Work ESD 10K Automatic Voltage Regulator

It is a voltage regulator able to keep always constant the power supply in 220V
(or 110 V in the additional connector) when the voltage oscillates in a margin
from 140 to 250V ( 220 V input) or 60 to 130 V (110 V input) and connected to
a fix load of 10.000W. The need to keep a stable main voltage, above all for
systems or goods which performing depends on this value, it conserves these
regulators in an appreciated auxiliary device, when we have to supply mixers
effect appliances, etc. The incorporate 2 high brightness displays allow to read
clearly, working conditions, like input, output and main voltage. With the finality
to avoid parasite noise proceeding of the main switch, these units dispose of a
delay in the adjustable switching of 3 or 6 seconds, afterwards it runs in working
normal mode. In the protection section, both devices include protection against a
higher input voltage (255V), overheat and excess of output voltage. In these cases
the unit will switch off, transmitting an acoustic signal and a message in the display.
It disposes of a precise switch in the output voltage which allows to adjust this
parameter from a 1% to 3%.In the front panel, this unit disposes of a 63 A circuit breaker.
In the rear side are placed input/output connection CEE 32 A 3 pole. 1 additional
schucko output for 220 V and another for 110 V.
This unit is cooled by fan.

Technical Specifications:

Power supply: 140V- 250V AC.
Maximum joint load: 10000 VA.
Delay, selectable: 3 or 6 seconds .
Precision of output tension, selectable: 1% - 3%
Protections against:
Excessive temperature of 95 C
High input level
Overload
Dimensions: 460x305 x 260 mm

Adam Hall Cables 87471

19" Power Strip 1U 8-way with switch

• Illuminated 2-pole switch on the front panel
• 8 mains outlets on the rear panel
• Black aluminium housing
• 54 mm deep
• 19 "angle can be mounted in four positions

Work LS-12 Controller

This is a 63A three-phase power splitter with 3x 63A/400V input and 4 CEE 3x 32A/400V output.
Each output is protected by a 32A multi9 circuit breaker and each phase can be read out by a
4-digit voltimeter as well as 4-digit ammeter. Furthermore, a residual current circuit breacker is
used for protection against electronic shock under fault conditions.