| Content | Genuine Stylus Tonar 734-DE AKAI RS-100 PC100
Specs:
- Stylus RS100
- Elliptical Diamond Tip 0.3 x 0.7 mil
- Tracking Force: 1.5 – 2.5 grams tracking pressure
- Stylus Color: Black
For Cartridges: PC-100, PC-120, Eagle P-750, P-750E, YM108, YM308
For Needles: N 45, Akai RS 100
Fits the following Turntables models: Akai AP 100, AP 101, AP 102, AP 206, AP 206 C, AP 207, AP 306, AP 306 C, AP 307, AP D 02, AP Q 4, P 103, Hitachi DS-ST-103, DDT300, HT400, MCD100, SDT1SU, SDT300, SDT400, SDT 7660
Note: This needle was installed on the following turntable models when they were sold.
If the original cartridge has been replaced with a different type, this needle won’t fit.
Match your old needle to the picture before you make a purchase.
|
Ortofon 14 Stylus Technical Data
Frequency range 20-22.000 Hz
Frequency response 20-20.000 Hz + 2 / - 2 dB
Tracking ability at 315Hz at recommended tracking force *) 70 µm
Compliance, dynamic, lateral 25 µm/mN
Stylus type Elliptical
Stylus tip radius r/R 8/18 µm
Equivalent stylus tip mass 0,5 mg
Tracking force range 1,0-1,5 g (10-15 mN)
Tracking force, recommended 1,25 g (12,5 mN)
Tracking angle 20°
Stylus colour Black
Recommended for following cartridges TM 14U |
|
DJ E Replacement stylus
Basic model for scratch and back-cueing. Outstanding rigidity by extra-strengthened cantilever
Features Special Elliptical stylus and a special developed and extremely balanced cantilever.
Not only does the cartridge have a most sufficient tracking ability, it is also nearly unbreakable and provides the DJs with the most needed stringency. Furthermore, it equals very low record wear, an advantage for busy DJ.
The DJ series has been known to many as the "jack of all trades," with improved tracking, alongside of accurate sound reproduction. Featuring a low wear stylus design, the DJ provides excellent groove handling, even with less weight applied.
DJ E Stylus Technical data
Output voltage at 1000Hz, 5cm/sec. - 6 mV
Channel balance at 1kHz - 2 dB
Channel separation at 1kHz - 23 dB
Channel separation at 15 kHz - 15 dB
Frequency range at -3dB - 20-22.000 Hz
Frequency response - 20-20.000 Hz +/-2 dB
Tracking ability at 315 Hz at recommmende tracking force - 80 μm
Compliance, dynamic lateral - 9 μm/m N
Stylus type - Special Elliptical
Stylus tip radius - r/R 13/25 μm
Tracking force range - 2,0-4,0 g (20-40 mN)
Tracking force recommended - 3,0 g (30 mN)
Tracking angle - 20°
Internal impedance, DC resistance - 750 Ohm
Internal inductance - 450 mH
Recommended load resistance - 47 kOhm
Recommended load capacitance - 200-600 pF
Cartridge weight - 18,5 g
Compatible with cartridges - DJ S
| Ortofon 520MKII Stylus Technical Data
- Frequency range 20-23.000 Hz
- Frequency response 20-20.000 Hz + 2 / - 3 dB
- Tracking ability at 315Hz at recommended tracking force 70 µm
- Compliance, dynamic, lateral 25 µm/mN
- Stylus type Nude Elliptical
- Stylus tip radius r/R 8/18 µm
- Equivalent stylus tip mass 0,3 mg
- Tracking force range 1,25-1,75 g (12,5-17,5 mN)
- Tracking force, recommended 1,5 g (15 mN)
- Tracking angle 20°
- Stylus colour Black
- Recommended for following cartridges Series 520 Mkll, 520, 520 P
|
|
Genuine Original Stylus for OM 20, OM 20 Super, OMP20, LM 20, Concorde 20, TM 20
Nude Elliptical
| Stylus 2M Black
| Technical data |
|
| Frequency range |
20-31.000 Hz |
| Frequency response |
20-20.000 Hz + 2 / - 0 dB |
| Tracking ability at 315Hz at recommended tracking force *) |
80 µm |
| Compliance, dynamic, lateral |
22 µm/mN |
| Stylus type |
Nude Shibata |
| Stylus tip radius |
r/R 6/50 µm |
| Tracking force range |
1,4-1,7 g (14-17 mN) |
| Tracking force, recommended |
1,5 g (15 mN) |
| Tracking angle |
20° |
| Stylus colour |
Black |
|
|
| Recommended for following cartridges |
2M Black |
*) Typical value |
Reviews
There are no reviews yet.