| Content |
- 44.1kHz/48kHz, 16/24-bit linear PCM mono/poly recording
- Support WAV format (compatible with BWF format)
- Media: microSD/SDHC cards (supports 32GBcapacities)
- Lavalier microphone with microphone clip and windscreen included (cable length: 160cm)
- Sliding record switch and hold function to prevent misoperation during recording
- Dual recording function
- automatic file closing function to prevent the loss of already recorded data
- Low/Mid Low/Mid/High/High plus recording level settings
- Low-cut filter
- Limiter
- Automatic level function
- With a built-in clock function, supports BWF files that can have time information added - convenient for editing and searching
- Time track incrementing function can create new files at regular intervals (about every 15 minutes) during recording
- Playback function allows recorded data to be checked immediately
- Headphone output
- Easy-to-read organic EL display
- micro USB B port enables easy data exchange with computers
- Records at least 10 hours on a single AAA battery
* using alkaline batteries (EVOLTA)
- Unit settings can be created as a computer text file
- Firmware can be updated using a microSD card
- Belt clip included
- Custom case for storing the unit and accessories included
- RoHS-compliant product
V2.00
- Support for MP3 recording at both 128kbps and 192kbps
- Level meters are now active during both recording and playback
- Independent level settings are now supported within the dual recording function
- POLY file dual recording is now possible
- Overall performance enhanced
|
UR-80: 24 Bit/96 kHz USB Recording System
Features
- Over forty assignable controls
- Up to 24-bit/96KHz recording
- 2x XLR/TRS combo jack with qualified microphone preamp & phantom power
- Included HQ-GM2, HyperCanvas software synthesizer
- ASIO2.0/WDM, MacOS X compatible drivers, low-latency support.
- UR-80 Editor Software Included
- V-Link support
Knob8Fader9Rotary Encoder1Button25LED10Number of Memory SetsPreset1User7Number of Audio Record/Playback Channels (Full duplex (except for 96 kHz setting))Record2 channels (stereo)Playback2 channels (stereo)Signal ProcessingAD/DA Conversion24 bits (linear)PC interface24 bitsSampling Frequency24 bitsDigital output44.1/48/96 kHzDigital input32/44.1/48/96 kHz* Built-in realtime sample rate converterAD/DA Conversion44.1/48/96 kHzFrequency Response96.0 kHz20 Hz to 40 kHz (+0 dB/-2 dB)48.0 kHz20 Hz to 22 kHz (+0 dB/-2 dB)44.1 kHz20 Hz to 20 kHz (+0 dB/-2 dB)Nominal Input Level (variable)Input Jack 1, 2 (XLR type)-50 to -10 dBuInput Jack 1, 2 (1/4 inch TRS phone type)-35 to +4 dBuInput ImpedanceInput Jack 1, 2 (XLR type)5 k ohmsInput Jack 1, 2 (1/4 inch TRS phone type, Lo-Z)32 k ohmsInput Jack 2 (Hi-Z)1 M ohmsNominal Output LevelOutput Jack0 dBuOutput ImpedanceOutput Jack1 k ohmsHeadphones160 ohmsResidual Noise LevelOutput Jack-90 dBu or less
(input terminated with 1 k ohms, OUTPUT VOLUME: max., INPUT SENS = min., INPUT MONITOR = min., IHF-A, typ.)InterfaceUSB
Digital input/output Coaxial type
Optical type(conforms to S/P DIF)ConnectorsInput Jack 1, 2 (XLR type (phantom power)
1/4 inch TRS phone type)
Digital In Connectors (Coaxial type, Optical type)
Digital Out Connectors (Coaxial type, Optical type)
Headphones Jack (Stereo 1/4 inch phone type)
Output Jack L/R (RCA phone type)OthersPower SupplyAC adaptorCurrent Draw1000 mAAccessoriesInstallation Guide
Owner's Manual
USB cable
AC adaptor
CD-ROM
Overlay Sheets with Application LabelsSize and WeightWidth379 mm14-15/16 inchesDepth239 mm9-7/16 inchesHeight84 mm3-5/16 inchesWeight1.7 kg3 lbs. 11 oz.
|
Stereo Rack Memory Recorder
The UR-2 is a 1 U rack size stereo audio recorder using SD card and USB storage device that is flexibly adapting to the wide variety of playback requirements.
The UR-2 is a new generation stereo memory recorder from Fostex that uses 2 SD cards (SDHC compatible) and USB storage device as the recording media. The recording/ playback file format is BWF (WAV). Its ample playback functions will adapt to the wide variety of playback requirements. It offers high quality recording of up to 24bit/96kHz (in BWF format). Employing FAT 32 disc format, it is easy to process the file transfer to a PC based DAW.
The analog input and output are balanced XLR/+4dBu and un-balanced RCA/-10dBV, the digital input and output complies to AES/EBU and S/P DIF digital signal. It is flexible to be used in the available audio system. The playback function includes Chain Play and Timer Play, it is suitable for live stage performance and sound installation. In addition to the external control via parallel remote with D-Sub 25pin and RS-232C serial remote, a USB keyboard and 10-key keyboard can trigger the instant playback start, which is very useful at a live event, theater and broadcast environments.
