on a board/ meeting room table to allow the recording of conferences and discussions. Visual indication of recorder status is provided by high brightness red and green indicators located around the RECORD button, which show STOP, PLAY, PLAY PAUSE, PLAY F.FWD, PLAY F.REV, CARD ERROR, RECORD and RECORD PAUSE. The two button control allows the recorder to be placed into record mode, create a new record mark and stop the recording process.

The DNRP-WRC is primarily for the simple control of audio recording in areas where conversations, discussions or conferences are taking place. The unit allows the DNF450R/F650R recorder to be placed out of sight to prevent media tampering or access to all the recorder controls.

• Simple unobtrusive controller for the recording of audio in board/meeting rooms
• Easy connection to Denon DN-F450R/F650R recorder serial (RS232) port
• Provides bright visual indication of STOP, PLAY, PLAY PAUSE, PLAY F.FWD, PLAY F.REV, CARD ERROR, RECORD and RECORD PAUSE
• RECORD and STOP buttons allow simple control without the need to access the recorder
• Ergonomic visually pleasing design with internal weight to prevent table slip
• Ultra low power consumption, no need for additional power adaptor
• Fully sealed label provides protection against drink spills

Main Features

    * Colour TFT touch screen interface
    * 20 illuminated flash start keys

    * Up to 100 tracks available for flash start through touch screen
    * Transport and Online buttons recessed to prevent accidental operation
    * 100-mm fader with fader start capability and 0-dB lock
    * Monitor speaker and headphones output for monitoring
    * CAT6 connection to HS-2 and HS-8

