| Content |
Ολοκληρωμένος ενισχυτής PA 120 WRMS, με μετασχηματιστή εξόδου 100V, με 3 mic& 2 AUX input, phantom power, high/low ρυθμιστικό EQ & priority mute στο mic 1, βάρος 10.8 kg. Εφαρμογές: σε εγκαταστάσεις 100V, μικρά καφέ, καταστήματα, εργοστάσια, κ.α.
| Specification |
|
|---|
| Power Source | 220 - 240V AC or 24V DC | | Rated Output | 120W | | Power Consumption | 124W (EN60065), 260W(AC operation at rated output, 8A (DC operation at rated output) | | Frequency Response | 50 - 20,000Hz (+/- 3 dB) | | Distortion | Under 1% at 1kHz,1/3 rated power | | Input | MIC 1: -60db 600Ω,electronically balanced, 5-P Din type. MIC 2,3:-60db 600Ω,electronically balanced, 5-P phone jack. AUX 1,2: -20dB, 10kΩ, unblanced, RCA pin jack. Mute: Contact Pin 4 - 5 Closure input (for MIC 1) | | Output | SPEAKER OUT:Balanced (floating)
HIGH IMPEDANCE:83W (100V)
LOW IMPEDANCE: 4Ω (22V)
REC. OUT: Odb, 600Ω unbalanced, RCA pin jack | | Phnatom Powe | DC + 21V (MIC 1) | | S/N Ratio | Over 60dB | | Tone Control | Bass: +/- 10 dB at 100k Hz Treble: +/- 10 dB at 10k Hz | | Muting | MIC1: Mutes other signals by 0 - 30 dB attenuation | | Indicator | Power signal, peak | | Finish | Panel: ABS resin, black/Case: Steel plate, black | | Dimensions | 420 (W) x 100.9 (H) x 360.3 (D) mm | | Weight | 10kg |
|
Specifications | Frequency Response (at 1 watt into 4 ohms, 20Hz - 20 kHz) |
+0/–1 dB
| | Signal to Noise Ratio (below rated 8-ohm power at 1 kHz, A-weighted) |
100 dB
| | Damping Factor (8 ohm): 20 Hz to 400 Hz |
> 500
| | Input Stage |
Input is electronically balanced and employs
precision 1% resistors
| | AC Line Current |
CDi 1000: 11.50A, CDi 2000: 11.93A, CDi 4000: 11.75A
At idle: Draws no more than 45 watts.
| | Crosstalk (below rated power) 20 Hz to 1 kHz |
> 70 dB
| | Input Impedance (nominal) |
20 kilohms balanced, 10 kilohms unbalanced
| Load impedance (note: safe with all types of loads)
Dual
Bridge mono |
2–8 ohms
4–16 ohms
| | Voltage Gain (at 1 kHz, 8 ohm rated output) |
CDi 1000: 30.5 dB, CDi 2000: 32.9 dB, CDi 4000: 34.2 dB
| | Sensitivity (at 8 ohm rated output) |
1.4V
| | Maximum Input Signal |
+22 dBu typical
| | Operating Temperature |
0° C to 40° C at 95% relative humidity (non-condensing)
| | AC Line Voltage and Frequency Configurations Available (± 10%) |
100V, 120V-240V, 50/60 Hz
| | Ventilation |
Flow-through ventilation from front to back
| | Cooling |
Heat sinks and proportional-speed fan
| | Dimensions: Width, Height, Depth (behind mounting surface) |
EIA Standard 19 in. W (EIA RS-310-B)
x 3.5 in. (8.9 cm) H x 12.25 in. (31.1cm) D
| | Net Weight, Shipping Weight |
19 lb (8.6kg), 22 lb (10.0 kg)
| |
XB Series - Intelligent Power
Power Without Compromises.
The XV is designed for paging, music and alarm signals. Versatile, dynamic and
extremely rugged according to IEC286-3. For the highest requirements in safety
and quality.
