| Content |
Technical Data
RF frequency range 518 ..... 866 MHz
Transmission/receiving frequencies 1440
Presets 4
Switching bandwidth 36 MHz
Peak deviation +/- 48 kHz
Compander HDX
Frequency response (microphone) 40.....18000 Hz
Signal-to-noise ratio > 110 dB(A)
THD, total harmonic distortion
In compliance with ETS 300422 , ETS 300445 , CE , FCC
Antenna connector 2 BNC, 50 Ohm
Audio-XLR connector 6,3 mm
Audio output level (balanced) XLR: +18 dBu max
Audio output level (unbalanced) Jack: +10 dBu max
Power supply 10,5 - 16 V DC battery AA (Mignon)
Dimensions (Receiver) 212 x 145 x 38 mm
Weight (Receiver) 1100 g
RF output power 30 mW
Power supply 2x 1.5 V battery AA (Mignon)
Operating time (transmitter) >8 h
Dimensions (Transmitter) d= 50 mm, l= 225 mm
Weight (Transmitter) 450 g
Transducer; Microphone type dynamic
AF sensitivity 1 mV/Pa
Sound pressure level (SPL) 154 dB(SPL) max.
Pick-up pattern super-cardioid
|
System Specifications
- Operating Frequencies: UHF band
- Band C: 541.500 MHz to 566.375 MHz (996 frequencies)
- Band D: 655.500 MHz to 680.375 MHz (996 frequencies)
- Band I: 482.000 MHz to 507.000 MHz (1001 frequencies)
- Not all frequencies are available in all areas. Please check with local regulations.
- Minimum Frequency Step: 25 kHz
- Modulation Mode: FM
- Maximum Deviation: +/-35 kHz
- Dynamic Range: > 110 dB (A-weighted), typical
- Total Harmonic Distortion: < 1% (at 1 kHz, +/-17.5 kHz deviation)
- Operating Range: 100 m (300\'), typical
- Open range environment with no interfering signals.
- Operating Temperature Range: -5o C to +45o C (23o F to 113o F)
- Battery and LCD performance may be reduced at very low temperatures.
- Frequency Response: 70 Hz to 15 kHz (+1 dB, -3 dB)
Receiver
- Receiving System: True diversity
- Image Rejection: 60 dB nominal, 55 dB minimum
- RF Sensitivity: 20 dBuV at 60 dB S/N ratio
- Maximum Output Level: XLR, balanced: +9 dBV; 1/4-inch (6.3 mm), unbalanced: +7 dBV
- Antenna Input: BNC-type, 50 ohms
- Bias voltage 12V DC, 60 mA, each
- Power Requirements: 12-18V DC, 500 mA
- Dimensions: 210.0 mm (8.27“) W x 164.4 mm (6.47“) D x 44.0 mm (1.73“) H, not including BNC connectors or feet.
- Net Weight: 1.1 kg (38.8 oz), without accessories
- Accessories Included: Two flexible UHF antennas; AC adapter (country dependent); rack-mount adapters
Handheld Transmitter
- RF Power Output: High: 30 mW; Low: 10 mW, (switchable), at 50 ohms
- Spurious Emissions: Following federal and national regulations
- Microphone Element: ATW-T341b: Dynamic cardioid
- Batteries: Two 1.5V AA, not included
- Battery Life: High: 6 hours (alkaline)
- Low: 8 hours (alkaline)
- Depending on battery type and use pattern.
- Dimensions: ATW-T341b: 237.0 mm (9.33“) long, 48.0 mm (1.89“) diameter
- Net Weight: ATW-T341b: 284 g (10.0 oz), without batteries
- Accessory Included: AT8456a Quiet-Flex(TM) stand clamp Dimensions and Weight in PackagingChannel D (655.500 MHz to 680.375 MHz)Shipping Weight: 6 lbs Shipping Dimensions: 15 x 14 x 4 in Channel I (482.000 MHz to 507.000 MHz)Shipping Weight: 6 lbs Shipping Dimensions: 15 x 14 x 4 in Channel C (541.500 MHz to 566.375 MHz)Shipping Weight: 6 lbs Shipping Dimensions: 16 x 14 x 4 in
|
The Audio Technica 3000 Series wireless systems provide reliable, professional UHF technology for the most demanding of applications. The ATW-3171 is a frequency agile, true-diversity handheld wireless microphone system including the ATW-R310 receiver and ATW-T371 handheld Transmitter.
The ATW-R310 receiver features frequency adjustable UHF reception, allowing access of up to 200 user selectable channels. Diversity reception allows 2 build-in, independent receivers to relay on a single frequency for the strongest possible reception. The rear panel reveals both unbalanced 1/4" Phone and balanced XLR outputs. A comprehensive back-lit LCD display reveals channel and frequency settings, signal status and transmitter battery status. The receiver also features a ground lift switch, convenient in settings where bad power feeds result in ground hum and noise on the output stage.
The ATW-T371 handheld transmitter features an ATM710 cardioid condenser element. The cardioid polar pattern effectively minimizes noise and feed-back at the off-axis sections. The condenser element increases sensitivity and provides details, accurate audio reproduction.
