AUDIO TECHNICA PRO70 CONDENSER LAVALIER MICROPHONE

This miniature condenser microphone achieves full-sounding pickup and is known for outstanding consistency and dependable performance. Supplied with both a clothing clip and guitar mount, it provides natural and articulate vocal reproduction when used as a clip-on lavalier and excels in pickup of acoustic guitar. The PRO70 is designed to make music and speech clearly and comfortably audible, yet never draw attention to itself or its operation. The microphone is equipped with a low-frequency roll-off switch that allows for reduced pickup of room noise. The versatile PRO70 may be powered by either battery or phantom power. Its cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source.

Miniature condenser microphone is ideal for both vocal and acoustic guitar applications
Natural and articulate vocal reproduction when used as a clip-on lavalier - clothing clip included
Excels in pickup of acoustic guitar with included instrument adapter
Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source
Switchable low-frequency roll-off
Corrosion-resistant contacts from gold-plated XLRM-type connector
Operates on battery or phantom power
6\' (1.8 m) cable permanently attached between microphone and power module

Element: Fixed-charge back plate, permanently polarized condenser
Polar Pattern: Cardioid
Frequency Response: 100-14,000 Hz
Low Frequency Roll Off: 80 Hz, 8 dB/octave
Open Circuit Sensitivity: Phantom: -45 dB (5.6 mV) re 1V at 1 Pa Battery: -45 dB (5.6 mV) re 1V at 1 Pa
Impedance: Phantom: 200 ohms Battery: 200 ohms
Maximum Input Sound Level: Phantom: 123 dB SPL, 1 kHz at 1% T.H.D. Battery: 123 dB SPL, 1 kHz at 1% T.H.D.
Dynamic Range: Phantom: 96 dB, 1 kHz at Max SPL Battery: 96 dB, 1 kHz at Max SPL
Signal to Noise Ratio: 67 dB, 1 kHz at 1 Pa
Phantom Power Requiremens: 11-52V DC, 2 mA typical
Battery Type: 1.5V AA/UM3
Battery Current Life: 0.4 mA / 1200 hours typical (alkaline)
Switch: Off, on-flat, on-roll-off
Output Connector: Integral 3-pin XLRM-type
Cable: Integral 6\' (1.8 m), permanently attached between microphone and power module
Accessories: AT8411 clothing clip; AT8444 instrument adapter; power module; windscreen; battery; soft protective pouch

• Miniature MU-55 is inconspicuous, lightweight and waterproof.
• Supplied with 4-pin mini XLR and fits all MIPRO bodypack transmitters.
• Featuring a smooth, warm, natural sound.
• Available in black or beige colors.
• Ideal for theater, houses of worship and educational applications.

Technical Data
 Frequency response  40...20.000 Hz 
 Sensitivity as per 121 TR 9-5  42 mV/Pa +- 3dB 
 Maximum sound pressure level (passiv)  118 dB (k=1%) 
 Pick-up pattern  cardioid 
 Dimensions  d=12mm, l=26mm 

 Shure SLX14 Instrument Wireless System Features:

    SLX4 Wireless Receiver:
    Automatic Frequency Selection
    Automatic Transmitter Setup
    960 Selectable frequencies across 24MHz bandwidth
    Detachable 1/4 wave antennas
    Microprocessor-controlled diversity
    RF presence LED
    5-segment audio meter
    Multi-function, backlit LCD
    Low battery indicator
    Frequency and power lockout
    Rugged metal chassis
    Volume control on rear of unit
    1/2 rack design
    Furnished rack hardware
    Non-slip bumpers for use out of rack
    XLR and 1/4" outputs

    SLX1 Bodypack Transmitter
    Automatic Transmitter Setup
    Backlit LCD with timeout feature
    Frequency and power lockout
    3-segment battery fuel gauge
    2 AA batteries (included) provide 8 hours of continuous use
    518 - 782 MHz operating range



Shure SLX14 Instrument Wireless System Specifications:

    SLX4 Wireless Receiver:
    Audio Output Level (ref. ± 38kHz deviation with 1kHz tone): XLR connector (into 600 Ohm load): —13dBV; 1/4" connector (into 3000 Ohm load): —2dBV
    Output Impedance: XLR connector: 200 Ohms; 1/4" connector: 1kohms
    XLR output: Impedance balanced; Pin 1: Ground; Pin 2: (+); Pin 3: (-)
    Sensitivity: —105 dBm for 12 dB SINAD, typical
    Image Rejection: >70 dB, typical
    Power Requirements: 12—18 Vdc at 150 mA, supplied by external power supply
    Operating Range Under Typical Conditions: 300 ft. (100m)
    Note: Actual range depends on RF signal absorption, reflection, and interference
    Audio Frequency Response (+/— 2 dB): Minimum: 45 Hz: Maximum: 15 kHz
    Note: Overall system frequency depends on microphone element.
    Total Harmonic Distortion (ref. +/— 38 kHz deviation, 1 kHz tone): 0.5%, typical
    Dynamic Range: >100 dB A-weighted
    Operating Temperature Range: —18 degree C (0 degree F) to +50 degree C (+122 degree F)
    Note: battery characteristics may limit this range
    Dimensions (H x W x D): 1.65 x 7.76 x 5.28 in., (42 x 197 x 134 mm)
    Weight: 1 lb. 13 oz. (816 g )
    Housing: Galvanized steel
    Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with
    respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output.
    Logic Connections: Pin 1: Logic output, Transmitter Mute Status. Mute=low (0 V). Sinks up to 100 mA. Absolute maximum -0.7 to 5.5V DC; Pin 2: Logic ground; Pin 3: Logic output, Battery Status. Good=low (0 V). Sinks up to 100 mA; Absolute maximum -0.7 to 5.5V DC

    SLX1 Bodypack Transmitter
    Audio Input Level: -10 dBV maximum at mic gain position, +10 dBV maximum at 0 dB gain position, +20 dBV maximum at -10 dB gain position
    Gain Adjustment Range: 30dB
    Input Impedance: 1 Mohms
    RF Transmitter Output: 30 mW maximum (dependent on applicable country regulations
    Dimensions (H x W x D): 4.25 x 2.50 x 0.75 in. (108 x 64 x 19 mmD)
    Weight: 81 grams (3 oz.) without batteries
    Housing: Molded ABS case
    Power Requirements: 2 "AA" size alkaline or rechargeable batteries
    Battery Life: >8 hours (alkaline)