Sequential power on, alive contacts and incorporated ground fault detection -
the XV is the solution under all conditions. Without the need for additional equipment.
For uninterrupted and troublefree operation.
Needless to say that the Bittner High-End toroidal output transformers in the XV
series are some of the best available.
High Tech SMT Design
Protection Circuits: DC, LF, HF, Thermal, Short Circuit, Current Limiter, 3 ms Muting Delay
PHOENIX
High-End Toroidal Output 100V Transformers
Ground Fault Detection
LED Indicators for POWER, SIGNAL, CLIP, PROTECT, GNDFAULT
Temperature controlled, variable speed low noise fans
Volume Controls at the back
Stereo / Bridged / Parallel Mode
Softstart
Sequential Remote Power On
Alive Contact
Ground Lift
3 Years Warranty
TECHNICAL DATA:
XV 600: 2x 300 W / 100 V
Class: AB
Frequency Response: 20 Hz - 20 kHz (0 / -0.3 dB)
THD: < 0.07%
Signal-to-Noise Ratio: < 101 dB
Channel Seperation: > 70 dB
Input Sensitivity: +6 dBu
Input Clipping: 22 dBu
Input Impedance: 20 kOhm
Cooling: 2 to 3 fans (temp. reg. variable speed)
Weight: 19 kg
Dimensions: 2 RU / 483 x 88 x 382 mm (19" x 3.5" x 15“)
|
Ενισχυτής 6 μικροφώνων, 120W/100V, τροφοδοσία phantom, 5 ζώνες, EQ 5 περιοχών, 2 mic priority, δυνατότητα τοποθέτησης των modules pam-d (deck), pam-tuner, pam-cd, τόνος chime. Κατάλληλο για εκκλησίες και ξενοδοχεία.
|
|
| |
Rated Output Power
|
PAM-120A(THD 1%) : 120W (RMS)
PAM-340A(THD 3%) : 340W (RMS)
PAM-480A(THD 3%) : 480W (RMS)
| |
Frequency Response
| |
Amp In
|
80Hz~20kHz
| |
Link In
|
80Hz~15kHz
| |
CH1~CH6
|
120Hz~8kHz
| |
Remote In
|
120Hz~8kHz(PAM-340A, PAM-480A)
| |
T.H.D.(at 1kHz Rated Output)
|
Less than 1%(PAM-120A)
| |
T.H.D.(at 1kHz Half Power Output)
|
Less than 0.5%(PAM-340A, PAM-480A)
| |
S/N
| |
Amp In
|
Better than 90dB(PAM-120A)
Better than 88dB(PAM-340A/480A)
| |
Link In
|
Better than 65dB
| |
CH1~CH6
|
Better than 50dB
| |
Remote In
|
Better than 50dB(PAM-340A/480A)
| |
Input Sensitivity/Impedance
| |
CH1~CH6
| |
TRIM VR -60dB Position
|
1mV/10kΩ
| |
TRIM VR -16dB Position
|
158mV/10kΩ
| |
Link In
|
100mV/10kΩ
| |
Amp In
|
1V/47kΩ(PAM-120A)
1V/20kΩ(PAM-340A/480A)
| |
Remote In
|
1V/10KΩ(PAM-340A/480A)
| |
Speaker Output/Impedance
|
PAM-120A : 120W/4Ω, 70V/42Ω, 100V/83Ω
PAM-340A : 340W, 100V/29.4Ω
PAM-480A : 480W, 100V/20.8Ω
| |
Preamp Output/Impedance
|
1V/600Ω
| |
Tone Control (100Hz, 10kHz)
|
±12dB
| |
CH1~CH6 EQ Control (100Hz, 1kHz, 10kHz)
|
±12dB
| |
|
| |
|
| |
Power Source
|
100–120VAC or 220V–240VAC; 50/60Hz, 24V DC(only PAM-120A)
| |
|
(Supplied AC mains transformer depends on country requirements)
| |
Power Consumption
|
PAM-120A : 135W(1/8 POWER), 200W(1/3 POWER), 300W(FULL POWER)
PAM-340A : 260W(1/8 POWER), 400W(1/3 POWER), 620W(FULL POWER)
PAM-480A : 360W(1/8 POWER), 550W(1/3 POWER), 880W(FULL POWER)
| |
Weight
|
PAM-120A : 13kg/28.7lb
PAM-340A : 13.5kg/29.7lb
PAM-480A : 15.5kg/34.2lb
| |
Dimensions
|
420(W) x 132(H) x 360(D)mm/16.5(W) x 5.2(H) x 14.2(D)in
| |
Operation Temperature
|
14F~104F (-10°C~+40°C)
|
|
Ενισχυτής ανακοινώσεων 250W. 24 ζωνών ψηφιακός, 24 έξοδοι επιλεγμένες με διακόπτη με ενσωματωμένο δέκτη FM, 1 CDP. 22 kg.
