DYNACORD SUB-115 Subwoofer 500 Watts

DYNACORD΄s SUB 115 is a vented direct radiating cabinet, equipped with the high-power Electro-Voice EVS15S transducer. The new High-Speed-Laminar-Vent system (patent pending) shows signifi cantly less distortion and lower air noise at low frequencies than common vented cabinets. The SUB 115 has the same dimensions and cosmetics as the powered PowerSub 315 and can directly be connected to the PowerSub 315 for an extended bass fundament. For this application you have to shift the PowerSub 315ʼs ʽMODE SWITCHʼ to the position ʽINTERNAL+EXTERNAL 2*500Wʼ.The SUB 115 contains a passive fi lter that suppresses high frequencies. Appropriate fullrange cabinets, e.g. DYNACORDʼs D12, can therefore be directly connected in parallel to the SUB 115 if an extended bass reproduction is required. You just have to connect the SUB 115 and the fullrange cabinet with a regular Speakon cable. The cabinet is equipped with an electronic circuit called VOICE COIL TRACKING PROTECTION. This circuit senses the terminal voltage of the transducer and simulates the thermal behaviour of the woofer΄s voice coil. In case of potential thermal overload the power applied to the speaker is reduced to a safe level. Extremely powerful amps can be used in order to have maximum dynamic range without the danger of thermal overload in non-controlled situations. The VOICE COIL TRACKING PROTECTION exhibits "soft” switching characteristics, so no annoying clicks or pops are audible. The circuitry automatically resets after the voice coil temperature has reached a safe value.

Παθητικό subwoofer με 15” woofer, ισχύος 400W RMS / 800W peak στα 8Ω. Ευαισθησία 96dB, max spl 124db, τεχνολογία bass reflex. Διαθέτει φωλιά στο πάνω μέρος για την τοποθέτηση σωλήνα στήριξης δορυφόρου, frequency response: 40Hz-300Hz, βάρος: 35Kg.

Χαρακτηριστικά:

• Μικρό σε όγκο για τα δεδομένα του (15” speaker) sub-woofer κατάλληλο για χρήση σε μόνιμες εγκαταστάσεις όπως café, club, discotheque, pub καθώς και φορητή χρήση
• Ιδανικό ηχείο subwoofer για φορητές εγκαταστάσεις, djs και εταιρίες ενοικιάσεων
• Δυνατότητα αναβάθμισης σε αυτοενισχυόμενο subwoofer εύκολα και απλά, προσθέτοντας την ενισχυτική βαθμίδα AVM-2 (δεν περιλαμβάνεται)
• Για την σωστή χρήση του subwoofer απαιτείται τελικός ενισχυτής ο οποίος να έχει ισχύ εξόδου 450W RMS στα 8Ω
• Τέλειος συνδυασμός του subwoofer VIBE15-SUB Mk2 με τα ηχεία VIBE10 Mk2 or VIBE12 Mk2 για δορυφόρους
• Ειδική βαφή με μπογιά πολυουρεθάνης για αντοχή στις γρατζουνιές
• Μεταλλική σήτα με επίστρωση ειδικού ακουστικού αφρού για ένα όμορφο οπτικά ηχείο και την προστασία των υλικών του speaker από σκόνες, χτυπήματα, υγρασία, σταγόνες νερού
• 35mm εσωτερική φωλιά στο πάνω μέρος για την τοποθέτηση του σωλήνα στήριξης του δορυφόρου
• High Power 15inch Woofer με ALU basket
• Ειδικές υποδοχές στο πίσω μέρος του sub woofer για την τοποθέτηση ροδών μεταφοράς (δεν περιλαμβάνονται)
• Ισχύς: 400Wrms (800Wpeak)
• Input impedance: 8Ω
• Input Sensitivity: 96dB 1W/1m
• Max. SPL: 124dB
• Frequency response: 40 - 300Hz
• Διαστάσεις: 440 x 595 x 605 mm
• Βάρος: 35kg

Ειδική έκδοση του AM 7115 για χρήση σε
εξωτερικό περιβάλλον με επιπλέον αναβάθμιση
υλικών προστασίας. Πιστοποίηση IP55 κατά
πρότυπο IEC 529. Παράδοση κατόπιν
παραγγελίας.