Frequency Agile The system operates on UHF frequencies allowing greater channel selectability and range. The transmitter and receiver feature 200 user selectable channels. Diversity Reception The ATW-R310 receiver features dual internal receivers. The receivers relay between each-other, vying for the strongest reception while minimizing noise and signal drop-out. ATW-T371 Handheld Transmitter The handheld transmitter features a cardioid capsule which minimizes noise at the off-axis sections of the microphone.
| System |
|---|
| Type of System |
UHF Frequency Agile Handheld |
| RF Carrier Frequency Range |
Band D - 655.500 MHz - 680.375 MHz |
| Approx. Working Range |
300 feet |
| Overall Frequency Response |
70Hz to 15kHz |
| Signal-to-Noise Ratio |
110 dB at 35 kHz deviation (IEC-weighted), maximum modulation 75 kHz |
| # Of Channels |
200 Channels |
| # Of Simultaneous Systems |
6 |
| Receiver |
|---|
| Type of Receiver |
Dual independent receivers, automatic-switching diversity |
| Type of Outputs |
Unbalanced: 1/4" TS (“mono“) phone jack
Balanced: XLRM-type |
| Headphone Monitoring |
No |
| Power Requirements |
120V AC 60 Hz; 12-18V DC, 500 mA, center positive, with external supply |
| Battery Type/Approx. Life |
AC Powered Only |
| Display |
Back-Lit LCD Display & Battery / Signal Status LED |
| Mounting Options |
Table Surface / Rack Mountable rack ears included |
| Antenna Type |
Internal |
| Dimensions |
8.27 x 1.93 x 6.93" (210.0 x 49.0 x 176.0mm) (WxHxD) |
| Weight |
9.9 oz (280 grams) |
| Transmitter |
|---|
| Type of Transmitter |
Frequency Agile Handheld |
| Type of Input Connector |
not applicable |
| Type of Microphone |
ATM710 Condenser Element |
| Polar Pattern |
Cardioid |
| Interchangeable Mic Heads |
No |
| Battery Type/Approx. Life |
(2) 1.5v AA Alkaline not included |
| Mute Switch |
Power / Mute switch dual function |
| Level Control |
No |
| Antenna Type |
BNC Flexible UHF |
| Display |
Back-Lit LCD Display & Battery / Signal Status LED |
| Dimensions |
9.33 x 1.89" (237.0 x 1.89)(Length x Diameter) |
| Weight |
2.4 lbs (1.1 kg) |
| Packaging Info |
|---|
| Package Weight |
5.5 lb |
| Box Dimensions (LxWxH) |
15.0 x 13.25 x 3.75“ |
|
For vocalists, performers and active spoken word presenters, the XD-V55 family sets new standards for reliability, ease of use and superior audio quality. All XD-V55 systems – both handheld and bodypack – feature patented digital technologies that deliver sound so impressive they inspire confident, great sounding performances. Including a handheld system featuring four superb microphone models, a lavalier system with three EQ filter models and a headset featuring a high-end omnidirectional microphone capsule, the XD-V55 family is the right choice. The mic modeling delivers great sound, which remains pristine from your lips to your audienceʼs ears thanks to the 24-bit performance. DCL™ (Digital Channel Lock) technology keeps your signal safe the entire time.
|
The WS-5200 includes a handheld wireless microphone WM-5220 and a diversity tuner WT-5810. The WM-5220 Wireless Microphone employs an electret condenser microphone capsule and is suitable for any applications. Thanks to the PLL-synthesizer system, 64 different operating frequencies are made available. A high output power ensures stable radio signal transmission. The WT-5810 is a PLL-synthesizer controlled double superhetrodyne diversity tuner designed to be used with a UHF wireless system. It employs a compander noise reduction circuit to minimize the influence of ambient RF noise.
| Product Composition | Handheld wireless microphone WM-5220 …1, Diversity tuner WT-5810 …1 | | Frequency Range | 636 - 865 MHz(*2), UHF | | Tone Frequency | 32.768 kHz | | Operating Temperature | -10 ℃ to +50 ℃ | | Accessory | AC adapter(*3) …1, Screw driver …1,
Microphone holder (with stand adapter) …1, Strage case …1 |
| Free yourself! for live sound, presentations and installations
The WMS420 wireless microphone system provides a highly flexible as well as easy to use solution. The ultra high frequency system is set up within seconds and is equally suitable on stage as well as in locations where a single- or multi channel solution is needed.
The entire WMS420 wireless system consists of the SR420 stationary receiver, HT420 handheld transmitter and the PT420 pocket transmitter. The HT420 handheld transmitter is available with the patented D5 dynamic microphone acoustic. This capsule guarantees maximum rejection against feedback, reduced handling noise and the famous AKG sound. Both transmitters are shipped with charging contacts that enable the use of rechargeable batteries. Moreover the transmitters offer exceptional eight hours of operation time from a single AA size battery, which dramatically reduces the operating costs in day-to-day use.
The detachable receiver antennas allow the use of professional accessories, such as antenna splitters and remote mounted directional antennas for multi channel systems. The WMS420 series includes three different bodypack sets. The head-worn set includes the high performance C555L condenser microphone. The presenter set includes the professional C417L lavalier microphone. The guitar set includes an instrument cable. With the AKG WMS420 system up to eight channels can be run simultaneously.
Detachable receiver antennas
enable the use of professional RF accessories
Patented state-of-the-art D5 dynamic capsule
cuts through the mix
Transmitters with charging contacts
saves money in day-to-day use and preserves the environment
Compatible with all AKG MicroMics
almost all applications can be covered
Low battery warning indicator
for secure operation |
Reviews
There are no reviews yet.