| Content | YAMAHA WK248400 XVJ60NPV1 FADER ΓΙΑ MG206 MG166 ORIGINAL
A20K lOG MONO
RESISTANCE : 20 KA
RESISTANCE CHARACTERISTIC : Log
LENGTH out : 75 mm
LENGTH route : 60 mm
HOLE SPACING : 72 mm
LENGTH OF LEVEL( SHAFT HIGH ): 15 mm
Shaft Width : 4 mm
Mono channel fader for Yamaha MG206C (ch1-12) and MG166C (ch1-8) mixers. Also used for MG124C, MW12C (ch1-4), MW12CX (ch1-4) |
AFTERMARKET CAP4R KNOB CAP FOR FADER 4ΜΜ RED
Size:
Long 23.5mm
Wide 11.5mm
High 11mm
HOLE 4mm
| DJM-400: Fader (CH1-CH2).
DJM-600 /S: Fader (CH1-CH4), Masterfader.
DJM-3000: Fader (CH1-CH4), Masterfader.
Suitable for
DJM 300
DJM 400
DJM 500
DJM 600
DJM 700
DJM 750
DJM 800
DJM 2000
DJM 3000
DJM 5000
SVM 1000 | Original Spare Part Pioneer DCS1055, Master Balance Potentiometer DJM600 DJM3000 With center grid.
| AFTERMARKET CAP4W KNOB CAP FOR FADER 4ΜΜ WHITE
Size:
Long 23.5mm
Wide 11.5mm
High 11mm
HOLE 4mm |
FADER B100 KOHM STEREO(DUAL) ALPHA FOR BEHRINGER.
SUITABLE REPLACEMENT FOR MIXER MODEL:
DX052 - DX626 - DJX400 - DJX700 - VMX100 - VMX200 - VMX300 - DDM2000 - DDM4000
RESISTANCE : 100 KΒΧ2
LENGTH out : 73 mm
LENGTH route : 45 mm
PCB mountings: 67.5 mm
SHAFT LENGTH: 15 mm
SHAFT TIP : 4 mm
73 mm x 16mm x 9mm
This fader is a replacement spare part suitable replacement for the CROSSFADER on the above models. This fader is a standard and very commonly used fader and will also fit many other mixers from other manufacturers like, American Audio, Citronic, Kam, Numark, Phonic, Sound-lab, Vestax, Vision, etc.
|
Reviews
There are no reviews yet.