Content |
The DM-1S is a small pencil condenser designed specifically for snare drum. It is a companion mic to the DM-1T tom microphone, from which it differs only in voicing.
Both mics are part of Sontronics application-specific microphone series, which also includes the DM-1B and the DM-1B kick-drum mic.
The DM-1T and DM-1S are physically identical. They are compact (length approximately 10cm) to facilitate placement above toms and snare without being in the way of cymbals.
The DM-1T tom mic and DM-1S snare mic are both end-address, with a 24mm true condenser capsule. Both produce a Cardioid pickup pattern.
Specifications
Pickup Patterns Pads & Filters
Cardioid (8 mV/Pa; 30 - 20,000 Hz)
Pad: -10dB (Via Switch)
Capsule Dimensions Impedance SPL/Noise
Capsule diameter: 24mm
200 Ohms (Low) Max SPL: 135 dB
Self-noise: 14.0 dB(A)
Weight Length Max Diameter Interface(s)
n/a 100mm (3.94'') n/a
3-pin XLR male (1)
Power Specifications
Requires phantom power
Phantom voltage: 48±4v
|
The e 865 is a fully professional super-cardioid vocal microphone utilising the
very best in condenser microphone technology to achieve new standards of
quality and sound. The microphone capsule insorporates special blast/pop
protiction plate to shield the diaphragm from excessive sound pressure levels.
Features
Rugged metal body
Extended dynamic response with pronounced presence and vocal 'punch'
Excellent feedback rejection
Very good rejection of handling noise
Very high sound pressure handling capability
Delivery Includes
1 e 865
1 microphone clip
1 pouch
Technical Data
Pick-up pattern super cardioid
Sensitivity in free field, no load (1kHz) 3 mV/Pa
Max. Sound pressure level (aktiv) 150 dB
Nominal impedance 200 Ohm
Min. terminating impedance 1000 Ohm
Dimensions d 47 x 193 mm
Weight w/o cable 311 g
Frequency response (microphone) 40.....20000 Hz
Phantom powering 12 - 48 V
|
Cardioid Condenser with 10dB Attenuator and 3 Position Low-Cut Filter
One of the world's great studio microphones, the SM81 provides precise, detailed sound reproduction, is excellent for studio recording, and is rugged enough for live sound reinforcement.
- A standard for acoustic instruments, including guitar and cymbals
- Selectable, low-frequency response -- either flat, 6dB/octave roll-off, or 18 dB/octave roll-off
- Built-in, switchable 10 dB attenuator for use in high SPL situations
- Phantom power only
- Windscreen included
- Low noise and high output clipping
- Cardioid condenser
- Frequency response: 20 to 20,000 Hz
| The e 945 is a fully professional super-cardioid vocal microphone which cuts
through the mix and offers a smooth, natural sound. Its warm tonal response
is matched with rugged construction and excellent feedback rejection.
Features
Rugged metal body
Advanced shock-mount design
Consistent on-/off-axis response
Hum compensating coil
Made in Germany
Delivery includes a pouch and a microphone clamp
Delivery Includes
1 e 945
MZQ 800 microphone clamp
Pouch
Technical Data
Pick-up pattern Super-cardioid
Frequency response (microphone) 40.....18000Hz
Sensitivity in free field, no load (1kHz)
2,0mV/Pa bei 1 kHz = -54dB (0 dB = 1V/Pa) = -74 dB (0 dB = 1V/ubar)
Nominal impedance 350 Ohm
Min. terminating impedance 1000 Ohm
Dimensions 47 x 186 mm
Weight 330 g | NT3 - Versatile & Dependable
Stylish and modern, the NT3 is a studio and location workhorse. With both
48V phantom and internal 9V battery operation, this R?DE is at home anywhere.
Intended for studio, stage and location work, this versatile handheld or stand
mounted microphone incorporates a true externally polarized condenser (hyper-
cardioid polar response) transducer with an internal capsule shock mounting
system, and an ultra-low noise electronic circuit that has a high immunity to R.F.
interference. Incorporating a rugged welded and heat-treated mesh head and all
metal body. The NT3 is supplied in a zip pouch with a windshield, stand mount
and thread adaptor.
SPECIFICATIONS:
Acoustic principle: Externally polarised 19mm (3/4“) condenser
Directional pattern: Hypercardioid
Frequency range: 20Hz-20 kHz
Output impedance: 200?
Signal noise ratio din iec 651: > 77dB (per IEC268-15)
Equvalent noise: 123dB (per IEC268-15)
Power supply voltage: P48, P24, P12 phantom 9V battery
Weight without battery: 371g
Weight with battery: 680g |
The super-cardioid e 614 is a permantly polarized condenser microphone
designed for demanding applications which require a wide frequency response,
high SPL, fast transient response and a compact design. With its frequency
response of 40 Hz to 20 kHz, the e 614 is able to capture the full sound of the
instrument, while its super-cardioid pick-up pattern isolates the microphone
from other on-stage signals.
An excellent microphone for percussion instruments, the e 614 is also an ideal
choice for woodwind and string instruments. Its excellent acoustic properties
also make it a valuable tool for home recording.
Features
Rugged design Effective rejection of incidental rear noise Excellent directivity
across the whole frequency range Full, natural sound High maximum sound
pressure level
Wide frequency response
Delivery Includes
Microphone pouch
Microphone clip MZQ 100
Technical Data
Frequency response 40 Hz ... 20 kHz
Transducer principle permanently polarized condenser
Pick-up pattern supercardioid
Sensitivity in free field, no load (1kHz) 3 mV/Pa = - 50dB (0 dB = 1 V/Pa)
Nominal impedance 50 Ohm
Min. terminating impedance 1 kOhm
Maximum sound pressure level (passiv) 139 dB/SPL
Equivalent noise level 24 dB(A)
Equivalent noise level weighted as per CCIR 468-3 35 dB
Dimensions ? 20mm, L = 100mm
Weight w/o cable 93 g
|
Reviews
There are no reviews yet.