YAMAHA NS-SW300 ACTIVE SUBWOOFER 10” 250W

Subwoofer
Driver     25 cm (10”) cone
Output Power     250 W
Frequency Response     20–160 Hz
Advanced YST     Yes
High-Efficiency Power Amplifier     Yes
Twisted Flare Port     Yes
BASS (Bass Action Selector System)     Yes
Auto Standby     Yes
Standby Power Consumption     0.3 W
System Connector     Yes
Dimensions (W x H x D)     350 x 366 x 420 mm; 13-3/4” x 14-3/8” x 16-1/2”
Weight     18 kg; 39.7 lbs.

imensions | Metric :14-1/4” W x 14-1/4” D x 14-1/10” H | 36.2 x 36.2 x 35.8 cm
Driver Complement :One high-definition 10" long throw woofer, pressure coupled to two 10” low bass radiators
Frequency Response :13 Hz – 200 Hz
Internal Amplifier Power :1500 watts
Auto On / Off :Signal Sensing (US) | Signal Sensing and Switched (International)
Power Requirements :110 volts Alternating Current (US) | 220 volts Alternating Current (International)
High Level Inputs :Two pairs of 5 way binding posts
High Level Outputs :Two pairs of 5 way binding posts
Subwoofer Inputs :One LFE input (for SW preout only)
Low Level Inputs :Two low level inputs: left and right low level in
Low Level Outputs :Two low level outputs: left and right low level out
High Level High Pass Crossover :Non Variable 6 dB/octave @ 80 Hz: Available only with high level inputs and outputs
Low Level High Pass Crossover :12 dB/octave continuously variable from 40 Hz to 150 Hz. Available only with low level inputs and outputs
Low Pass Crossover% :24 dB/octave, continuously variable from 40 Hz – 150 Hz: Available only with high level inputs and outputs or low level inputs and outputs
Available Finishes :Piano-Gloss Black
Accessories :Rubber feet; Isolation spikes
Fuse :8 amp 250 volt Slo Blo (US) | 4 amp 250 volt Slo Blo (International)
Weight | Metric :70 lbs | 31.8 kg
Warranty :5 Years; 3 Years for Amplifiers

Amplifier Output:    500 Watts (RMS) 1000 Watts (Peak)
Low Frequency Limit    27Hz (EQ1) 21Hz (EQ2)
Upper Frequency Limit    40 - 120Hz Variable
Variable Low Pass Filter Alignment    Active 4th order 24dB/octave (two-stage filter)
Cabinet Specification:    Sealed Cabinet with 25mm M.D.F construction and internal bracing.
Amplifier Classification:    Class-D amplifier
Driver Compliment:    1 x 12" C-CAM® sub-woofer driver featuring triple suspension and 3" long throw voice coil.
Dimensions:
(H x W x D)    340 x 340 x 410 mm
(13 3/8 x 13 3/8 x 16 1/8 inch)
Weight: (unpacked)    22.56Kg (49.63lbs)
Mains Input Voltage:    100 - 120 Vac, 220 - 240 Vac, 50/60Hz
Input Impedance    20Kohms

 User's Manual

 ΔΙΑΤΙΘΕΤΑΙ ΣΤΑ ΠΑΡΑΚΑΤΩ ΧΡΩΜΑΤΑ

System Format: Sealed Cabinet. 25mm M.D.F construction with internal bracing. Sealed amplifier compartment
Low Frequency Limit: 18 Hz
Upper Frequency Limit: 40 - 120 Hz Variable
Low Pass Filter Alignment: Active 4th order 24dB/octave (6/12/18/24 dB user adjustable)
Amplifier Power Output 650 watts Continuous. 1200 watts (peak)
Amplifier Classification D2AudioTM* DSP controlled, Class-D amplifier system. High current switch mode power supply (smpsu)
Equalisation 4 Settings (Off/Music/Movie/Impact)
Phase Control 0-90-180-270 degrees
Auto Sensing Input Level Requirements Line Level > 2mV. Standby after 10 minutes if no signal sensed
Digital Volume Level -60 to +10dB in 1dB increments
Drive Unit Complement 1 x 15” C-CAM® sub-woofer driver featuring triple suspension
3” long throw voice coil
12V Trigger Input 3.5mm mono jack socket
Connections Stereo RCA in/out
LFE in/out
12V Trigger in (3.5mm mono jack)
LEO* - 3.5mm Microphone input jack (microphone supplied)
Input Impedance 20 kohms
Dimensions (H x W x D) 430 x 400 x 400 mm (16 15/16 x 15 3/4 x 15 3/4 Inches)
Grille Depth 28 mm (1 1/8 Inches)
Weight (unpacked) 35.3 kg (77.6 lbs)
Mains Input Voltage 100 - 120 Vac / 220 - 240 Vac 50/60 Hz (Factory preset)
Electrical Certifications CE/CB/ETL/Fcc/ErP (Energy saving compliant)
Power Consumption Maximum 1000W. Standby Fuse Type 20mm UL/VDE (Value is region specific)
IR Remote Control Code NEC SH6122

AVAILABLE IN SIX COLOR FINISHES

    Pressure vessel enclosure

500W ICEpower® amplifier
Switch mode power supply
Description     Active closed-box subwoofer system
Drive unit     2x f200mm (8 in) mica / aluminium diaphragm long-throw
Frequency range     -6dB at 18Hz and 40/140Hz adjustable (EQ at i)
Frequency response     ±3dB 21Hz – 31/110Hz adjustable (EQ at i)
Power output:     500W
Rated power consumption:     110W (105W - 100V version)
Input impedance:     100kΩ
Signal / noise:     >90dB
Functions:     Volume level
Low-pass filter frequency
Bass roll-off alignment
Auto sense on/standby
Phase switch
Inputs:     Line In (RCA Phono)
Speaker Level In (FCC68 4/4)