The Mic input located on the front panel offers 48V phantom power, it can be used not only for recording but also for speech to be mixed with playback source. Last but not least, its newly employed organic EL display gives an extremely clear visibility. This combined with DC power operation, it serves for outdoor use very well.
MAIN FEATURES
• 2 sets SD card slots and a USB host connector for alternate recording/playback among the different media.
• Stereo or Mono WAV (BWF) recording to SD card (also SDHC) and USB storage device
• Fs: 44.1/48/88.2/96kHz, Quantization: 16/24bit
• High speed file transfer with PC via USB 2.0 (bi-directional)
• Employing FAT32 format, it allows to directly mount the recorded files to PC.
• It adapts to a wide variety of use environment by offering Chain Play and Memory Play.
• Timer Play and Power ON Play enable automatic playback start for such as chime and repetitive announcement, which are convenient in the installation audio industry.
• The play mode list employs CSV file format so that it is easy to edit by a text editor or spread sheet program software on PC.
• 99 Cue points with locate function. Waveform display under Scrub mode offers easy and visual Cue point setting
• Microphone input with P48V available on the front panel. Not only for recording but for speech to be mixed with playback source.
• Analog I/O with balanced XLR and un-balanced RCA pin jacks, Digital I/O with XLR connectors
• An organic EL display offers high visibility.
• Remote transport control via Foot SW, Parallel remote pot (Dsub 25pin) and RS-232C (D-sub 9pin)
• External USB keyboard can be used not only for file name editing but for transport control such as REC and PLAY.
|
The DNRP-WRC provides two button record control and visual status indication of a connected Denon® DN-F450R/F650R recorder.
The mouse sized unit, once connecte to the recorder using its integral 5 metre lead, can be placed in a convenient location on a board/ meeting room table to allow the recording of conferences and discussions. Visual indication of recorder status is provided by high brightness red and green indicators located around the RECORD button, which show STOP, PLAY, PLAY PAUSE, PLAY F.FWD, PLAY F.REV, CARD ERROR, RECORD and RECORD PAUSE. The two button control allows the recorder to be placed into record mode, create a new record mark and stop the recording process.
The DNRP-WRC is primarily for the simple control of audio recording in areas where conversations, discussions or conferences are taking place. The unit allows the DNF450R/F650R recorder to be placed out of sight to prevent media tampering or access to all the recorder controls.
- Simple unobtrusive controller for the recording of audio in board/meeting rooms
- Easy connection to Denon DN-F450R/F650R recorder serial (RS232) port
- Provides bright visual indication of STOP, PLAY, PLAY PAUSE, PLAY F.FWD, PLAY F.REV, CARD ERROR, RECORD and RECORD PAUSE
- RECORD and STOP buttons allow simple control without the need to access the recorder
- Ergonomic visually pleasing design with internal weight to prevent table slip
- Ultra low power consumption, no need for additional power adaptor
- Fully sealed label provides protection against drink spills
|
Apogee makes the direct connection to Pro Tools | HD systems a reality. The Apogee X-HD option card allows for direct connectivity between Pro Tools HD™ systems and Apogee's X-Series or Rosetta 200 converters. The result is an incredibly powerful combination of Digidesign's™Ê¼ Pro Tools software and Apogee's superior conversion and clocking hardware. Features: - Primary HD port for connecting directly to HD Core or Accel cards.
- Expansion port for daisy-chaining multiple Apogee devices (AD-16X, DA-16X, Rosetta 800 & Rosetta 200)
- Compatible with the latest versions of ProTools
- May be used along side similar interfaces (such as Digidesign 96 I/O, 192 I/O, Prism Dream ADA-8)
- Please note: Not compatible with Pro Tools|HD Native
|
Liquid Mix HDLiquid Mix HD | TDM Plugin for Pro Tools HD
Key Features
Variety of Classic Emulations
40 compressors and 20 EQs, sampled from vintage originals with a free expanding library online.
Dynamic Convolution Technology
The unique patented Dynamic Convolution process delivers unparalleled EQ and Compression emulations.
Ultra-Low Latency for Recording
With the ultra-low latency of Liquid Mix HD (just 12 samples), it can now be used for recording and live sound applications
Optimised for Pro Tools HD
Over one hundred simultaneous mono instances can be run at 44.1/48kHz on an HD3 system.
Full Control Surface Mapping
Pro Tools TDM format ensures full control mapping on all major Pro Tools control surfaces, including ICON and VENUE.
Unique Hybrid Super EQ
Create your own totally unique 7-band super EQ, built out of separate classic EQ bands.
Compressor 'Free' Mode
Vintage compressors with limited controls can now be set to provide fully variable Attack, Release and Ratio.
Automation and Full Recall
Perfect integration with Pro Tools HD allows for automation of parameters and full recall within your session.
|
Reviews
There are no reviews yet.