LD SYSTEMS LDSP2K4 SP 2K4 – PA Power Amplifier 2 x 1190 W 2 Ohm

1,756.70 incl. GR VAT

Available on backorder

EAN: N/A
Installments calculation
CompareAdd to wishlist Submit Better Price
The new Audio 3-stage CLASS-H SMPS amplifiers incorporate all the features to meet all your needs, whether youʼre starting a P.A. amplifier project from scratch or just need to upgrade your present sound reinforcement equipment. In the amps, youʼll find 2 and 4 channel models, all offering high power levels at low distortion in the […]

 

Read more

The new Audio 3-stage CLASS-H SMPS amplifiers incorporate all the features to meet all your needs, whether youʼre starting a P.A. amplifier project from scratch or just need to upgrade your present sound reinforcement equipment. In the amps, youʼll find 2 and 4 channel models, all offering high power levels at low distortion in the range 1.5 to 6 kW, yet weighing around 8.6 kg and only 30 cm deep.

  • Model Name: SP2K4
  • Output Power 1 kHz, 500
  • Crosstalk (20 Hz – 20 kHz): > 75 dB
  • Voltage Gain (selectable): 26/32/38 dB
  • Input Sensitivity: 3.0 / 1.5 / 0.8 V
  • Protection: Soft-start, Turn-on Turn-off transients, Muting at turn-on, Over-heating, DC, RF, Short-circuit, Open or mismatched loads, Overloaded power supply, ICL (Inteligent Clip Limiting), PMS (Power Management System), SSP (SOA Sentry Protection)
  • Controls: On / Off Switch, Volume, Voltage Gain, Dual / Link Switchable, Bridge Mode Configuration Switch
  • Indicators: Signal, Temperature, ICL (Inteligent Clip Limiting), PMS (Power Management System)
  • Connectors:
    • Input: 2 x XLR
    • Line Output: 2 x XLR
    • Speaker Output: 2 x Speakon
  • Power Supply: 230 V – 50 Hz
  • Dimensions (W x H x D): 483 × 88.9 × 310 mm
Weight 8.00 kg

Reviews

There are no reviews yet.

Be the first to review “LD SYSTEMS LDSP2K4 SP 2K4 – PA Power Amplifier 2 x 1190 W 2 Ohm”

Your email address will not be published. Required fields are marked *

Quick Comparison

LD SYSTEMS LDSP2K4 SP 2K4 - PA Power Amplifier 2 x 1190 W 2 Ohm removeRCF HC 1600: 1600 W, 2 IN, HIGH CURRENT STEREO POWER AMPLIFIERS removeLD Systems DEEP2 1600 PA Power Amplifier 2 x 800 W 2 Ohms removeQSC GX-7 POWER AMPLIFIER 2x1000W RMS @ 4Ω, 2x725W RMS @ 8Ω removeRCF ED 1100: 1100 W, 2 IN, EXTENDED DYNAMIC STEREO POWER AMPLIFIER removeCROWN XTi-2002 2x800W 4Ω POWER AMPLIFIER remove
NameLD SYSTEMS LDSP2K4 SP 2K4 - PA Power Amplifier 2 x 1190 W 2 Ohm removeRCF HC 1600: 1600 W, 2 IN, HIGH CURRENT STEREO POWER AMPLIFIERS removeLD Systems DEEP2 1600 PA Power Amplifier 2 x 800 W 2 Ohms removeQSC GX-7 POWER AMPLIFIER 2x1000W RMS @ 4Ω, 2x725W RMS @ 8Ω removeRCF ED 1100: 1100 W, 2 IN, EXTENDED DYNAMIC STEREO POWER AMPLIFIER removeCROWN XTi-2002 2x800W 4Ω POWER AMPLIFIER remove
Image
SKULDSP2K4HC1600LDDP1600010002ED1100XTi-2002
Rating
Price 1,756.70 incl. GR VAT 1,004.39 incl. GR VAT 750.00 incl. GR VAT 695.00 incl. GR VAT 716.10 incl. GR VAT 777.00 incl. GR VAT
Stock

Available on backorder

Available on backorder

In stock

Available on backorder

Available on backorder

Only 1 left in stock (can be backordered)

AvailabilityAvailable on backorderAvailable on backorderIn stockAvailable on backorderAvailable on backorderOnly 1 left in stock (can be backordered)
Add to cart

Add to cart

Add to cart

Add to cart

Add to cart

Add to cart

Add to cart

Description
Content

The new Audio 3-stage CLASS-H SMPS amplifiers incorporate all the features to meet all your needs, whether youʼre starting a P.A. amplifier project from scratch or just need to upgrade your present sound reinforcement equipment. In the amps, youʼll find 2 and 4 channel models, all offering high power levels at low distortion in the range 1.5 to 6 kW, yet weighing around 8.6 kg and only 30 cm deep.

  • Model Name: SP2K4
  • Output Power 1 kHz, 500
  • Crosstalk (20 Hz - 20 kHz): > 75 dB
  • Voltage Gain (selectable): 26/32/38 dB
  • Input Sensitivity: 3.0 / 1.5 / 0.8 V
  • Protection: Soft-start, Turn-on Turn-off transients, Muting at turn-on, Over-heating, DC, RF, Short-circuit, Open or mismatched loads, Overloaded power supply, ICL (Inteligent Clip Limiting), PMS (Power Management System), SSP (SOA Sentry Protection)
  • Controls: On / Off Switch, Volume, Voltage Gain, Dual / Link Switchable, Bridge Mode Configuration Switch
  • Indicators: Signal, Temperature, ICL (Inteligent Clip Limiting), PMS (Power Management System)
  • Connectors:
    • Input: 2 x XLR
    • Line Output: 2 x XLR
    • Speaker Output: 2 x Speakon
  • Power Supply: 230 V - 50 Hz
  • Dimensions (W x H x D): 483 × 88.9 × 310 mm

This professional stereo power amplifier, working in class-H mode, provides 2x800W, at an efficiency of around 85%.

