| Content |
450W ΤΕΛΙΚΟΣ ΕΝΙΣΧΥΤΗΣ (100V)
INPUTS: RCA + XLR
OUTPUTS: 70V+100V+4-16 Ohm
ΕΝΔΕΙΚΤΙΚΑ LED: LEVEL-CLIP-PROTECTION-TEMPERATURE
ΔΙΑΣΤΑΣΕΙΣ: 48x9x43cm
ΒΑΡΟΣ: 19,5kg |
Ενισχυτής Public Address 120W/100V, 2 μεγαφωνικές ζώνες, 3 mic & 3 AUX inputs (2 stereo), emergency in με προτεραιότητα η οποία ενεργοποιείται ακόμα και αν το μηχάνημα είναι σε power off, telephone in με δυνατότητα προσπέλασης στις 2 ζώνες, τόνος (chime) αναγγελίας, rec out, line out. Δυνατότητα paging σε κάθε ζώνη ή και στις 2 ταυτόχρονα σε συνδυασμό με το paging μικρόφωνο PM-660. (420W x 100H x 364D mm). Βάρος 12,6kg
| Specification | |
|---|
| Power Source |
AC mains 50/60Hz, or 24V DC (M4 screw terminal) |
| Output |
120W |
| Power Consumption |
AC operation: 158W (rated output), 66W (EN60065)
24V DC operation: 7.0A (rated output), 2.8A (EN60065) |
| Frequency Response |
50 - 20,000Hz ±3dB |
| Distortion |
Under 2% at 1kHz, rated power |
| Input |
MIC 1: -60dB*, 600Ω, electronically-balanced, combined type of XLR-3-31 equivalent and phone jack DIN socket (5 pins)
MIC 2, 3: -60dB(*1), 600Ω, electronically-balanced, combined type of XLR-3-31 Equivalent and phone jack
AUX 1(MOH): -20dB*, 10kΩ, unbalanced RCA pin jack
AUX 2: -20dB(*1), 10kΩ, unbalanced, RCA pin jack
AUX 3: -20dB(*1), 10kΩ, unbalanced, RCA pin jack combined type of XLR-3-31 and phone jack
TEL(*2): -20dB*1, 10kΩ, electronically-balanced, M3 screw terminal |
| Output |
REC: 0dB(*1), 600Ω, unbalanced, RCA pin jack
LINE 1,2(*3): 0dB(*1), 600Ω, unbalanced, RCA pin jack
MOH: 0dB(*1), 600Ω transformer balanced, M3 screw terminal
SPEAKER SELECTOR:
2 zone, high impedance (100V line/83Ω), individual selector switch, M4 screw terminal
DIRECT SPEAKER OUT:
High impedance (100V line/83Ω),M4 screw terminal
Low impedance (4 - 16Ω), M4 screw terminal(Both Low and High impedance terminals cannot be used at the same time.) |
| Phantom Power |
ON or OFF for each MIC 1 - 3 with switch setting |
S/N ratio
(Band Pass: 20 - 20,000Hz) |
Over 100dB (Master volume: min)
Over 76dB (Master volume: max)
Over 60dB (MIC 1 - 3))
Over 76dB (AUX 1 - 3)
Over 90dB (TEL)
Over 96dB (EMERGENCY) |
| Control Input |
Bass: ±10dB at 100Hz, Treble: ±10dB at 10kHz
TEL: No-voltage make contact input, open voltage: 24V DC, short-circuit: under 5mA, M3 screw terminal
EMERGENCY (*4): No-voltage make contact input, open voltage: 24V DC, short-circuit: under 10mA, M3 screw terminal |
| Control Output |
Power remote: Open collector output, withstand voltage: 35V DC, control current: under 50mA, M3 screw terminal |
| Indicator |
5 point LED output level meter, Power indicator LED, Zone indicator LED, Emergency LED, TEL LED |
| Priority |
EMERGENCY: Overrides other inputs
TEL: Overrides other inputs except "EMERGENCY”, ON/OFF selectable with switch setting
MIC 1: Overrides other inputs except "EMERGENCY & TEL”, ON/OFF selectable with switch setting |
| Operating Temperature |
-10ºC - +40ºC |
| Finish |
Panel: ABS resin, black, hair line
Case: Steel plate, black |
| Dimensions |
420 (W) x 107.7 (H) x 367 (D)mm |
| Weight |
12.6kg |
| Accessory |
Power cord x 1,
Terminal block cover x 1,
Terminal block cover mounting screw x 2 |
| Option |
Rack mounting bracket: MB-25B,
Volume control cover: YA-920,
Input transformer: IT-453A |
| Note* |
(*1) 0dB = 1V
(*2) Can be transformer-balanced with the addition of optional IT-453A input transformer.
(*3) LINE 1 and LINE 2 outputs can be interlocked with ZONE 1 and ZONE 2 speaker selectors, respectively. (This function needs internal modification.)
