Content |
• Easy set-up and use
• Suited for 40cm and 80cm shooters
• Plug-and-play
Showtec's FX Shot is an easy-to-use electric confetti shooter. They are designed to fire prefilled single use electric cannons, which are available in 40cm and 80cm. Confetti or streamers in various colours, even fluor UV and metallic colours are an option. The cannons contain a pressurized nitrogen cartridge which launches confetti up to 12 meters and streamers even 20 meters wide.
Attention:
The FX Shot will be activated by a 230V power source and can therefore be operated very easy by a 230V power switch like the Showtec DJ-Swith (50363). If you like to operate by DMX you can use a Showtec Relay Pack (50752) in combination with a Showtec DMX controller.
Specifications
Size: 13 x 12 cm
Weight: 1.7 kg
Voltage: 230V
Power: 100W
Operation: 230V on/off or DMX by using a switch pack
|
Power: AC 240V, 50 Hz
Output: 18.000 cu. ft/min (509 m³/min)
Tank Capacity: 2,5 L
Fluid type: Fog Fluid
Fluid Consumption Rate: 44 Min/L(100% Output)
DMX: Yes
Heater: 1200W
Weight: 10,9 kg
Dimensions (LxWxH): 458 x 243 x 177 mm
Accessories/ordering info:
Remote: Z-8 (included)
Cable Length: 10M
Connector DMX: 3 Pin XLR in-out
Connector remote: 6,3 mm Stereo Jack
Functions: timer with interval, duration
and volume;
Continuous fogging; manual on/off
Compatible With: Z-1200II, ICE-101, LCU-1
Optional:
Z-9 Wireless Remote: Ordercode: 60698 |
Digital technology and a new Design
The viper nt originate from the continued development and improvement of the Viper fog machine.
It unites the current digital technology with the proven technique and power of its predecessor.
New features guarantee a much more simple operation ? place and fog, reducing the amount of
time needed to set up the machine.
Features
? Control panel
The control panel with LED-display, simple symbols allow for easy operation. It also protects
the control buttons against dirt.
? Finest adjustments of the output
Digital technology makes fine adjustment of the pump possible. In steps of 1% the output can
be adjusted from 0 - 99%. Thus, any desired effect from a tiny fog-cloud to the thickest fog can
be produced. This enables the viper nt to be used in both small and large locations.
? DMX 512 as standard
The viper nt can be controlled via DMX 512. The connection is done with 5pin-XLR-plugs.
The DMX start address can be adjusted and saved via the control panel.
The machine can also be controlled with analog (0 - 10 V) via a lighting desk or via XLR-remote
(option). This connection is done with 3pin-XLR-plugs.
A stand-alone-mode is also possible. The adjustments are done directly at the machine. A short
press at the start button makes the machine run. Therefore a permanent pressing of the start button
is unnecessary.
? Internal timer
With the internal timer the fog time can be exactly adjusted in seconds, the wait time in minutes
and the output in %.
Safety
The change of the design is not only cosmetic, it also has improved safety features.
The viper nt is equipped with new safety features.
On the front and the back part of the cover there are fixing points for safety bonds.
At both sides of the bottom of the machine are three holes to which a hanging yoke complete with
a collecting tray for fluid drips can be fixed.
Fluid
The following Look-fluids are available for the viper nt:
Quick-Fog (thick, quick disappearing fluid)
Regular-Fog (thick, long lasting fluid)
Slow-Fog (thick, extremly long lasting fluid)
Advantages
? DMX as standard, analog and stand-alone-mode
? Internal timer
? Fog output adjustable in steps of 1% (0 - 99%)
? Continuous output
? Easy handling
? Powerful output
? Made in Germany
Technical Data:
Procedure: vaporizing fog generator
Power requirement: 1300 Watt
Voltage: 230 V / 50 Hz
110 V / 60 Hz
Warm up time approx. 7 min.
Fluid consumption
at max. output
at continuous output: 120 ml/min.
. 35 ml/min.
Fluid tank capacity: 5 liter
Fog output: adjustable in 99 steps
Output projection:max. 15 m
Fogging time at
Control: DMX 512
0 ? 10 V analog
Stand-alone-Mode
Radio remote (Option)
Temperature control: Microprocessor controlled
Overheating protection: Heater block/Thermostat
Pump/Thermal switch
Dimensions (L x W x H): 470 x 230 x 240 mm
Weight without bottle: approx. 8,3 kg
|
S-100-II Remote Control SC-2
Antari Fogger accessories.
|
Jem Air Force 1 Fan speed 0 – 2500 rpm 1600 cubic m/hr. Single channel DMX operation. Analogue link sockets. Floor standing or truss mounting. Low voltage multifunctional Remote control. Sealed fan motor. Converts smoke to haze, Wind effects. Projects smoke down long lengths of ducting. Keeps equipment cool: Amp racks, Dimmer racks.
| 1200 watt fogger with DMX
- Continuous output
- Rugged metal housing with handle, mounting bracket and safety eyelet
- Heating element with Unicore technology
- Economic temperature control of the heating element
- Adjustable timer with interval, duration and output volume, continuous output, manual activation
- Output distance: Approx. 7 m
- Control via Wireless remote control (optional); DMX; wired remote control
- For application areas such as: Party room; Clubs/dancing school; restaurants, bars and hotels
- Removable tank with level indication
- Operates on water-based fluid
Package contents
- 1 x device, 1 x user manual, 1 x mounting bracket, 1 x remote control, 2 x knurled screw, 2 x screw, 4 x washer, 1 x container, 1 x tube, 1 x filter
Power supply: |
230 V AC, 50 Hz |
Power consumption: |
1200 W |
IP classification: |
IP20 |
Power connection: |
Fixed power supply cord with safety plug |
Warm-up time: |
Approx. 6 min |
Output volume: |
Approx. 510 m³/min |
Output distance: |
Approx. 7 m |
Tank capacity: |
2,5 l water-based fluid removable tank |
Fluid consumption: |
Approx. 70 ml/min |
DMX channels: |
1 |
DMX input: |
1 x 3-pin XLR (M) mounting version |
DMX output: |
1 x 3-pin XLR (F) mounting version |
Control: |
Wireless remote control (optional); DMX; wired remote control |
Housing color: |
Grey |
Heater: |
1100 W |
Color: |
Grey |
Dimensions: |
Width: 25 cm
Depth: 48 cm
Height: 26 cm |
Weight: |
11,50 kg |
Accessories/ordering info:
Remote: Z-8 (included)
Cable Length: 10 m
Connector DMX: 3 Pin XLR in-out
Connector remote: 6,3 mm Stereo Jack
Functions: timer with interval,
duration and volume;
Continuous fogging; manual on/off
Compatible With: Z-1200II, ICE-101,
LCU-1
Optional:
Z-9 Wireless Remote: Ordernr: 60698
|
Reviews
There are no reviews yet.