| Content |
The cutting-edge wireless control system gives Antari W series a simple setting and operation interface. Additionally, the state-of-the-art heater design upgrades the W Series fog machines to a higher level in terms of good quality fog and energy efficiency. In conclusion, Antari W Series bring users to a professional scene in an easier method. Main Features: 1. Intelligent Wireless Control System Each machine comes with a set of wireless receiver and transmitter as standard controller. The working distance of wireless control is 50 meters in open area. 2. Opto-electronic Fluid Sensor When the fluid recipient runs dry,the fluid sensor stops pumping automatically to protect pump from burning. 3. More Efficient New Heat Exchanger Design It can generate drier fog with smaller particles.This leads to a fairly low fog fluid consumption.Compare to the equivalent power consumption heat exchangers, the same quantity of fog fluid in W series can produce 20% more fog than others. 4. New Advanced PCB (Printed Circuit Board) Design The new system can control temperature precisely and rule out the influence from outside environments as much as possible to make W series fog machines be able to work stably between - 20 and + 60 degree Celsius.
Specification
» Power : AC100V/AC120V/AC230V/AC240V,50Hz-60Hz » Heater : 800 W » Output : 3,000 cu.ft / min » First Heat-up Time : 100 seconds » Tank Capacity : 0.8 liter » Fluid Consumption Rate : 60 min / 0.8liter (100% Output) » Remote Included : W-1 Wireless Remote » Weight : 3.8 Kg » Dimensions (mm) : L 315 W 128 H 166 » Liquid Used : Antari FLR / FLG Liquid
| Digital technology and a new Design
The viper 2.6 is a very powerful fog generator. It unites the current digital technology with proven technique and power.
Very powerful output, simple handling and the possibility to connect an external fan are the main new features of this machine.
Features:
- Finest adjustments of the output Digital technology enables fine adjustments of the pump. In steps of 1% the output can be adjusted from 0 - 99%. Thus, any desired effect - from a tiny fog cloud to the thickest continuous fog - can be produced. This allows an individual adaptation to the dimensions of the room. The fan can be adjusted separately from 0 - 99% .
- DMX 512 as standard
The Viper 2.6 can be controlled via DMX 512. Pump and fan can here be controlled separately. Thus, the connected fan can be used as wind machine as well. The connection is done with 5pin-XLR-plugs, two following addresses will be taken. The DMX start address can be adjusted and saved via the control panel. The address remains saved also when the machine is unplugged. The machine can also be controlled with analog (0 - 10V) via a lighting desk or a XLR-remote (option). The adjustment of the fan is done directly at the machine, the pump can be adjusted via the analog control. The connection is done with 3-pin-XLR-plug. A Stand-Alone-Mode is possible as well. The adjustments of the pump and the fan are done directly at the machine. Pressing the start button once, the machine starts running with the pre-adjusted levels.
With the internal timer, the fogging time can be adjsted in seconds, the wait time in minutes and the output in %. Once the timer is activated, the adjusted program will run until the timer is deactivated.
The control panel with LED display and simple symbols allow an easy operation. It also protects the control buttons against dirt.
- Robust flightcase version
The flightcase on wheels protect the inbuild machine and fan and ensures an easy transport and flexible handling. Handles at both sides of the case allow an easy lifting. Removable lids enable direct access to control panels and fluid tank.
Liquid
The following Look fog liquids are available for the Viper 2.6/Viper deLuxe: Quick-Fog (thick, quick disappearing fog liquid) Regular-Fog (thick, long lasting fog liquid) Slow-Fog (thick, extremely long lasting fog liquid)
Safety
The viper 2.6 is equipped with new safety features.
On the front and the back part of the cover there are fixing points for safety bonds.
At both sides of the bottom of the machine are three holes to which a hanging yoke
complete with a collecting tray for fluid drips can be fixed.
Fluid
The following Look-fluids are available for the viper 2.6:
Quick-Fog (thick, quick disappearing fluid)
Regular-Fog (thick, long lasting fluid)
Slow-Fog (thick, extremly long lasting fluid)
Technical Data
Procedure: vaporizing fog generator
Power requirement: 2600 Watt
Voltage: 230 V / 50 Hz
Warm up time: approx. 7 min.
Fluid consumption at max. output
at continuous output: 240 ml/min.
70 ml/min.