Specifications
General
Recording media         CompactFlash card
  Tested media         SanDisk Extreme IV 4 GB, 8 GB, 16 GB
SanDisk Extreme 4 GB, 8 GB, 16 GB
File system         FAT32
File format         BWF (single-channel, multi-channel)
Number of audio channels         8 channels at 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
8 channels + stereo mix at 44.1 kHZ, 48 kHz
4 channels at 176.4 kHz, 192 kHz
Quantization bit rates         16 bit/24 bit
Sampling frequencies         44.1/47.952/48/48.048/88.2/96/176.4/192 kHz
(47.952/48.048: 48 kHz ± 0.1% pull-up/pull-down)
Reference clock         Internal, Word in, Video in,
Digital in (CH 1-2, CH 3-4, CH 5-6, CH 7-8)
Timecode frame rates         23.976, 24, 25, 29.97 DF, 29.97 NDF, 30 DF, 30 NDF
Built-in mic         Omni directional, monaural
Low cut filter         Cut-off frequency: 40/80/120 Hz
Slope: –12/–18 dB/oct
Analogue audio inputs and outputs
MIC IN/LINE IN connectors (1–8)         XLR-3-31 (1: GND, 2: HOT, 3: COLD)
  Input impedance (LINE)         10 kOhm
  Nominal input level (LINE)         + 6 dBu (Ref. level: –9 dB)
+ 4 dBu (Ref. level: Other than –9 dB)
  Maximum input level (LINE)         Selectable: +15 dBu, +18 dBu, +20 dBu, + 22 dBu, +24 dBu
  Input impedance (MIC –25)         2.4 kOhm
  Minimum input level (MIC –25)         –45 dBu
  Maximum iput level (MIC –25)         +11 dBu
  Input impedance (MIC 0)         2.4 kOhm
  Minimum input level (MIC 0)         –70 dBu
  Maximum input level (MIC 0)         –14 dBu
LINE OUT connectors (L/R)         XLR-3-32 (1: GND, 2: HOT, 3: COLD)
  Output impedance         100 Ohm or less
  Nominal output level         +6 dBu (Ref. level: –9 dB)
  Nominal output level         +4 dBu (Ref. level: Other than –9 dB)
  Maximum output level         Selectable: +15 dBu, +18 dBu, +20 dBu, +22 dBu, +24 dBu
PHONES connector         6.3-mm stereo phone jack
  Maximum output power         100 mW + 100 mW or more (THD+N: 1 % or less, at 32 Ohm)
Digital audio inputs and outputs
DIGITAL I/O connector         D-Sub, 25-pin connector
  Format         AES3-2003/IEC60958-4 (AES/EBU)
  Minimum input voltage         200 mVpp
  Maximum input voltage         7 Vpp
  Output voltage         3.5 Vpp
DIGITAL OUT connectors         BNC
  Format         AES3-2003/AES-3id-2001 (AES/EBU)
  Output voltage         1 Vpp at 75 Ohm
Control inputs and outputs
EXT DC IN connector         XLR-4-32 (1: –, 2: NC, 3: NC, 4: +)
  Input voltage         11–16 V (2 A)
CASCADE/WORD/VIDEO IN connector         BNC
  Input voltage         5 V TTL equivalent
  Input impedance         75 Ohm ±10 %
  Allowable frequency deviation of external sync         ±100 ppm
CASCADE/WORD OUT connector         BNC
  Output voltage         5 V TTL equivalent
  Output impedance         75 Ohm ±10 %
  Sampling frequencies         44.1/47.952/48/48.048/88.2/96/176.4/192 kHz
(47.952/48.048: 48 kHz ± 0.1 % pull-up/pull-down)
TIME CODE IN connector         BNC
  Input voltage         0.5–5 Vpp
  Input impedance         10 kOhm
TIME CODE OUT connector         BNC
  Output voltage         2.0 Vpp
  Output impedance         600 Ohm
USB port         USB B-type, 4-pin
  Format         USB2.0 HIGH SPEED (480 MBit/s)
KEYBOARD connector         Mini-DIN connector (PS/2)
Audio performance
Frequency response (MIC/LINE IN to LINE OUT)          
  All sample rates         20 Hz – 20 kHz, 0 dB (±0.5 dB)
  88.2/96 kHz sample rates         at 40 kHz –1 dB (±1.0 dB)
  176.4/192 kHz sample rates         at 80 kHz –3 dB (+1/–2 dB)
Distortion          
  LINE IN to LINE OUT         0.003 % or less (–20 dB reference level, +23 dBu input, 1 kHz, AES-17 LPF)
  MIC IN (MIC –25) to LINE OUT         0.02 % or less (–20 dB reference level, –10 dBu input, Trim at +20 dB, 1 kHz, AES-17 LPF)
  MIC IN (MIC 0) to LINE OUT         0.02 % or less (–20 dB reference level, –35 dBu input, Trim at +20 dB, 1 kHz, AES-17 LPF)
S/N ratio          
  LINE IN to LINE OUT         110 dB(A) or more (22 kHz LPF)
  MIC IN (MIC –25 or MIC 0) to LINE OUT         100 dB(A) or more (22 kHz LPF)
Computer compatibility
Windows         Windows XP, Windows Vista, Windows 7
  CPU         Pentium 300 MHz or faster
  Memory         128 MB or more
  USB         USB 2.0 port
Macintosh         Macintosh Mac OS X 10.2 or later
  CPU         Power PC G3, G4, Intel Mac 266 MHz or faster
  Memory         64 MB or more
  USB         USB 2.0 port
Recommended USB host controller         Intel chipset
Power supply and other specifications
Power requirements         100–240 V AC, 50–60 Hz (AC adaptor PS-1225L)
10 AA batteries (Alkaline or NiMH)
External DC battery (DC 11–16 V, 2 A or more)
Battery operation time (continuous operation)         Measured according to JEITA standard at 48 kHz, 24-bit, 8 ch playback or recording, phantom power off. Varies with operating conditions.
  NP type battery (Li-Ion: 14.8 V/4.6 Ah)         About 5 hours
  AA type batteries (NiMH)         About 2 hours
Power consumption         18 W
Dimensions (W x H x D)         270 mm x 100 mm x 260 mm (excluding protrusions)
Weight         3.65 kg (excluding batteries)
Operating temperature range         0–40 ºC