A passive transformer based power supply and hand selected components makes this power rating possible with exceptional audio quality and absolute reliability, even in the 2 Ohm mode. The output stage is fully protected against over-temperature, short circuit, RFI and equipped with soft start circuit and temperature-controlled fan cooling.  The integral soft clip limiter protects against damage to the connected loudspeakers.  The activity of a protective circuit, signal and limiter is shown for each channel by LEDʼs.

 

AMPLIFIER SPECIFICATIONS
Power output stereo 2Ω:2 x 800 Watt rms 
Power output stereo 4Ω:2 x 650 Watt rms 
Power output stereo 8Ω:2 x 350 Watt rms 
Power output bridged 4Ω:1600 Watt rms 
Power output bridged 8Ω:1300 Watt rms 
Frequency Response:20 Hz ÷ 20 kHz  
Signal/noise rate:> 103 dB 
Crosstalk:> 70 dB 
Distortion (THD+N): 
Intermodulation: 
Damping factor:200:1 (8 Ω) 
Slew rate:50 V/μS 
INPUT SECTION
Input connector:2 x XLR balanced, 6,3mm jack unbalanced 
Input sensitivity:0 / 0.775 dBm/V RMS 
Input impedance: 20.000 kΩ 
Controls:Volume control for each channel 
OUTPUT SECTION
Output connector:2 x Neutrik Speakon 4 ways 
SYSTEM PARAMETERS
Cooling:Two-speed fan 
Protections:Temperature, DC, RFI short circuit, Soft-Start, Thermal on transformer 
POWER REQUIREMENT
Operating voltage:220÷240 / 110÷120 ~ 50 / 60 V ~ Hz  
Max.current:7.5 A 
Power Consumption:2700 W 
PHYSICAL SPECIFICATIONS
Height:88 / 3.46 mm/inch 
Width:483 / 19.01 mm/inch 
Depth:455 / 17.91 mm/inch 
Net Weight:19.5 / 42.98 Kg/Lbs 
SHIPPING INFORMATION
Package height:150 / 5.9 mm/inch 
Package width:555 / 21.85 mm/inch 
Package depth:525 / 20.66 mm/inch 
Shipping Weight:20 / 44.09 Kg/Lbs

 

The new DEEP2 amp series features four class-H power amplifiers with toroidal core offering amplifying levels from 2 x 400 W till 2 x 810 W at 4 Ohm. During the development of this series we attached a great importance to the reliability and the durability of the amps in continuous operation, this is why we used exclusively high end and selected components for the construction of these products. The DEEP2 series features a Clip Limiter as well as every common protection circuits. These amps are 2 Ohm and 4 Ohm (bridge) stable in continuous operation. On the rear panel you will find all the common In- and Outputs. The DEEP2 series will convince every user thanks to a dynamic and very clear sound which is perfectly adapted for Subbass applications as well as for multifunctional speakers. All models are lightweight and feature a robust steel plate housing and a very user friendly and compact design. The DEEP2 series will prove to be a profitable and reliable choice for bands, renting companies and professional users thanks to its excellent price/performance ratio. Product type Power Amplifiers
Type PA Power Amplifiers
Rated ouput power (1kHz @ 2 Ohms) 2 x 800 W
Rated ouput power (1kHz @ 4 Ohms) 2 x 650 W
Rated ouput power (1kHz @ 8 Ohms) 2 x 450 W
Rated ouput power (1kHz @ 4 Ohms, bridged) 1600 W
Rated ouput power (1kHz @ 8 Ohms, bridged) 1300 W
Output circuitry Class H
Frequency response 20 - 20000 Hz
THD < 0.1 %
Signal-to-noise ratio 106 dB
Damping factor > 400
Crosstalk >80 dB
Gain 39 dB
Input sensitivity 0.775 V
Protection circuits clip limiter , DC protection , short circuit , thermal overload
Controls 2 x volume , bridge/stereo mode selector , ground lift , mains switch (on/off)
Indicators level , Limit , Power , Protect (protection circuit engaged) , Signal
Loudspeaker outputs 2
Speaker output connections Speakon compatible , Terminal posts
Cooling highly efficient, automatic
Operating voltage transformer
Operating voltage 230 V AC / 50-60 Hz
Weight 15,9 kg
Features Volex mains socket

- Power levels matched to the most popular speakers used by entertainers
- Optimized for maximum real-world headroom into 4 ohm and 8 ohm speaker systems
- Inputs: XLR, 1/4" TRS and phono input connectors for compatibility with any source
- Outputs: Speakon(R) combo accepts, 1/4" (TS) plugs or Speakon 2-pole and 4-pole plugs (connects 2 poles only). Binding posts support all other speaker wiring systems
- Minimum depth chassis (10.1“/257 mm) fits in compact, inexpensive effects racks
- Lightweight - GX7 is only 15.5 lbs (7 kg)
- Detented gain controls for precise setting and matching of sensitivity
- GuardRail(TM) automatically protects the amplifier and loudspeakers from damage due to temperature rise or overdrive without shutting down the show
- Front panel LEDs monitor Power, Signal and Clipping
- Subwoofer/Satellite crossover built-in
- 230V 16.5 lbs (7.5 kg)

Weight8.00 kg20.00 kg15.90 kg7.00 kg17.00 kg9.80 kg
DimensionsN/AN/AN/AN/AN/AN/A
Additional information
Weight 8.00 kg
Weight 20.00 kg
Weight 15.90 kg
Weight 7.00 kg
Weight 17.00 kg
Weight 9.80 kg