ROCKTRON MIDI XCHANGE MIDI FOOTCONTROLLER

Πληροφορίες

Midi Footcontroller

The Marshall PEDL-10021 5-way LED foot controller can be used of any of the TSL Series Amplifiers.

The Marshall TSL Foot Controller switches between channels, and can also be used as an on/off control for the Reverb and Effects loop.

A must have for any gigging guitarist.
LED lights for dark stages.
5 way selection controller.
Some of the TSL Range already include footswitches.

Ποδοδιακόπτης συμβατός με τα παρακάτω μοντέλα:

• CRUSH 20 CRUSH 20RT & CRUSH 35RT (CHANNEL)
• CRUSH PRO SERIES (CHANNEL OR REVERB)
• TH30 AND TH100 (CHANNEL)
• DUAL TERROR (CHANNEL)
• AD30 (CHANNEL)
• OR 50 (MASTER VOLUME DEFEAT)
• CUSTOM SHOP 50 (EQ LIFT NOTE: THE LED WILL NOT ILLUMINATE AS THE CUSTOM SHOP USES PASSIVE SWITCHING CIRCUITRY)
• ROCKERVERB (REVERB OR CHANNEL)
• DUAL DARK (CHANNEL OR ATTENUATOR)
• OB1-300 & OB1-500 (BLEND CONTROL)

The Palmer PEABO is a balanced switcher with one input and two outputs. This makes it the perfect choice for routing a signal to one of two different inputs.

• Onstage, switch your vocal mike between FOH and monitor mixing desk so you can communicate with the monitor mixer or the band in private.
• Two different sound configurations. Suppose you sometimes want a different effect or sound on your microphone, for example, a "telephone effect" or more Hall. Run both outputs of the PEABO to two channels of the mixing desk - now you can configure these differently and toggle between the two channels onstage whenever you want.
• You can also use the PEABO to address two different rooms or zones selectively.

Switching is controlled by a sturdy latching foot switch; the selected output is indicated by a red LED. Slide switches make it possible to select various attenuation levels (6, 15 or 21 dB attenuation) individually for both outputs. A ground lift helps to avoid ground loop hum.

Housed in a solid metal case with extended edges for optimum protection of the in- and outputs. Pre-drilled holes permit simple and secure mounting in a rack or on a pedal board.

The PEABO's strictly passive circuitry means that it requires no power supply at all. A 9-volt block battery is only required to power the LED.

• Function on/off
• Without LED
• 5m cable
• Screwed steel housing
• Kink protection and cable feed-through
• Mono jack
• “Channel" label
• Suitable for all amplifiers with simple on/off switch
• Dimensions: 84 x 45 x 112 mm
• Compatible with: Marshall DSL50, DSL100, DSL401, EL34 50/50, EL34 100/100, EL84 20/20, MB30, MB60, MB150, G30RCD, G50RCD, G80RCD, G100RCD, JCM600, JCM601, JCM602, JTM612, JTM60, JTM622, JTM610, JTM615, MG30DFX, JTM312, JTM310, VS30R, 1962, 2555SL, 2100, 2500, 7400, 7200, 72115, 72410, 9100, 9200, 8040, 3520, 5522, 9004