Fluid tank capacity: 5 liter
Fog output: adjustable in 99 steps
Output projection: max. 15 m
Fogging time at
external Fan: max. 800 Watt
Air quantity adjustable in 99 steps
Control: DMX 512
0 - 10 V analog
Stand-alone-Mode
Radio remote (Option)
Temperature control: Microprocessor controlled
Overheating protection: Heater block/Thermostat
Pump/Thermal switch
Dimensions (L x W x H): 520 x 230 x 250 mm
Weight without bottle: approx. 12 kg | The party smoke-machine
* Ideal for party-rooms or small discotheques
* Powerful output
* With ON/OFF remote control
* Remote-control connection via 3-pin IEC-socket
* With mounting-bracket
* Quality thermostat
* Overheat protective switch
SPECIFATIONS
Power supply: 230 V AC, 50 Hz ~
Power consumption: 700 W
Smoke-output: approx. 2.5 m
Warm-up time: approx. 5 min.
Fluid consumption: approx. 90 ml/min.
Output volume: approx. 90 m?/min.
Tank capacity: 1 l
Dimensions (LxWxH): 325 x 235 x 230 mm
Weight: 3.5 kg | DMX-controlled smoke-machine
* Powerful smoke-machine for medium-sized discotheques or medium-sized stages
* Control via comfortable remote-control with LCD-display
* LED Fluidlevel-display
* Pump stops automatically when the fluid is depleted
* DMX-control via every standard DMX-controller
* Without mounting-bracket for standing installation
* Wide range of accessories available
SPECIFICATIONS:
| Power supply: |
230 V AC, 50 Hz |
| Power consumption: |
1500 W |
| IP classification: |
IP20 |
| Power connection: |
Fixed power supply cord with safety plug |
| Warm-up time: |
Approx. 2 min |
| Output volume: |
Approx. 430 m³/min |
| Output distance: |
Approx. 3 m |
| Tank capacity: |
2,3 l |
| Fluid consumption: |
Approx. 30 ml/min |
| DMX channels: |
1 |
| DMX input: |
1 x 3-pin XLR (M) mounting version |
| DMX output: |
1 x 3-pin XLR (F) mounting version |
| Control: |
DMX; Wireless remote control; wired remote control |
| Housing color: |
Silver |
| Attachment system: |
Mounting bracket |
| Carrier frequency: |
433,92 MHz |
| Color: |
Silver |
| Dimensions: |
Width: 27,5 cm
Depth: 40 cm
Height: 28 cm |
| Weight: |
6,00 kg |
| Remote control |
| Cable length: |
3 m |
| Battery: |
1 x 12 V 23AE alkaline manganese built-in |
|
MDG Ice Fog Q Low Fog Machine 2850W
Extremely quiet, adjustable low fog output
Self-contained unit on wheels for easy transport
Compartments for accessories
Compatible with remote control timer and DMX interface
Detachable remote control and 8 m (26 ft) cable included
The quietest low fog generator on the market
Low fluid consumption (0.09 L/3 oz per minute at full output)
Can be placed closer to the action
TECHNICAL DATA
ICE FOG Compack
Fluid consumption 0.09 L (3 oz)
(per minute at full output)
Liquid CO2 type Low pressure refrigerated
Liquid CO2 consumption
(per minute) 3 L (6.8 lb) at 1500 kPa (225 psi)
Reservoir capacity 2.5 L (0.66 US gallon)
Fog colour Pure white
Particle size 0.5-4.5 microns
CO2 running time Low pressure version:
180 L (48 US gallon)
canister (DEWAR) = 70 minutes
Warm-up time (maximum) 8 minutes
Fluid type MDG Low Fog Fluid
(M.S.D.S. available on request)
Operating voltage 230 VAC, 50/60 Hz
Power consumption 2,850 W
Dimensions Total length 1.15 m
Operating length 1.71 m
Width 1.51 m
Height 67 cm
Weight 113 kg (250 lb)
Approval CE approved, CSA
and UL pending
Included Remote control ? 8 m (26 ft) 5-pin XLR
extension cable ? 2.5 m (8 ft) long x
13 cm (5 in) diameter fog output conduit
? 3 m (10 ft) insulated low-pressure
liquid CO2 input hose with gauge.
|
Martin JEM CLUB SMOKE Machine - Remote Control
|
Reviews
There are no reviews yet.