(*4)Operation when activated can be selected from the following: Turning ON the unit\'s power (factory-preset) or OFF. (The OFF function needs internal modification.) |
|
Crown CDi 2000 2x800W-4Ω Τελικός Ενισχυτής
Τελικός ενισχυτής με 2Χ1000W/2V, 2X800W/4Ω,2Χ800W/70V, δυνατότητα bridge λειτουργίας,εξελιγμένο τροφοδοτικό που επιτρέπει τη χρήση του ενισχυτή οπουδήποτε στον κόσμο LCD οθόνη ενδείξεων φωτιζόμενη στην εμπρόσθια πρόσοψη, με ενσωματωμένο επεξεργαστή DSP με έτοιμα preset για διάφορα ηχεία, EQ, limiting,compression, delay, crossover frequencies και subharmonic synthesizer. Είσοδοι balanced με phoenix connectors έξοδοι με barrier strip.Μεταβλητού βήματος ανεμιστήρες στο σύστημα ψύξης, με σύστημα προστασίας και ελέγχου 5 διαφορετικών σημείων, με 6 led ενδείξεων διαφόρων λειτουργιών Κατάλληλος για μόνιμες εγκαταστάσεις.
|
Ενισχυτής ανακοινώσεων 250W. 24 ζωνών ψηφιακός, 24 έξοδοι επιλεγμένες με διακόπτη με ενσωματωμένο δέκτη FM, 1 CDP. 22 kg.
|
POWER AMP
| |
Rated Output
|
120W + 120W
| |
Input Sensitivity
|
-10dBV / 10kΩ
| |
S/N
|
Better than 75dB
| |
Frequency Response
|
100Hz-18kHz
| |
MIC/LINE 1~5CH
| |
MIC Input Sensitivity
|
-55dBV / 10kΩ
| |
MIC S/N
|
Better than 55dB
| |
MIC Frequency Response
|
120Hz-10kHz
| |
MIC T.H.D
|
Less than 0.5%
| |
LINE Input Sensitivity
|
-10dBV / 10kΩ
| |
LINE S/N
|
Better than 65dB
| |
LINE T.H.D
|
Less than 0.3%
| |
CD
| |
S/N
|
Better than 80dB
| |
Frequency Response
|
100Hz-20kHz
| |
TUNER
| |
S/N
|
Better than 60dB
| |
Frequency Response
|
120Hz-12kHz
| |
Power Consumption
|
170W (1/8 Power)
| |
Weight
|
16kg/35.3lb
| |
Dimension
|
482(W)x177(H)x373(D)mm/19(W)x7(H)x15(D)in
|
|
Ενισχυτής αυτοκινήτου 30W, με δυνατότητα τροφοδοσίας 12V από μπαταρία, 2mic input, 1AUX και μικρόφωνο με push talk διακοπτη.
| Specification |
|
|---|
| Power Source | Standard voltage: 14VDC
Usable Voltage; 10 ~ 16V DC (12V Battery Used) | | Power Consumption | 4.4A or less at rated power output. | | Output Power | Rated 30W, max. 60W | | Output Impedance | 4Ω (BRN), 8Ω (ORG), COmmon (WHT)
Changeable by changing lead wire connections. | | Distortion | Less than 5% (at 1kHz rated output) | | Frequency | Response 100 ~ 10,000Hz | | Input | Mic 1, 2 : 600Ω, 4 mV, Phone Jack
Aux : 10 kΩ, 500 mV, Phone Jack | | Dimensions | (W x H x D): 178 x 50 x 144mm (mounting device excluded) | | Weight | 1.1 kg | | Finish | Front panel; ABS resin, Black
Case; Zinc plated steel sheet | | Accessory | Microphone holder ... 1
Mounting Bracket ... 1
Mounting Screw ... 1
Fuse (8A) ... 1
Connection cord ... 1 set | | Accessory | Microphone Unidirectional dynamic type with Talk switch
Impedance : 600Ω
Sensitivity : -53dB (IkHz, 0 dB = 1 V / Pa) |
|
The VP-200VX Power Amplifier Input Module is designed to be used in conjunction with the VP-2064, VP-2122, VP-2241 or VP-2421 power amplifier.
| Power Source | Supplied from VP-2064, VP-2122, VP-2241 or VP-2421 | | Current Consumption | 30 mA or less | | Power Amplifier Link | RJ45 female connector for connecting the VX-200SP,
VX-200SZ Audio Output module, or SX-2100AO.
Twisted-pair straight cable (TIA/EIA-568A standard) | | Finish | Panel: Surface-treated steel plate | | Dimensions | 88 (W) × 25.8 (H) × 53.2 (D) mm | | Weight | 50 g | | Applicable Model | VP-2064, VP-2122, VP-2241, VP-2421 |
|
Αξιολογήσεις
Δεν υπάρχει καμία αξιολόγηση ακόμη.