|
POWER AMP
| |
Rated Output
|
120W + 120W
| |
Input Sensitivity
|
-10dBV / 10kΩ
| |
S/N
|
Better than 75dB
| |
Frequency Response
|
100Hz-18kHz
| |
MIC/LINE 1~5CH
| |
MIC Input Sensitivity
|
-55dBV / 10kΩ
| |
MIC S/N
|
Better than 55dB
| |
MIC Frequency Response
|
120Hz-10kHz
| |
MIC T.H.D
|
Less than 0.5%
| |
LINE Input Sensitivity
|
-10dBV / 10kΩ
| |
LINE S/N
|
Better than 65dB
| |
LINE T.H.D
|
Less than 0.3%
| |
CD
| |
S/N
|
Better than 80dB
| |
Frequency Response
|
100Hz-20kHz
| |
TUNER
| |
S/N
|
Better than 60dB
| |
Frequency Response
|
120Hz-12kHz
| |
Power Consumption
|
170W (1/8 Power)
| |
Weight
|
16kg/35.3lb
| |
Dimension
|
482(W)x177(H)x373(D)mm/19(W)x7(H)x15(D)in
|
|
XB Series - Intelligent Power
Power Without Compromises.
The XV is designed for paging, music and alarm signals. Versatile, dynamic and
extremely rugged according to IEC286-3. For the highest requirements in safety
and quality.
Sequential power on, alive contacts and incorporated ground fault detection -
the XV is the solution under all conditions. Without the need for additional equipment.
For uninterrupted and troublefree operation.
Needless to say that the Bittner High-End toroidal output transformers in the XV
series are some of the best available.
High Tech SMT Design
Protection Circuits: DC, LF, HF, Thermal, Short Circuit, Current Limiter, 3 ms Muting Delay
PHOENIX
High-End Toroidal Output 100V Transformers
Ground Fault Detection
LED Indicators for POWER, SIGNAL, CLIP, PROTECT, GNDFAULT
Temperature controlled, variable speed low noise fans
Volume Controls at the back
Stereo / Bridged / Parallel Mode
Softstart
Sequential Remote Power On
Alive Contact
Ground Lift
3 Years Warranty
TECHNICAL DATA:
XV 1000: 2x500 W/100 V
Class: AB
Frequency Response: 20 Hz - 20 kHz (0 / -0.3 dB)
THD: < 0.07%
Signal-to-Noise Ratio: < 101 dB
Channel Seperation: > 70 dB
Input Sensitivity: +6 dBu
Input Clipping: 22 dBu
Input Impedance: 20 kOhm
Cooling: 2 to 3 fans (temp. reg. variable speed)
Weight: 33 kg
Dimensions: 2 RU / 483 x 88 x 382 mm (19" x 3.5" x 15“) |
Αξιολογήσεις
Δεν υπάρχει καμία αξιολόγηση ακόμη.