Frequency Range (-10 dB):     40 Hz – 4.2 kHz
Frequency Response (±3 dB):     47 Hz - 3.0 kHz
Transducer Power Rating (AES):     1000 W (4000 W peak), 2 hrs
Long-Term System Power Rating (IEC):     600 W (2400 W peak), 100 hrs
Maximum SPL:     50 Hz –125 Hz
125 Hz – 800 Hz:     126 dB-SPL cont avg
(dB-SPL, 1W @ 1m):     50 Hz – 125 Hz
125 Hz – 800 Hz:     97 dB
Nominal Impedance:     8 ohms
Low Frequency Driver:     1 x JBL 2265H 380 mm (15 in) Differential Drive driver with 75 mm (3 in) dual voice coil
Enclosure:     Trapezoidal with 15 degree side angles, 16 mm (5/8 in) exterior grade 11-ply Finnish birch plywood
Suspension Attachment:     13 points (3 top, 3 bottom, 2 each side, 3 rear), M10 threaded hardware
Finish:     Black DuraFlex™ finish.
Grille:     Powder coated 14 gauge perforated steel, with acoustically transparent black foam backing.
Input Connector:     NL4 Neutrik Speakon® and CE-compliant covered barrier strip terminals. Barrier terminals accept up to 5.2 sq mm (10 AWG) wire or max width 9 mm (.375 in) spade lugs. Speakon in parallel with barrier strip for loop-through.
Environmental Specifications:     Mil-Std 810; IP-x3 per IEC529
Dimensions (H x W x D in vertical cabinet orientation):     548 x 561 x 657 mm
Net Weight:     25.9 kg (57 lb)
Optional Accessories:     M10 x 35 mm forged shoulder eyebolts with washers. Optional planar array frame kit. See AE Series Bracket Guide.

EVID 12.1 EVID Series Premium Surface Mount Subwoofer

To augment and extend the low frequency response of any full-range models,
an attractive and powerful subwoofer completes the EVID line. The 12.1 provides
an easy installation by incorporating dual voice coils to handle both channels of
a stereo pair. In addition, the unit can power up to four satellites with its four
crossed-over audio outputs on the back panel. For extended bass performance
in demanding installations... EVID 12.1 Subwoofer.

Specifications
Max. SPL / 1m (calc); full space 125 dB 
System Power Handling (continuous/program/peak) 175/350/700 Watts 
Nominal Impedance 6 Ohms 
Minimum Impedance 6 Ohms 
Flying No 
Frequency Response (-10dB) 40 - 140 Hz 
Input Connections Spring Terminal 
Internal Crossover Yes 
Sensitivity 1W/1m 100 dB 
Chassis Size 12 inches 
Weight Net 18.1 kg ( 39.9 lbs ) 
Dimensions (HxWxD) 412 x 584 x 305 mm
(16.22" x 22.99" x 12.01")

Yamaha realized more than 40 years ago that simply building systems around speaker units bought from other manufacturers would not do, initiating a long and arduous but fruitful quest for ideal speaker performance based on original technology. Along the way innovative Yamaha speaker technology has resulted in a number of breakthrough products that established new performance standards in a number of critical fields.

• High power subwoofer.
• Dual woofers can be switched for discrete drive (IS1215 and IS1218).
• Twelve 10mm-screw suspension points (M10) provided for flexible rigging.
• Durable black or white finish (can be painted to match any interior).
• Optional matching array frame available (for IS1118 and 1218 only).
• Parallel-wired Neutrik NL4 and barrier strip connectors.