Content | TONAR DIAMOND 822DS
For Sharp Cartridges STY 117, Aiwa AN36 High Quality Stylus Spherical Diamond for Turntable.
Specs:
- Spherical Diamond Tip Needle 0.7 mil
- Tracking Force: 1.5 – 3.0 grams tracking pressure
- Stylus Color: Grey
- 16 or 33 or 45rpm NOT for 78rpm ,
- Made Japan
For Cartridges: Sanyo MG 48, Sharp C 117, JVC MD 1011, MD 1013
For Needles: STY-117 Aiwa AN 36, Fuji Onkyo MM 107, Mitsubishi 3 D 33 M, 3D-48 M, NEC LP 60 D, Philips D 64, Sanyo ST 48 D, ST 107, 2611 K, 2711, 2811, Sharp STY 117, Victor / JVC DT 25 H DT 29.
Fits the following Turntables models:
Benytone M 8125 L, M 9130 L, Blaupunkt RST 300, Crown SHC 5003, Sharp SG-1, ST-107, STY-117, 33 and 45 rpm, Aiwa AN36, LX100E, APD35, AN-36, LX-100E, AP-D35, SHARP 70H, RP10, RP11, RP11H, RP15, RP31, RP31H, RP31HB, RP400X, RPLL, SG2, SG270, SG290, SG2H, SGL, 70-H, RP-10, RP-11, RP-11H, RP-15, RP-31, RP-31H, RP-31HB, RP-400X, RPLL, SG-2, SG-270, SG-290, SG-2H, SANYO D822, DCW4800, DCX989, GXT4580, JXT4800, SG2H, TP1200, D-822, DC-W4800, DC-X989, GXT-4580, JXT-4800, SG-2H, TP-1200, SANYO-FISHER N107A, Fisher MCE 40, MCE 402, MCE 4025, MCE 4040, MT 640, 4040, 820 System, 850 System, Cybernet, Diatone, Grundig RST 300, JVC / Victor CCL 3, CSL 2100, Loewe Opta RST 300, Mitsubishi 3D-48-M, DP 540, DP 74 B, DSS 7600, DSS 8700, DSSS 60 M, DSSS 61, DSSS 61 M, DSSS 62, DSSS 62 M, National SL1011, Nikko P 47, 319, 390, Philips GC 008, GC 808, Rotel MPC 7, RP 400 X, NEC LP-60-D, Samsung 150, 350, Sanyo ST-107, ST-48-D, STG-2D, STY-117, D 822, GXT 4580,Teleton MPC 7, MST 6, P 340, P 850, Tensai 3005, Transonic P 47, 319 System, 390 System, Uher 120 Compact, Universum T 1722002, Victor / JVC CCL 3, CSL 2100, MSL 801, SSL 105 TS, SSL 115 TS, SSL 3300, SSL 4500, SSL 48 D, SSL 5000, SSL 6000, SSL 66 D, SSL 77 TS, SSL 87 D, SSL 89 TS, SSL 96 TS, SSL 97 D, SSS 200.5 and more.
Note: This needle was installed on the following turntable models when they were sold.
If the original cartridge has been replaced with a different type, this needle won’t fit.
Match your old needle to the picture before you make a purchase.
| Replacement stylus for the Carl Cox Signature CS-1 Cartridge.
* Frequency response: 20 to 22,000Hz
* Output: 6mV
* Channel separation nominal: 32dB
* DC resistance: 430 ohms/ch
* Inductance: 400mH/ch
* Weight: 18.0g
* Channel balance: within 1.5dB
* Tracking force: 3–6g
* Recommended load: 47K ohms 200pf
* Stylus tip: fine circular diamond
* Application: club and mobile DJs, high output |
Stylus 5 Spherical
Technical data |
|
Frequency range |
20-20.000 Hz |
Frequency response |
20-15.000 Hz ± 2 dB
|
Tracking ability at 315Hz at recommended tracking force *) |
60 µm |
Compliance, dynamic, lateral |
15 µm/mN |
Stylus type |
spherical |
Stylus tip radius |
R/18 µm |
Equivalent stylus tip mass |
0,5 mg |
Tracking force range |
1,75-2,25 g (17,5-22,5 mN)
|
Tracking force, recommended |
2 g (20 mN)
|
Tracking angle |
20° |
Stylus colour |
Black |
|
OM 5,OMB 5, LMA 5, SMB 5 |
*) Typical value |
DJ E Replacement stylus
Basic model for scratch and back-cueing. Outstanding rigidity by extra-strengthened cantilever
Features Special Elliptical stylus and a special developed and extremely balanced cantilever.
Not only does the cartridge have a most sufficient tracking ability, it is also nearly unbreakable and provides the DJs with the most needed stringency. Furthermore, it equals very low record wear, an advantage for busy DJ.
The DJ series has been known to many as the "jack of all trades," with improved tracking, alongside of accurate sound reproduction. Featuring a low wear stylus design, the DJ provides excellent groove handling, even with less weight applied.
DJ E Stylus Technical data
Output voltage at 1000Hz, 5cm/sec. - 6 mV Channel balance at 1kHz - 2 dB Channel separation at 1kHz - 23 dB Channel separation at 15 kHz - 15 dB Frequency range at -3dB - 20-22.000 Hz Frequency response - 20-20.000 Hz +/-2 dB Tracking ability at 315 Hz at recommmende tracking force - 80 μm Compliance, dynamic lateral - 9 μm/m N Stylus type - Special Elliptical Stylus tip radius - r/R 13/25 μm
Tracking force range - 2,0-4,0 g (20-40 mN) Tracking force recommended - 3,0 g (30 mN) Tracking angle - 20° Internal impedance, DC resistance - 750 Ohm Internal inductance - 450 mH Recommended load resistance - 47 kOhm Recommended load capacitance - 200-600 pF Cartridge weight - 18,5 g
Compatible with cartridges - DJ S
| Ortofon 310 Stylus Technical Data
- Frequency range 20-20.000 Hz
- Frequency response 20-18.000 Hz + 2 / - 3 dB
- Tracking ability at 315Hz at recommended tracking force 60 µm
- Compliance, dynamic, lateral 20 µm/mN
- Stylus type Elliptical
- Stylus tip radius r/R 8/18 µm
- Equivalent stylus tip mass 0,5 mg
- Tracking force range 1,25-1,75 g (12,5-17,5 mN)
- Tracking force, recommended 1,5 g (15 mN)
- Tracking angle 20°
- Stylus colour Grey
- Recommended for following cartridges Series 310 Universial
|
|
The Ortofon Arkiv stylus Boasts clear and accurate sound reproduction and remarkable stereo imaging, making it perfectly suited for sampling, transcription, and numerous other professional applications.
Replacement stylus to be used in Ortofon Arkiv OM and Concorde cartridges. Growing demand for the ability to transcribe vinyl to digital formats has prompted the creation of Ortofon Arkiv cartridge - a cartridge specially designed to provide optimized sound quality specifically for recording purposes. The Ortofon Arkiv cartridge boasts clear and accurate sound reproduction and remarkable stereo imaging, making it perfectly suited for sampling, transcription, and numerous other professional applications.
Ortofon Arkiv Cartridge Specifications:
Frequency response: 20 to 20.000 Hz Output: 6mV Channel separation nominal: 23dB Inductance: 450mH/ch Weight: 5g Tracking force: 3 grams Recommended load: 47K ohms 200pf Stylus tip: Special elliptical |
Reviews
There are no reviews yet.